No abstract

No abstract

No abstract

Drug loading is an important parameter known to impact the release rate of a poorly soluble drug from an amorphous solid dispersion (ASD). Recent studies have shown that small increases in drug loading can dramatically reduce the drug release rate from ASDs prepared with poly(vinylpyrrolidone-co-vinyl acetate) (PVPVA). However, the link between drug physicochemical properties and the drug loading where the release is abruptly compromised is not well understood. This study probes the role of different factors on the relative dissolution rates of drug and polymer from PVPVA-based ASDs as a function of drug loading: (1) the impact of drug-polymer hydrogen bonding interactions on the initial dissolution rate of ASDs, investigated using two structural analogues, indomethacin (IND) and indomethacin methyl ester (INDester), (2) the influence of surface drug crystallization, observed for INDester ASDs, and (3) by changing temperature, the impact of the "wet" glass transition temperature (T g ). Scanning electron microscopy (SEM), with or without energy dispersive X-ray (EDX) analysis, Fourier transform infrared spectroscopy (FTIR), and powder X-ray diffraction (PXRD) were utilized to study the solid-state phase behavior and/or drug enrichment on the partially dissolved ASD tablet surfaces. Nanoparticle tracking analysis (NTA) was utilized to study the solution-state phase behavior. It was found that, contrary to expectations, ASDs with drug-polymer hydrogen bonding exhibited poorer initial release at moderate drug loadings (15−25%) as compared to the non-hydrogen bonding analogue ASDs. Surface crystallization led to the deterioration of dissolution performance. Lastly, T g relative to experimental temperatures also appeared to play a role in the observed dissolution behavior as a function of drug loading. These findings shed light on potential mechanisms governing ASD dissolution performance and will aid in the development of optimized ASD formulations with enhanced dissolution performance.

Amorphous solid dispersions (ASDs) are of great interest as enabling formulations because of their ability to increase the bioavailability of poorly soluble drugs. However, the dissolution of these formulations under nonsink dissolution conditions results in highly supersaturated drug solutions that can undergo different types of phase transitions. The purpose of this study was to characterize the phase behavior of solutions resulting from the dissolution of model ASDs as well as the degree of supersaturation attained. Danazol was chosen as a poorly water-soluble model drug, and three polymers were used to form the dispersions: polyvinylpyrrolidone (PVP), hydroxypropylmethyl cellulose (HPMC), and hydroxypropylmethyl cellulose acetate succinate (HPMCAS). Dissolution studies were carried out under nonsink conditions, and solution phase behavior was characterized using several orthogonal techniques. It was found that liquid-liquid phase separation (LLPS) occurred following dissolution and prior to crystallization for most of the dispersions. Using flux measurements, it was further observed that the maximum attainable supersaturation following dissolution was equivalent to the amorphous solubility. The dissolution of the ASDs led to sustained supersaturation, the duration of which varied depending on the drug loading and the type of polymer used in the formulation. The overall supersaturation profile observed thus depended on a complex interplay between dissolution rate, polymer type, drug loading, and the kinetics of crystallization.