No abstract

A large amount of (all-E)-lycopene was successfully purified from tomato paste using an improved method that included a procedure to wash crystalline powder with acetone. The total yield of the pure (all-E) form was at least 30%. The melting point of (all-E)-lycopene was determined to be 176.35 °C by differential scanning calorimetry (DSC) measurements. Bathochromic shifts were observed in the absorption maxima of all solvents tested (at most a 36 nm shift for λ2 in carbon disulfide, as was observed in hexane) and were accompanied by absorbance decreases, namely, a hypochromic effect, showing a higher correlation between the position and the intensity of the main absorption bands. This bathochromic shift was dependent upon the polarizability of the solvent rather than its polarity. The structure of (all-E)-lycopene in CDCl3 and C6D6 was identified on the basis of one- and two-dimensional nuclear magnetic resonance (NMR) spectra, including (1)H and (13)C NMR, homonuclear correlation spectroscopy ((1)H-(1)H COSY), heteronuclear multiple-quantum coherence (HMQC), and heteronuclear multiple-bond connectivity (HMBC). The rate constants of the decrease in (all-E)-lycopene with hexane and benzene were calculated to be 3.19 × 10(-5) and 3.55 × 10(-5) s(-1), respectively. The equilibrium constants between (all-E) and (13Z) isomers were estimated to be 0.29 in hexane and 0.31 in benzene, respectively, from the point at which the amount of (13Z)-lycopene reached its maximum.

2-(3,5,6-Trifluoro-2-hydroxy-4-methoxyphenyl)benzoxazole (3) and benzothiazole analogue (4) are prepared by the two-step procedures from the corresponding 2-(pentafluorophenyl)benzazoles. Benzoxazole 3 is applicable to a fluorescent probe sensing magnesium cation, and 4 is suitable for sensing zinc cation. Both fluorophores 3 and 4 are sensitive to the pH change at pH 7-8, resulting in large fluorescence enhancement under basic conditions. Their high sensitivity to pH and selectivity in metal cations are ascribed to the high acidity of the fluorophenol moiety.

Thephotochemical reaction of [3(3)](1,3,5)cyclophane 2, which is a photoprecursor for the formation of propella[3(3)]prismane 18, was studied using a sterilizing lamp (254 nm). Upon photolysis in dry and wet CH2Cl2 or MeOH in the presence of 2 mol/L aqueous HCl solution, the cyclophane 2 afforded novel cage compounds comprised of new skeletons, tetracyclo[6.3.1.0.(2,7)0(4,11)]dodeca-5,9-diene 43, hexacyclo[6.4.0.0.(2,6)0.(4,11)0.(5,10)0(9,12)]dodecane 44, and pentacyclo[6.4.0.0.(2,6)0.(4,11)0(5,10)]dodecane 45. All of these products were confirmed by the X-ray structural analyses. A possible mechanism for the formation of these photoproducts via the hexaprismane derivative 18 is proposed. The photophysical properties in the excited state of the [3n]cyclophanes ([3n]CP, n = 2-6) were investigated by measuring the emission spectra and determining the quantum yields and lifetimes of the fluorescence. All [3n]CPs show excimeric fluorescence without a monomeric one. The lifetime of the excimer fluorescence becomes gradually longer with the increasing number of the trimethylene bridges. The [3n]CPs also shows excimeric phosphorescence spectra without vibrational structures for n = 2, 4, and 5, while phosphorescence is absent for n = 3 and 6. With an increase in symmetry of the benzene skeleton in the [3(3)]- and [3(6)]CPs, the probability of the radiation (phosphorescence) process from the lowest triplet state may drastically decrease.