Abstract-We investigated a dielectric resonator ceramic microstrip patch antenna. The antenna was formed using barium strontium titanate (BST), which had a dielectric constant of 15. A new approach, i.e., the use of a high temperature dielectric probe kit, was used to determine the dielectric constant of BST. A computer simulation technology (CST) microwave studio was used to simulate the BST array antennas, taking into consideration the dielectric constant. We also measured the gain of the antennas loaded with two-, four-, and six-element arrays of the BST antenna and found that the gain of a six-element BST array antenna was enhanced by a gain of about 1.6 dB over the four-element BST array antenna at 2.3 GHz. The impedance bandwidths of these BST array antennas for voltage standing wave ratio (VSWR) < 2 were in the application ranges,

The microwave industry has shown increasing interest in electronic ceramic material (ECM) due to its advantages, such as light weight, low cost, low loss, and high dielectric strength. In this paper, simple antennas covered by superstrate layers for 2.30 GHz to 2.50 GHz are proposed. The antennas are compact and have the capability of producing high performance in terms of gain, directivity, and radiation efficiency. Bismuth titanate with high dielectric constant of 21, was utilized as the ECM, while the superstrate layers chosen included a split ring resonator and dielectric material. The superstrate layers were designed for some improvement in the performance of directivity, gain, and return loss. The proposed antennas were simulated and fabricated. The results obtained were small antennas that possess high gain and high directivity with 360°, omni-directional signal transmission that resonant types of conventional dipole antenna cannot achieve. The gain of the antenna with the superstrate layer was enhanced by about 1 dBi over the antenna without a superstrate layer at 2.40 GHz.

No abstract

No abstract

The purpose of this paper is to determine the best practice of green supply chain management in composite technology manufacturing industries through quality function deployment or so-called as QFD approach. Since introduced, the QFD approach had been deployed in varieties of applications but lack of discussion on the know-what issues in developing the green supply chain model. Four case studies were been performed to have a consensus decision on the green supply chain practices using pre-determined parameters in QFD model. The findings show that top management commitment is the most essential element to ensure the success of green supply chain practices. Besides, workers' commitment and customer focus are significance to the establishment of 24 items or measures for green supply chain practices.

KNN thin films with diverse yttrium concentration (mol % = 0, 0.1, 0.3, 0.5, 0.7 and 0.9) were fabricated using sol-gel spin coating technique. Doped KNN revealed that Y 3+ was successfully doped into the ABO 3 perovskite lattice without changing the phase formation of KNN. The thickness of the deposited layer of KNN produced with increasing dopant concentration was determined to be 200 nm with dense and well-defined grains. Afterwards, the vibrational bonding and conductivity of KNN films with diverse yttrium concentration were identified according to the charge compensation mechanism. At high dopant concentration of > 0.5 mol %, O-Nb-O bonding was asymmetric and became distorted due to B-site occupancy by yttrium dopant. Further investigation revealed that charge compensation mechanism was shifted by increasing doping concentration. As a result, yttrium-doped KNN became semi-conductive at low yttrium concentration. Meanwhile, at high concentration, yttrium-doped KNN became an insulator and underwent ionic compensation.

No abstract

No abstract