The mechanical properties of components manufactured by fused filament fabrication lack sufficient levels for industrial applications. The need for post‐processing is, therefore, necessary to enhance the interlayer strength and mechanical characteristics. In the present study, experimental analysis of the effects of annealing on polycarbonate acrylonitrile butadiene styrene manufactured by fused filament fabrication is explored. Annealing temperatures are selected in the range from 90 to 210°C based on differential scanning calorimetry analysis. The ultimate tensile strength improved by 20.39% from 32.39 to 38.99 MPa after the heat treatment at 180°C for 1‐h duration. Flexural strength showed a remarkable enhancement of 53.21% after annealing at 180°C for 2 h. The interlayer diffusion and bonding are boosted following heat treatment and microstructural imaging proved the same although the surface had flakes due to the high heat exposure. X‐ray diffraction testing of annealed models demonstrated a maximum crystallinity index of 32.56% when compared with nonannealed samples with 6.58%. The addition of polycarbonate to acrylonitrile butadiene styrene improves the stiffness and impact loading capacity with high heat resistance. The heat treatment process is capable of magnifying the mechanical characteristics of the end functional components, thereby opening up the scope for more engineering applications.

Electrical discharge machining (EDM) is an advanced, non-traditional machining process that is widely employed in sectors such as manufacturing, automotive, aerospace, and medicine. Near-dry EDM is a prospective technology that offers advantages over dry and wet EDM in terms of material removal rate (MRR), tool wear rate (TWR), and surface integrity. A 2D model of the axi-symmetric workpiece based on the Gaussian distribution of the heat flux is used to simulate the single spark in near-dry EDM. The MRR of near-dry EDM is determined at various glycerin flow rates in the glycerin-air combination. The simulation is then performed on the SS304 workpiece with different glycerin flow rates. The results are compared to EDM simulations using N2 and O2 as the dielectric medium. The average MRR of near-dry EDM with an 8 ml/min glycerin flow rate is determined to be 204% higher than that of N2 and 117% higher than that of O2 gas dielectric. When the volumetric ratio of glycerin in the glycerin-air combination increases, the MRR was also found to be increasing. The maximal MRR of near-dry EDM was found to be 129.30703 mm3/min with an 8 ml/min glycerin flow rate and a 0.18 volumetric ratio and a maximal MRR of 144.3407 mm3/min was found with a 15 ml/min glycerin flow rate and a 0.35 volumetric ratio.