The process of divertor detachment, whereby heat and particle fluxes to divertor surfaces are strongly diminished, is required to reduce heat loading and erosion in a magnetic fusion reactor to acceptable levels. In this paper the physics leading to the decrease of the total divertor ion current (I t ), or 'rollover', is experimentally explored on the TCV tokamak through characterization of the location, magnitude and role of the various divertor ion sinks and sources including a complete analysis of particle and power balance. These first measurements of the profiles of divertor ionisation and hydrogenic radiation along the divertor leg are enabled through novel spectroscopic techniques.Over a range in TCV plasma conditions (plasma current and electron density, with/without impurityseeding) the I t roll-over is ascribed to a drop in the divertor ion source; recombination remains small or negligible farther into the detachment process. The ion source reduction is driven by both a reduction in the power available for ionization, P recl , and concurrent increase in the energy required per ionisation, E ion : This effect of power available on the ionization source is often described as 'power starvation' (or 'power limitation'). The detachment threshold is found experimentally (in agreement with analytic model predictions) to be ~ P recl /I t E ion~ 2, corresponding to a target electron temperature, T t~ E ion /γ where γ is the sheath transmission coefficient. The target pressure reduction, required to reduce the target ion current, is driven both by volumetric momentum loss as well as upstream pressure loss.The measured evolution through detachment of the divertor profile of various ion sources/sinks as well as power losses are quantitatively reproduced through full 2D SOLPS modelling through the detachment process as the upstream density is varied.2. We show the equivalence of approaching detachment from momentum balance (e.g. target pressure losses) and power limitation arguments from combining the Bohm sheath criteria with power/particle balance (section 4.2 -equation 21). This is supported with experimental measurements which show that both power loss (in fact power-limitation of the ion source) and volumetric momentum loss occur after the detachment onset. In addition, upstream pressure loss occurs during detachment, which is shown to be consistent with analytic modelling. 4 3. The ∝ trend observed experimentally in TCV (where n eu is the upstream electron density) during attached conditions contrasts the often assumed ∝ 2 trend on which the Degree of Detachment (DoD) is based [3,7,24,[36][37][38]. The TCV observations are however supported with analytic predictions, when accounting for changes in the upstream temperature and divertor radiation. This illustrates deviations in upstream and divertor conditions need to be accounted for before the DoD can be used.Our measurements show that as further power limitation occurs (P recl gets closer to P ion ), volumetric momentum loss (estimated from inferred charge ex...

The aim of this work is to provide an understanding of detachment at TCV with emphasis on analysis of the Balmer line emission. A new Divertor Spectroscopy System has been developed for this purpose. Further development of Balmer line analysis techniques has allowed detailed information to be extracted from the three-body recombination contribution to the n=7 Balmer line intensity. During density ramps, the plasma at the target detaches as inferred from a drop in ion current to the target. At the same time the Balmer $6\rightarrow2$ and $7\rightarrow2$ line emission near the target is dominated by recombination. As the core density increases further, the density and recombination rate are rising all along the outer leg to the x-point while remaining highest at the target. Even at the highest core densities accessed (Greenwald fraction 0.7) the peaks in recombination and density may have moved not more than a few cm poloidally away from the target which is different to other, higher density tokamaks, where both the peak in recombination and density continue to move towards the x-point as the core density is increased. The inferred magnitude of recombination is small compared to the target ion current at the time detachment (particle flux drop) starts at the target. However, recombination may be having more localized effects (to a flux tube) which we cannot discern at this time. Later, at the highest densities achieved, the total recombination does reach levels similar to the particle flux.Comment: Article accepted for publication in Journal of Nuclear Materials and Energ

Divertor detachment is explored on the TCV tokamak in alternative magnetic geometries. Starting from typical TCV single-null shapes, the poloidal flux expansion at the outer strikepoint is varied by a factor of 10 to investigate the X-divertor characteristics, and the total flux expansion is varied by 70% to study the properties of the super-X divertor. The effect of an additional X-point near the target is investigated in X-point target divertors. Detachment of the outer target is studied in these plasmas during Ohmic density ramps and with the ion ∇B drift away from the primary X-point. The detachment threshold, depth of detachment, and the stability of the radiation location are investigated using target measurements from the wall-embedded Langmuir probes and two-dimensional CIII line emissivity profiles across the divertor region, obtained from inverted, toroidally-integrated camera data. It is found that increasing poloidal flux expansion results in a deeper detachment for a given line-averaged density and a reduction in the radiation location sensitivity to core density, while no large effect on the detachment threshold is observed. The total flux expansion, contrary to expectations, does not show a significant influence on any detachment characteristics in these experiments. In X-point target geometries, no evidence is found for a reduced detachment threshold despite a Nuclear Fusion Results from recent detachment experiments in alternative divertor configurations on TCVInternational Atomic Energy Agency a See the author list of 'Overview of progress in European Medium Sized Tokamaks towards an integrated plasma-edge/wall solution' by H. Meyer et al, to be published in the Nuclear Fusion

The role of the pedestal position on the pedestal performance has been investigated in AUG, JET-ILW and TCV. When the pedestal is peeling-ballooning (PB) limited, the three machines show a similar behaviour. The outward shift of the pedestal density leads to the outward shift of the pedestal pressure which, in turns, reduces the PB stability, degrades the pedestal confinement and reduces the pedestal width. Once the experimental density position is considered, the EPED model is able to correctly predict the pedestal height. An estimate of the impact of the density position on a ITER baseline scenario shows that the maximum reduction in the pedestal height is 10% while the reduction in the fusion power is between 10% and 40% depending on the assumptions for the core transport model used.When the pedestal is not PB limited, a different behaviour is observed. The outward shift of the density is still empirically correlated with the pedestal degradation but no change in the pressure position is observed and the PB model is not able to correctly predict the pedestal height. On the other hand, the outward shift of the density leads to a significant increase of η e (where η e is the ratio of density to temperature scale lengths, η e = L ne /L Te ) which leads to the increase of the growth rate of microinstabilities (mainly ETG and ITG) by 50%. This suggests that, when the pedestal is not PB limited, the increase in the turbulent transport due to the outward shift of the density might play an important role in the decrease of the pedestal performance.

A large database of reciprocating probe data from the edge plasma of TCV (Tokamak à Configuration Variable) is used to test the radial velocity scalings of filaments from analytical theory [J. R. Myra, D. A. Russell, and D. A. D'Ippolito, Phys. Plasmas 13, 112502 (2006)]. The measured velocities are mainly scattered between zero and a maximum velocity which varies as a function of size and collisionality in agreement with the analytical scalings. The scatter is consistent with mechanisms that tend to slow the velocity of individual filaments. While the radial velocities were mainly clustered between 0.5 and 2 km/s, a minority reached outward velocities as high as 5km/s or inward velocities as high as-4km/s. Inward moving filaments are only observed in regions of high poloidal velocity shear in discharges with Bx∇B away from the X-point, a new finding. The filaments have diameters clustered between 3 and 11mm, and normalized sizes â clustered between 0.3 and 1.1, such that most filaments populate the resistive-ballooning regime, therefore, most filaments in TCV have radial velocities with little or no dependence on collisionality. Improvements in crosscorrelation techniques and conditional averaging techniques are discussed which reduce the sizes determined for the largest filaments, including those larger than the scrape-off layer (SOL).