No abstract

The implementation of optical sensor technology to monitor the milk quality on dairy farms and milk processing plants would support the early detection of altering production processes. Basic visible and near-infrared spectroscopy is already widely used to measure the composition of agricultural and food products. However, to obtain maximal performance, the design of such optical sensors should be optimized with regard to the optical properties of the samples to be measured. Therefore, the aim of this study was to determine the visible and near-infrared bulk absorption coefficient, bulk scattering coefficient, and scattering anisotropy spectra for a diverse set of raw milk samples originating from individual cow milkings, representing the milk variability present on dairy farms. Accordingly, this database of bulk optical properties can be used in future simulation studies to efficiently optimize and validate the design of an optical milk quality sensor. In a next step of the current study, the relation between the obtained bulk optical properties and milk quality properties was analyzed in detail. The bulk absorption coefficient spectra were found to mainly contain information on the water, fat, and casein content, whereas the bulk scattering coefficient spectra were found to be primarily influenced by the quantity and the size of the fat globules. Moreover, a strong positive correlation (r ≥ 0.975) was found between the fat content in raw milk and the measured bulk scattering coefficients in the 1,300 to 1,400 nm wavelength range. Relative to the bulk scattering coefficient, the variability on the scattering anisotropy factor was found to be limited. This is because the milk scattering anisotropy is nearly independent of the fat globule and casein micelle quantity, while it is mainly determined by the size of the fat globules. As this study shows high correlations between the sample's bulk optical properties and the milk composition and fat globule size, a sensor that allows for robust separation between the absorption and scattering properties would enable accurate prediction of the raw milk quality parameters.

Changes in the drinking behaviour of pigs may indicate health, welfare or productivity problems. Automated monitoring and analysis of drinking behaviour could allow problems to be detected, thus improving farm productivity. A high frequency radio frequency identification (HF RFID) system was designed to register the drinking behaviour of individual pigs. HF RFID antennas were placed around four nipple drinkers and connected to a reader via a multiplexer. A total of 55 growing-finishing pigs were fitted with radio frequency identification (RFID) ear tags, one in each ear. RFID-based drinking visits were created from the RFID registrations using a bout criterion and a minimum and maximum duration criterion. The HF RFID system was successfully validated by comparing RFID-based visits with visual observations and flow meter measurements based on visit overlap. Sensitivity was at least 92%, specificity 93%, precision 90% and accuracy 93%. RFID-based drinking duration had a high correlation with observed drinking duration ( R 2 = 0.88) and water usage ( R 2 = 0.71). The number of registrations after applying the visit criteria had an even higher correlation with the same two variables ( R 2 = 0.90 and 0.75, respectively). There was also a correlation between number of RFID visits and number of observed visits ( R 2 = 0.84). The system provides good quality information about the drinking behaviour of individual pigs. As health or other problems affect the pigs' drinking behaviour, analysis of the RFID data could allow problems to be detected and signalled to the farmer. This information can help to improve the productivity and economics of the farm as well as the health and welfare of the pigs.

No abstract

Sensors play a crucial role in the future of dairy farming. Modern dairy farms today are equipped with many different sensors for milk yield, body weight, activity, and even milk composition. The challenge, however, is to translate signals from these sensors into relevant information for the farmer. Because the measured values for an individual cow show nonstationary behavior, the concepts of statistical process control, which are commonly used in industry, cannot be used directly. The synergistic control concept overcomes this problem by on-line (real-time) modeling of the process and application of statistical process control to the residuals between the measured and modeled values. In this study, the synergistic control concept was developed and tested for early detection of anomalies in dairy cows based on detection of shifts in milk yield. Compared with the combination of visual observation and milk conductivity measurements, the developed strategy had a sensitivity of 63% for detecting clinical mastitis. Consequently, this technique could have added value on many farms, as it extracts practical information out of inexpensive data that are already available. As it can be easily extended to other measured parameters, the technique shows potential for early detection of other nutrition and health problems.

Timely identification of a cow's reproduction status is essential to minimize fertility-related losses on dairy farms. This includes optimal estrus detection, pregnancy diagnosis, and the timely recognition of early embryonic death and ovarian problems. On-farm milk progesterone (P4) analysis can indicate all of these fertility events simultaneously. However, milk P4 measurements are subject to a large variability both in terms of measurement errors and absolute values between cycles. The objective of this paper is to present a newly developed methodology for detecting luteolysis preceding estrus and give an indication of its on-farm use. The innovative monitoring system presented is based on milk P4 using the principles of synergistic control. Instead of using filtering techniques and fixed thresholds, the present system employs an individually on-line updated model to describe the P4 profile, combined with a statistical process control chart to identify the cow's fertility status. The inputs for the latter are the residuals of the on-line updated model, corrected for the concentration-dependent variability that is typical for milk P4 measurements. To show its possible use, the system was validated on the P4 profiles of 38 dairy cows. The positive predictive value for luteolysis followed by estrus was 100%, meaning that the monitoring system picked up all estrous periods identified by the experts. Pregnancy or embryonic mortality was characterized by the absence or detection of luteolysis following an insemination, respectively. For 13 cows, no luteolysis was detected by the system within the 25 to 32 d after insemination, indicating pregnancy, which was confirmed later by rectal palpation. It was also shown that the system is able to cope with deviating P4 profiles having prolonged follicular or luteal phases, which may suggest the occurrence of cysts. Future research is recommended for optimizing sampling frequency, predicting the optimal insemination window, and establishing rules to detect problems based on deviating P4 patterns.

Analytical methods that are often used for the quantification of progesterone in bovine milk include immunoassays and chromatographic techniques. Depending on the selected method, the main disadvantages are the cost, time-to-result, labor intensity and usability as an automated at-line device. This paper reports for the first time on a robust and practical method to quantify small molecules, such as progesterone, in complex biological samples using an automated fiber optic surface plasmon resonance (FO-SPR) biosensor. A FO-SPR competitive inhibition assay was developed to determine biologically relevant concentrations of progesterone in bovine milk (1-10 ng/mL), after optimizing the immobilization of progesterone-bovine serum albumin (P4-BSA) conjugate, the specific detection with anti-progesterone antibody and the signal amplification with goat anti-mouse gold nanoparticles (GAM-Au NPs). The progesterone was detected in a bovine milk sample with minimal sample preparation, namely ½ dilution of the sample. Furthermore, the developed bioassay was benchmarked against a commercially available ELISA, showing excellent agreement (R = 0.95). Therefore, it is concluded that the automated FO-SPR platform can combine the advantages of the different existing methods for quantification of progesterone: sensitivity, accuracy, cost, time-to-result and ease-of-use.

Udder health problems are often associated with milk losses. These losses are different between quarters, as infected quarters are affected both by systemic and pathogen-specific local effects, whereas noninfected quarters are only subject to systemic effects. To gain insight in these losses and the milk yield dynamics during disease, it is essential to have a reliable reference for quarter-level milk yield in an unperturbed state, mimicking its potential yield. We developed a novel methodology to predict this quarter milk yield per milking session, using an historical data set of 504 lactations collected on a test farm by an automated milking system from DeLaval (Tumba, Sweden). Using a linear mixed model framework in which covariates associated with the linearized Wood model and the milking interval are included, we were able to describe quarter-level yield per milking session with a proportional error below 10%. Applying this model enables us to predict the milk yield of individual quarters 1 to 50 d ahead with a mean prediction error ranging between 8 and 20%, depending on the amount of historical data available to estimate the random effect covariates for the predicted lactation. The developed methodology was illustrated using 2 examples for which quarter-level milk losses are calculated during clinical mastitis. These showed that the quarter-level mixed model allows us to gain insight in quarter lactation dynamics and enables to calculate milk losses in different situations.