In this paper, a broadband metamaterial (MM) absorber is presented for X-band applications. A novel eight-resistive-arm (ERA) cell is proposed as an MM unit cell to achieve both broadband absorption and wide incidence angles. The proposed ERA cell is designed using equivalent circuit model and full-wave analysis in order to achieve an absorption ratio higher than 90% in the range of 8.2–13.4 GHz. The experimental results indicate that the absorptivity was greater than 90% in the range of 8–13 GHz for all polarization angles under normal incidence. Under oblique incidence, the measured absorptivity was greater than 90% in the range of 8.2–12.2 GHz up to 60° and in the range of 9.2–12 GHz up to 65° in the transverse electric (TE) mode. In the transverse magnetic (TM) mode, the measured absorptivity was higher than 90% in the range of 9.5–12.4 GHz when the incidence angle was varied from 0° to 60° and remaining a 90% absorption bandwidth in the range of 10–12 GHz up to 65°. Compared to other broadband MM absorbers, the proposed MM absorber exhibited the widest incidence angles in both TE and TM modes.

In this paper, we propose an angle- and polarization-insensitive broadband metamaterial absorber with a resistive fan-shaped resonator. First, the symmetric fan-shaped resonator is designed, and four lumped resistors are loaded in the gap between each fan-shaped circular sector on the top layer to increase the bandwidth. Based on the circuit parameters, the periodic structure of the fan-shaped resonator is designed using full-wave analysis. The proposed absorber is fabricated using a printed circuit board process in a single layer. The experimental results indicate that an absorptivity value greater than 96% was achieved in the frequency range of 7–12.8 GHz for all polarization angles at normal incidence. Under oblique incidence, the measured absorptivity was greater than 90% in the range of 7–12.1 GHz when the incident angle varied from 0° to 45° in the transverse electric mode. In the transverse magnetic mode, the measured absorptivity was greater than 90% between 7.1 and 9.3 GHz when the incident angle varied from 0° to 45°.

In this paper, a wide incidence angle-insensitive metamaterial absorber is proposed using eight-circular-sector (ECS). Under normal incidence, the proposed absorber shows high absorptivity at different polarizations due to its symmetric geometry. Under oblique incidence, zero-reflection conditions for transverse electric (TE) and transverse magnetic (TM) polarization are different. Nevertheless, the proposed absorber shows high absorptivity under oblique incidence of both TE and TM polarization due to ECS. The performance of the proposed absorber was demonstrated with full-wave simulation and measurements. The simulated absorptivity at the specular angles exceed 90% and the frequency variation is less than 0.7% at approximately 9.26 GHz up to a 70° incidence angle in both TM and TE polarization. We built the proposed absorber on a printed-circuit board with 20 × 20 unit cells, and we demonstrated its performance experimentally in free space. The measured absorptivity at 9.26 GHz for the specular angles is close to 98% for all polarization angles under normal incidence. As the incidence angle is varied from 0° to 70°, the measured absorptivity at 9.26 GHz for the specular angles remain above 92% in both TE and TM polarization.

This study focused on the radome and proposed an absorber with a meta-dome structure for ultra-wideband radar absorption using an FR-4 dielectric material on the metasurface absorber for protection. In addition to protecting the absorber, the metasurface absorber exhibited ultra-wideband frequency absorptivity from radar signals, with an absorptivity band from 4.6–12 GHz, including the C and X frequency bands of radar signals. A wide incidence angle should also be considered in addition to the absorption frequency band. Experimental results were obtained for all polarization angles at normal incidence for 5–14 GHz. Sensitivity to incident angle from 0° to 40° in the transverse electric mode and 0° to 60° in the transverse magnetic mode were observed. The proposed concept was demonstrated using full-wave simulation and experimental measurements.

In this paper, a bandwidth-enhanced and wide-angle-of-incidence metamaterial absorber is proposed using a hybrid unit cell. Owing to symmetric unit cells, high absorptivity is maintained for all polarization angles. A circular-sector unit cell enables high absorptivity under the oblique incidence of both transverse electric (TE) and transverse magnetic (TM) modes. To enhance the bandwidth, we introduced a hybrid unit cell comprising four circular sectors. Two sectors resonate at 10.38 GHz, and two resonate at 10.55 GHz. Since the two absorption frequencies are near each other, the bandwidth increases. The proposed idea is demonstrated with both full-wave simulations and measurements. The simulated absorptivity exceeds 91% around 10.45 GHz at an angle of incidence up to 70° in both TM and TE polarizations. The measured absorptivity at 10.45 GHz is close to 96.5% for all polarization angles under normal incidence. As the angle of incidence changes from 0° to 70°, the measured absorptivity at 10.45 GHz remains above 90% in the TE mode and higher than 94% in the TM mode. Under an oblique incidence, the measured 90% absorption bandwidth is 1.95% from 10.1–10.2 GHz and 10.4–10.5 GHz up to 70° at the TE mode, and 3.39% from 10.15–10.5 GHz up to 70° at the TM mode.