Owing to the rapid growth of very large-scale integration technology at nanometer scales, cobalt and ruthenium interconnects are being used to solve the high-resistivity copper problem. However, with such interconnects, carbon contamination can occur during chemical vapor deposition and atomic layer deposition. Bipolar (BP) high-power impulse magnetron sputtering (HiPIMS) with a high ionization rate is an excellent vacuum process for depositing low-resistivity thin films. In this study, low-resistivity cobalt, ruthenium, and copper thin films were deposited using BP-HiPIMS, HiPIMS, and direct-current magnetron sputtering (MS). The resistivities of the cobalt, ruthenium, and copper thin films (<10 nm) deposited via BP-HiPIMS were 91.5, 75, and 35%, respectively, lower than the resistivities of the same film materials deposited using direct-current MS. To solve the low pass-through flux of cobalt, the target temperature was raised to the Curie temperature (approximately 1100 °C) using a thermal insulation backplate (Ti-6Al-4V), resulting in a resistivity reduction of about 73%. The study provides a novel method for the vacuum deposition of cobalt and ruthenium thin films.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.