Groundwater extraction is increasing rapidly in many areas of the world, causing serious impacts such as falling water tables, ground surface subsidence, water quality degradation, and reduction of stream baseflow on which many ecosystems depend. Methods for understanding and predicting the impacts of groundwater extraction generally lack detailed spatial and temporal knowledge of the subsurface hydrogeomechanical properties. This review provides a comprehensive understanding of Earth and atmospheric tides and their impact on subsurface pore pressure. First, we evaluate the global occurrence of Earth and atmospheric tides. Then, we illustrate their impact on the groundwater response and connect this with the theory of poroelasticity, which underpins quantitative analyses. Finally, we review methods that utilize these impacts to characterize groundwater systems and to quantify their hydrogeomechanical properties. We conclude by highlighting their potential as passive and low‐cost investigation techniques and by outlining the research and developments required to progress and make analyses readily available. Thus, hydrogeomechanical properties of subsurface systems could be obtained at unprecedented spatial and temporal resolution, adding additional value to commonly acquired groundwater and atmospheric pressure data.

Abstract. Subsurface hydro-geomechanical properties crucially underpin the management of Earth's resources, yet they are predominantly measured on core samples in the laboratory while little is known about the representativeness of in situ conditions. The impact of Earth and atmospheric tides on borehole water levels is ubiquitous and can be used to characterise the subsurface. We illustrate that disentangling the groundwater response to Earth (M2) and atmospheric tidal (S2) forces in conjunction with established hydraulic and linear poroelastic theories leads to a complete determination of the whole hydro-geomechanical parameter space for unconsolidated systems. Further, the characterisation of consolidated systems is possible when using literature estimates of the grain compressibility. While previous field investigations have assumed a Poisson's ratio from literature values, our new approach allows for its estimation under in situ field conditions. We apply this method to water level and barometric pressure records from four field sites with contrasting hydrogeology. Estimated hydro-geomechanical properties (e.g. specific storage; hydraulic conductivity; porosity; shear, Young's, and bulk moduli; Skempton's and Biot–Willis coefficients; and undrained or drained Poisson's ratios) are comparable to values reported in the literature, except for consistently negative drained Poisson's ratios, which is surprising. Our results reveal an anisotropic response to strain, which is expected for heterogeneous (layered) lithological profiles. Closer analysis reveals that negative Poisson's ratios can be explained by in situ conditions differing to those from typical laboratory core tests and the small strains generated by Earth and atmospheric tides. Our new approach can be used to passively, and therefore cost-effectively, estimate subsurface hydro-geomechanical properties representative of in situ conditions and it improves our understanding of the relationship between geological heterogeneity and geomechanical behaviour.

Abstract. Subsurface hydro-geomechanical properties crucially underpin the management of Earth's resources, yet they are predominantly measured on core-samples in the laboratory while little is known about the representativeness of in-situ conditions. The impact of Earth and atmospheric tides on borehole water levels are ubiquitous and can be used to characterise the subsurface. We illustrate that disentangling the groundwater response to Earth and atmospheric tidal forces in conjunction with hydraulic and linear poroelastic theories leads to a complete determination of the whole hydro-geomechanical parameter space for unconsolidated systems. Further, the characterisation of consolidated systems is possible when using literature estimates of the grain compressibility. While previous field investigations have assumed a Poisson's ratio from literature values, our new approach allows for its estimation under in-situ field conditions. We apply this method to water level and barometric pressure records from four field sites with contrasting hydrogeology. Estimated hydro-geomechanical properties (e.g. specific storage, hydraulic conductivity, porosity, shear-, Young's- and bulk- moduli, Skempton's and Biot-Willis coefficients and undrained/drained Poisson's ratios) are comparable to values reported in the literature, except for consistently negative drained Poisson's ratios which are surprising. Our results reveal an anisotropic response to strain, which is expected for a heterogeneous (layered) lithological profile. Closer analysis reveals that negative Poisson's ratios can be explained by differing in-situ conditions to those from typical laboratory core tests and the small strains generated by Earth and atmospheric tides. Our new approach can be used to passively, and therefore cost-effectively, estimate subsurface hydro-geomechanical properties representative of in-situ conditions. Our method can be used to improve our understanding of the relationship between geological heterogeneity and geomechanical behaviour.

SUMMARYThe Thirlmere Lakes include five natural wetlands within a Blue Mountains World Heritage listed national park, where there are concerns over an apparent possibility of a long term decline in water levels. Lake levels correlate with rainfall variability and are historically known to have dried several times during prolonged droughts. However, the effects of long term hydrological changes on the Lakes are unclear, as are uncertainties associated with extraction of water for local uses and the possible effects of nearby longwall coal mining.This study is part of a large multi-disciplinary research program, of which this part focuses on groundwater conditions insedimentary strata, and the possibilities of interactions with sediments below the Lakes. Surface geophysical techniques and mapping of geological structures will be combined with deep drilling, wireline logging, geological and hydrogeological investigations. Characterisation of sedimentary strata include permeability, bulk density, moisture content, porewater stable water isotopes and XRD mineral identification. New deep drillholes are planned to obtain information on hydraulic properties of formations. A staged geophysical survey program is designed to complement the geological investigation. Resistivity imaging, time-domain electromagnetics and ground penetrating radar (GPR) will be employed to define sedimentary structure within the unconsolidated alluvium (sand, clay and peat layers) and depth estimates to the underlying rock. A combination of these geophysical methods and contextural geological information, will be used to identify structural and sedimentological anomalies and their hydrogeological properties such as permeability and connection to deeper strata. The results of this work provide new data on groundwater conditions in structured rock that underlie the sediments of Thirlmere Lakes.

No abstract