No abstract

This paper discusses the issue of the true reliability of a beach slope prediction method. Beach profiles have been predicted for five sites where there is reasonable information available regarding the operating variables that influence slope. Data derived from operating records show significant variability in two of the main controlling parameters: throughput (flow rate) and solids concentration (rheology or flow resistance). A combination of these variables has been used to calculate predicted beach slopes over the top, middle and lower thirds of the tailings beaches studied. Reasonable agreement between predicted and observed profiles has been obtained for both the overall slopes, and the measured slope concavity.

The reliable prediction or management of beach slope and stack geometry is integral to realisation of the potential benefits of thickened tailings technology. Stack geometry not only controls the storage capacity for a given footprint, but also strongly influences post-deposition geotechnical and geoenvironmental performance. Unfortunately, accurate prediction in design has proved difficult. However, there has been significant improvement in understanding the behaviour of tailings after they exit the pipe, and a number of methods for beach slope prediction have been proposed and developed. This paper reviews a selection of these methods, and examines their applicability to different deposition scenarios. Some recommendations are made to assist engineers and operators to achieve a given stack geometry.

No abstract

Tailings (mining waste) disposal is a significant consideration for the mining industry, with the majority of the ore processed in most mining operations ending up as tailings. This creates large volumes of tailings, which must be handled and stored responsibly to avoid potential environmental catastrophes. The most common form of tailings storage facility is the impoundment, where tailings are contained within a basin, with beaches forming around the perimeter of the impoundment and a pond standing in the middle. A relatively new method of tailings storage is to create a "stack," whereby the tailings solids form a large heap, with the discharge of tailings slurry from the apex of the heap. This method of tailings storage is finding greater popularity as the industry seeks to reduce the amount of water discharged with the tailings, and usually features the discharge of non-segregating tailings slurry that flows turbulently in its own self-formed channel down the tailings beach. It is of significant interest for mine operators and tailings engineers to be able to predict the shape of the beach that forms in either of these disposal scenarios. The key to being able to do this relies on a method of prediction of the beach slope. In this article two new beach shape models are presented for the three-dimensional (3-D) geometric modeling of the beach surface of a tailings stack that has been formed through the variable discharge of a non-segregating slurry that periodically changes in its composition, whereby the overall discharge output is defined as a sequence of smaller finite periods of steady uniform discharge, each having its own resulting beach slope. A beach slope model previously presented by the authors has been used here to predict the applicable beach slope for each finite discharge regime. The shape models presented here present two different methods for the compounding of the individual tailings deposits that are generated by each of these finite discharge * To whom correspondence should be addressed. E-mail: Satinath. Bhattacharya@rmit.edu.au. regimes. Historic tailings discharge data is run through both models, and the shapes predicted by the models are compared with aerial survey data of real tailings stacks. This work not only presents a method of tailings stack shape prediction, but also a plausible theory for explaining the concavity of tailings beaches. The models also have the potential to be developed further for the 3-D modeling of tailings beaches formed in other types of storage facilities, such as impoundments or valleys.