Field A considered in this paper is an oil field characterized by low permeability and large vertical variability of formation properties. Injection and production take place in commingled multi-layer zones of Field A. Wells are hydraulically fractured across the entire stack of the producing layers. In the injection wells, the bottomhole pressure is higher than the formation fracturing pressures causing continuing growth of fracture length. This paper discusses 60 multi-rate injection tests to determine the injection profiles in Field A. The tests consisted of continuous measurements of the bottomhole pressures for several constant injection rates. Measurements were made for three different injection periods with pressures below and above the formation fracturing pressure. Each injection period lasted until steady-state conditions were established. Layer injection rates were determined from stabilized injection profiles obtained by spinner surveys before the tests. Layer properties were determined by matching the constant injecting rates and layer pressures for multiple injection periods. Test results demonstrated that well performances in Field A could not be described by known solutions for a constant fracture length. The non-linear relationship between the steady-state pressure and injection rate indicated that continuous change in fracture geometry had to be taken into account. These tests were useful to determine individual layer injectivities, current formation pressures and fracture opening pressures of each layer. Based on the results, it is concluded that multi-layer, multi-rate injection tests are useful to monitor layer pressure distributions and effectively produce multi-layer fields. The Simultaneous Separate Injection (SSI) technology used in these tests provides the ability to control layer injection rates and maintain uniform production from multiple layers. The SSI technology also allows injecting controlled volumes simultaneously into several layers through one injection well. Comparison of the tests using the SSI technology and adjusted valves demonstrates redistribution of injection rates from a higher- permeability layer to a lower-permeability layer.
Гидродинамические исследования скважин в многопластовых нагнетательных скважинах в условиях превышения давления закачки над давлением раскрытия трещин Альфред Давлетбаев, OOO «РН-УфаНИПИнефть», Виталий Байков, OOO «РН-УфаНИПИнефть», Эрдал Озкан, SPE, Colorado School of Mines, Тимур Гарипов, OOO «РН-УфаНИПИнефть», Тимур Усманов, OOO «РН-УфаНИПИнефть», Руслан Асмандияров, ООО «РН-Юганскнефтегаз», Андрей Слабецкий, ООО «РН-Юганскнефтегаз», Эдуард Назаргалин, ООО «РН-Юганскнефтегаз» Авторское право 2010 г., Общество инженеров-нефтяников Этот доклад был приготавливан предьявления в 2010 Российской нефтьегазовой технической конференции и выставке состоится в Москве 26-28 октабря 2010.Данный доклад был выбран для проведения презентации Программным комитетом SPE по результатам экспертизы информации, содержащейся в представленном авторами резюме. Экспертиза содержания доклада Обществом инженеров-нефтяников не выполнялась, и доклад подлежит внесению исправлений и корректировок авторами. Материал в том виде, в котором он представлен, не обязательно отражает точку зрения Общества инженеров-нефтяников, его должностных лиц или участников. Доклады, представленные на конференциях SPE, подлежат экспертизе со стороны Редакционных Комитетов Общества инженеров-нефтяников. Электронное копирование, распространение или хранение любой части данного доклада в коммерческих целях без предварительного письменного согласия Общества инженеров-нефтяников запрещается. Разрешение на воспроизведение в печатном виде распространяется только на резюме длиной не более 300 слов; при этом копировать иллюстрации не разрешается. Резюме должно содержать явно выраженную ссылку на то, где и кем был представлен данный доклад. Write Librarian, SPE, P.O.Box 833836, Richardson, TX 75083-3836 U.S.A., факс 01-972-952-9435. РезюмеПласты месторождения А характеризуются низкой проводимостью и высокой расчлененностью пластов. Ведется совместная эксплуатация нескольких пластов единой сеткой скважин, на всех пластах проводится гидроразрыв пласта (ГРП). Давление закачки в нагнетательных скважинах выше давления раскрытия трещины зафиксированного при операции ГРП, имеет место самопроизвольное развитие техногенных трещин.В данной работе приведены результаты исследования многопластовых нагнетательных скважин на установившихся режимах закачки с замерами профиля приемистости по стволу (проведено более 60 исследований). Исследование проводится на нескольких режимах с различным давлением нагнетания. Как правило, регистрируется по 3 режима при давлении закачки ниже и выше давления раскрытия трещины. На установившихся режимах закачки проводится комплекс промыслово-геофизических исследований с регистрацией профиля приемистости по пластам в многопластовой скважине. Полученные данные расхода и давления закачки по каждому пласту обрабатываются методом построения индикаторной диаграммы.Проведенные эксперименты показали, что при забойном давлении выше давления раскрытия трещин течение в системе «скважина-трещина-пласт» не описывается известным решением о притоке в трещину ГРП с фиксиро...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.