Mechanochromic luminescence has been observed in many boron coordinated β-diketonate (BF2bdk) complexes. Recently, it was shown that the metal-free methoxy-substituted dinaphthoylmethane β-diketone (dnmOMe) also displayed aggregation induced emission (AIE), solvatochromism, and high contrast mechanochromic luminescence (ML) that recovered rapidly at room temperature. In order to understand how substituents and boron coordination affect solution and solid-state optical properties, a series of methoxy- and bromo-substituted derivatives (dnm, dnmOMe, dnmBr, and dnmBrOMe) and their corresponding boron complexes (BF2dnm, BF2dnmOMe, BF2dnmBr, and BF2dnmBrOMe) were synthesized and their AIE, ML, and room temperature recovery properties were compared. All boron complexes exhibited red-shifted absorption and emission, in addition to larger solution and solid-state quantum yields than β-diketones. While AIE studies show increased emission for dnmOMe and dnmBrOMe, the emission of corresponding boron complexes diminished upon aggregation. However, boron complexes were still strongly emissive in the solid state. ML properties were investigated using spin-cast films. Smearing resulted in the appearance of blue-green emission in ligands and a color change from green to yellow-orange in boron complexes. Bromide substituted derivatives showed increased room temperature recovery times compared to other dnm ligands, and boron complexes show only partial recovery over several days.

Reversible mechanochromic luminescence (ML) is known for difluoroboron β-diketonates (BF2bdks). Here, we report ML for the methoxy-substituted dinaphthoylmethane (dnmOMe) ligand even without coordination to boron. In addition, dnmOMe shows solvatochromism and aggregation-induced emission (AIE). Diketone thin films showed high contrast emission when smeared, and rapid recovery of the pre-smeared state at room temperature.

Mechanochromic luminescent (ML) materials, which show a change in emission due to an applied mechanical stimulus, are useful components in a variety of applications, including organic light-emitting diodes, force sensors, optical memory storage, and next-generation lighting materials. While there are many different ML active derivatives, few show room temperature self-erasing. Thin films of the methoxy substituted β-diketone, gbmOMe, initially exhibited blue (428 nm) emission; however, green (478 nm) emission was observed after smearing. The mechanically generated smeared state recovered so rapidly that characterization of its emission was difficult at room temperature using traditional luminescence techniques. Thus, a new complementary metal oxide semiconductor camera imaging method was developed and used to calculate the decay time of the mechanically generated smeared state (i.e., smeared-state decay; τ) for gbmOMe thin films. Additionally, this method was used to evaluate substrate and film thickness effects on ML recovery for glass and weighing paper films. The recovery behavior of gbmOMe was largely substrate-independent for the indicated matrixes; however, thickness effects were observed. Thus, film thickness may be the main factor in determining ML recovery behavior and must be accounted for when comparing the recovery dynamics of different ML materials. Moreover, when heated above the melting point (T = 119 °C), bulk gbmOMe powders assumed a metastable state that eventually crystallized after a few minutes at room temperature. However, melted thin films remained in an amorphous state indefinitely despite annealing at different temperatures (50-110 °C). The amorphous phase was identified as a supercooled liquid via changing the rate of cooling in differential scanning calorimetry thermograms.

A simple, straightforward, and rapid method for the detection of beta-2 transferrin in otorrhea and rhinorrhea that can be used in a routine clinical laboratory is described. The beta-2 transferrin was detected by agarose gel electrophoresis of the fluid on Beckman Paragon equipment, followed by pressure transfer to a nitrocellulose membrane and then incubation with enzyme-labeled antitransferrin antibody and substrate. The procedure was fast (3.5 h) and sensitive (detected as little as 1 microgram/ml) and required only 3 microliters of fluid. Beta-2 transferrin was detected in cerebrospinal fluid diluted up to eightfold. No special training or expertise was needed, and all equipment and procedures used are commonly available in a routine clinical laboratory.