The Ir precatalyst (3) contains both a Cp* and a κ2 C 2,C 2′ -1,3-diphenylimidazol-2-ylidene ligand, a C−C chelate, where one C donor is the NHC and the other is a cyclometalated N-phenyl wingtip group. The structure of 3 was confirmed by X-ray crystallography. Like our other recently described Cp*Ir catalysts, this compound is a precursor to a catalyst that can oxidize water to dioxygen. Electrochemical characterization of the new compound shows that it has a stable iridium(IV) oxidation state, [Cp*IrIV(NHC)Cl]+, in contrast with the unstable Ir(IV) state seen in our previous cyclometalated [Cp*IrIII(2-pyridyl-2′-phenyl)Cl] catalyst. The new iridium(IV) species has been characterized by EPR spectroscopy and has a rhombic symmetry, a consequence of the ligand environment. These results both support previous studies which suggest that Cp*Ir catalysts can be advanced through the relevant catalytic cycle(s) in one-electron steps and help clarify the electrochemical behavior of this class of water-oxidation catalysts.

We present the first analysis of performance of hydroxamate linkers as compared to carboxylate and phosphonate groups when anchoring ruthenium-polypyridyl dyes to TiO2 surfaces in dye-sensitized solar cells (DSSCs). The study provides fundamental insight into structure/function relationships that are critical for cell performance. Our DSSCs have been produced by using newly synthesized dye molecules and characterized by combining measurements and simulations of experimental current density-voltage (J-V) characteristic curves. We show that the choice of anchoring group has a direct effect on the overall sunlight-to-electricity conversion efficiency (η), with hydroxamate anchors showing the best performance. Solar cells based on the pyridyl-hydroxamate complex exhibit higher efficiency since they suppress electron transfer from the photoanode to the electrolyte and have superior photoinjection characteristics. These findings suggest that hydroxamate anchoring groups should be particularly valuable in DSSCs and photocatalytic applications based on molecular adsorbates covalently bound to semiconductor surfaces. In contrast, analogous acetylacetonate anchors might undergo decomposition under similar conditions suggesting limited potential in future applications.

A series of half-sandwich Ir and Rh compounds are demonstrated to be competent catalysts for the hydrogenation of carboxylic acids under relatively mild conditions. Of the structurally diverse group of catalysts tested for activity, a Cp*Ir complex supported by an electron-releasing 2,2'-bipyridine ligand was the most active. Higher activity was achieved with employment of Brønsted or Lewis acid promoters. Mechanistic studies suggest a possible reaction pathway involving activated carboxylic acid substrates. The hydrogenation reaction was shown to be general to a variety of aliphatic acids.

Sodium periodate was characterized as a primary chemical oxidant for the catalytic evolution of oxygen at neutral pH using a variety of water-oxidation catalysts. The visible spectra of solutions formed from Cp*Ir(bpy)SO(4) during oxygen-evolution catalysis were measured. NMR spectroscopy suggests that the catalyst remains molecular after several turnovers with sodium periodate. Two of our [Cp*Ir(bis-NHC)][PF(6)](2) complexes, along with other literature catalysts, such as the manganese terpyridyl dimer, Hill's cobalt polyoxometallate, and Meyer's blue dimer, were also tested for activity. Sodium periodate was found to function only for water-oxidation catalysts with low overpotentials. This specificity is attributed to the relatively low oxidizing capability of sodium periodate solutions relative to solutions of other common primary oxidants. Studying oxygen-evolution catalysis by using sodium periodate as a primary oxidant may, therefore, provide preliminary evidence that a given catalyst has a low overpotential.

Solid copper(I) cyanide occurs as extended one-dimensional chains with interesting photophysical properties. To explain the observed luminescence spectroscopy of CuCN, we report a series of computational studies using short bare and potassium-capped [Cu(n)(CN)(n+1)] (-) (n = 1, 2, 3, 4, 5, and 7) chains as CuCN models. On the basis of TD-DFT calculations of these model chains, the excitation transitions in the UV spectrum are assigned as Laporte-allowed pi-pi transitions from MOs with Cu 3d(pi) and CN pi character to empty MOs with Cu 4p and CN pi* character. Transitions between the HOMO (3d(z)) and LUMO (Cu 4p and CN pi*) are symmetry forbidden and are not assigned to the bands in the excitation spectrum. The emission spectrum is assumed to arise from transitions between the lowest triplet excited state and the ground-state singlet. The lowest energy triplet for the model networks has a bent structure due to distortions to remove the degeneracies in the partially occupied MOs of the linear triplet. The S(0)-T gap for the bent triplet chains is consistent with the emission wavelength for bulk CuCN.

Fourteen Cp*IrIII complexes, bearing various combinations of N- and C-spectator ligands, are assayed in hydrogen-transfer catalysis from isopropyl alcohol to acetophenone under various conditions to investigate ligand effects in this widely used reaction. The new cationic complexes bearing monodentate pyridine and N-heterocyclic carbene (NHC) ligands were characterized crystallographically and by variable-temperature nuclear magnetic resonance (VT-NMR). Control experiments and mercury poisoning tests showed that iridium(0) nanoparticles, although active in the reaction, are not responsible for the high activity observed for the most active precatalyst [Cp*Ir(IMe)2Cl]BF4 (6). For efficient catalysis, it was found necessary to have both NHCs in monodentate form; tying them together in a bis-NHC chelate ligand gave greatly reduced activity. The kinetics of the base-assisted reaction showed induction periods as well as deactivation processes, and H/D scrambling experiments cast some doubt on the classical monohydride mechanism.

Copper(i) cyanide exposed to various liquid or vapor-phase amines (L) at ambient temperature produces a variety of visible photoluminescence colors via reversible formation of amine adducts. The adducts show phase matches to authentic (CuCN)L(n), n = 0.75-2.0, produced by heating CuCN with liquid amine.

A series of half-sandwich complexes of iridium, rhodium, and ruthenium are shown to be active catalysts for the conversion of aldehydes and water to carboxylic acids. Depending on the catalyst, H2 is either released (the “aldehyde–water shift”) or transferred to a second equivalent of aldehyde (aldehyde disproportionation). Mechanistic studies suggest hydride transfer to be the selectivity-determining step along the reaction pathway. Using [(p-cymene)­Ru­(bpy)­OH2]­[OTf]2 as precatalyst, we demonstrate a novel example of a highly selective aldehyde–water shift in the absence of a hydrogen acceptor or base.