Turbulent Richtmyer-Meshkov instability (RMI) is investigated through a series of high resolution three dimensional smulations of two initial conditions with eight independent codes. The simulations are initialised with a narrowband perturbation such that instability growth is due to non-linear coupling/backscatter from the energetic modes, thus generating the lowest expected growth rate from a pure RMI. By independently assessing the results from each algorithm, and computing ensemble averages of multiple algorithms, the results allow a quantification of key flow properties as well as the uncertainty due to differing numerical approaches. A new analytical model predicting the initial layer growth for a multimode narrowband perturbation is presented, along with two models for the linear and non-linear regime combined. Overall, the growth rate exponent is determined as θ = 0.292 ± 0.009, in good agreement with prior studies; however, the exponent is decaying slowly in time. Also, θ is shown to be relatively insensitive to the choice of mixing layer width measurement. The asymptotic integral molecular mixing measures Θ = 0.792 ± 0.014, Ξ = 0.800±0.014 and Ψ = 0.782±0.013 which are lower than some experimental measurements but within the range of prior numerical studies. The flow field is shown to be persistently anisotropic for all algorithms, at the latest time having between 49% and 66% higher kinetic energy in the shock parallel direction compared to perpendicular and does not show any return to isotropy. The plane averaged volume fraction profiles at different time instants collapse reasonably well when scaled by the integral width, implying that the layer can be described by a single length scale and thus a single θ. Quantitative data given for both ensemble averages and individual algorithms provide useful benchmark results for future research.

The process of non-uniform laser-driven DT plasma burning caused by the thermonuclear burn wave produced and propagating in plasma is investigated theoretically. The energy transfer from the burning plasma region to the remaining cold portion is assumed to be realized either by α-particles or by free electrons. A similarity solution of this problem has been obtained and, deriving from this solution, the conditions for “firing-up” non-uniform thermonuclear targets are defined.

Interactions of the laser beam of iodine laser 'PALS' with low-density foam targets and acceleration of Al foils by the pressure of heated foam matter are investigated here, both experimentally and theoretically. An x-ray streak camera was used for the evaluation of the speed of energy transfer through the porous foam material. X-ray streak records show no noticeable emission near the Al foil at the rear side of a 400 µm thick foam and, thus, Al foil is most likely accelerated without significant heating and expansion. Accelerated foil velocities, measured by three-frame optical shadowgraphy, reach up to 10 7 cm s −1 . Experimental results compare well with our two-dimensional hydrodynamics simulations and with an approximate analytical model.

No abstract

Impact-driven shock waves, thermonuclear plasma and neutron yield were investigated. The results of 2D numerical simulations and Gekko/HIPER laser experiments on the collision of a laser-accelerated disk-projectile with a massive target, both containing (CD) n -material, are discussed. A two-temperature model of the non-equilibrium plasma created by impact-driven shock waves due to the collision of a laser-accelerated planar projectile with a massive target was developed and used for analysis of the numerical and experimental results. The model defines the characteristics of shock waves and plasmas (including their lifetime) as well as neutron yields in both the colliding objects as functions of velocity, density and mass of the projectile-impactor just before collision. The neutron yield generated during the period of laser-driven acceleration of the impactor was also determined.Two effects were discovered that exert a substantial influence on the plasma parameters and neutron yield. The first of them relates to the formation of the pre-impact state of the impactor. It decreases the projectile density due to thermal expansion of its matter through a free boundary during the period of laser-driven acceleration. The other relates to the formation of impact-produced plasma. Predominant heating of the ion component of plasma leads to the existence of a non-equilibrium two-temperature plasma during the period of electron-ion relaxation.