While action spectroscopy of cold molecular ions is a well-established technique to provide vibrationally resolved absorption features, fluorescence experiments are still challenging. Here we report the fluorescence spectra of pyronin-Y and resorufin ions at 100 K using a newly constructed setup. Spectra narrow upon cooling, and the emission maxima blueshift. Temperature effects are attributed to the population of vibrational excited levels in S 1 , and that frequencies are lower in S 1 than in S 0 . This picture is supported by calculated spectra based on a Franck−Condon model that not only predicts the observed change in maximum, but also assigns Franck−Condon active vibrations. In-plane vibrational modes that preserve the mirror plane present in both S 0 and S 1 of resorufin and pyronin Y account for most of the observed vibrational bands. Finally, at low temperatures, it is important to pick an excitation wavelength as far to the red as possible to not reheat the ions.

Here, we present a new instrument named LUNA2 (LUminescence iNstrument in Aarhus 2), which is purpose-built to measure dispersed fluorescence spectra of gaseous ions produced by electrospray ionization and cooled to low temperatures (<100 K). LUNA2 is, as an earlier room-temperature setup (LUNA), optimized for a high collection efficiency of photons and includes improvements based on our operational experience with LUNA. The fluorescence cell is a cylindrical Paul trap made of copper with a hole in the ring electrode to permit laser light to interact with the trapped ions, and one end-cap electrode is a mesh grid combined with an aspheric condenser lens. The entrance and exit electrodes are both in physical contact with the liquid-nitrogen cooling unit to reduce cooling times. Mass selection is done in a two-step scheme where, first, high-mass ions are ejected followed by low-mass ions according to the Mathieu stability region. This scheme may provide a higher mass resolution than when only one DC voltage is used. Ions are irradiated by visible light delivered from a nanosecond 20-Hz pulsed laser, and dispersed fluorescence is measured with a spectrometer combined with an iCCD camera that allows intensification of the signal for a short time interval. LUNA2 contains an additional Paul trap that can be used for mass selection before ions enter the fluorescence cell, which potentially is relevant to diminishing RF heating in the cold trap. Successful operation of the setup is demonstrated from experiments with rhodamine dyes and oxazine-4, and spectral changes with temperature are identified.

When ionic dyes are close together, the internal Coulomb interaction may affect their photophysics and the energy-transfer efficiency. To explore this, we have prepared triangular architectures of three rhodamines connected to a central triethynylbenzene unit (1,3,5-tris(buta-1,3-diyn-1-yl) benzene) based on acetylenic coupling reactions and measured fluorescence spectra of the isolated, triply charged ions in vacuo. We find from comparisons with previously reported monomer and dimer spectra that while polarization of the πsystem causes redshifted emission, the separation between the rhodamines is too large for a Stark shift. This picture is supported by electrostatic calculations on model systems composed of three linear and polarizable ionic dyes in D 3h configuration: The electric field that each dye experiences from the other two is too small to induce a dipole moment, both in the ground and the excited state. In the case of heterotrimers that contain either two rhodamine 575 (R575) and one R640 or one R575 and two R640, emission is almost purely from R640 although the polarization of the π-system expectedly diminishes the dipole-dipole interaction.

Bioluminescence from fireflies, click beetles, and railroad worms ranges in color from green-yellow to orange to red. The keto form of oxyluciferin is considered a key emitter species in the proposed mechanisms to account for color variation. To establish the intrinsic photophysics in the absence of a microenvironment, we present experimental and theoretical gas-phase absorption and emission spectra of the 5,5-dimethyloxyluciferin anion (keto form) at room and cryogenic temperatures as well as lifetime measurements based on fluorescence. The theoretical model includes all 75 vibrational modes. The spectral impact of the large number of excited states at elevated temperatures is captured by an effective state distribution. At low temperature, spectral congestion is greatly reduced, and the observed well-resolved vibrational features are assigned to multiple Franck−Condon progressions involving different vibrational modes. An in-plane ∼60 cm −1 scissoring mode is found to be involved in the dominant progressions.

Förster Resonance Energy transfer (FRET) is a nonradiative process that may occur from an electronically excited donor to an acceptor when the emission spectrum of the donor overlaps with the absorption spectrum of the acceptor. FRET experiments have been done in the gas phase based on specially designed mass‐spectroscopy setups with the goal to obtain structural information on biomolecular ions labeled with a FRET pair (i.e., donor and acceptor dyes) and to shed light on the energy‐transfer process itself. Ions are accumulated in a radio‐frequency ion trap or a Penning trap where mass selection of those of interest takes place, followed by photoexcitation. Gas‐phase FRET is identified from detection of emitted light either from the donor, the acceptor, or both, or from a fragmentation channel that is specific to the acceptor when electronically excited. The challenge associated with the first approach is the collection and detection of photons emitted from a thin ion cloud that is not easily accessible while the second approach relies both on the photophysical and chemical behavior of the acceptor. In this review, we present the different instrumentation used for gas‐phase FRET, including a discussion of advantages and disadvantages, and examples on how the technique has provided important structural information that is not easily obtainable otherwise. Furthermore, we describe how the spectroscopic properties of the dyes are affected by nearby electric fields, which is readily discernable from experiments on simple model systems with alkyl or π‐conjugated bridges. Such spectral changes can have a significant effect on the FRET efficiency. Ideas for new directions are presented at the end with special focus on cold‐ion spectroscopy.