The objective of this randomized clinical trial was to evaluate the clinical performance of adhesive restorations using a three-step etch-and-rinse adhesive (TSER), a one-step self-etching adhesive (OSSE), and a simplified ethanol-wet bonding technique (EWBT) prior to the application of a composite resin in non-carious cervical lesions. Ninety-three restorations (31 for each group) were placed in 17 patients by a single operator. No cavity preparation was performed. After 6 and 12 months, the restorations were assessed by two previously trained examiners using modified Ryge criteria for retention (kappa=1.00) and marginal adaptation/staining (kappa=0.81), and the results were analyzed by Fisher's exact and Kruskal-Wallis tests, respectively. No significant differences were observed among groups at the 6-and 12-month time points for any of the assessed criteria (p≥0.05). The intra-group analysis performed by Cochran's test (for retention) and Wilcoxon test (for marginal adaptation/staining) revealed significant differences between the baseline/12-month time intervals in marginal adaptation in OSSE (p=0.0180) and in marginal staining in TSER (p=0.0117). The survival analysis for retention criteria performed using a logrank test did not show significant differences (p>0.05). The restorations placed using the simplified EWBT performed equally well as the other adhesive strategies employed.

ABSTRACT:The objective of this randomized clinical trial was to evaluate the clinical performance up to 18 months of restorations placed using ethanol-wet bonding technique (EWBT) compared with the three-step etch-and-rinse (TSER) and one-step self-etching (OSSE) approaches. Ninety-three non-carious cervical lesions (31 for each group) were restored by one experienced operator in 17 patients under relatively dry conditions using gingival retraction cord, cotton rolls and saliva ejector. Each adhesive system was randomly allocated to one of randomized cervical lesions until the three groups were present in the same subject in equal amounts. The restorations were evaluated at baseline, 6, 12 and 18 months by two blinded and calibrated examiners using the modified US Public Health Service guidelines (USPHS) for the following outcomes: retention (kappa= 1.00), staining and marginal adaptation (kappa=0.81) and analyzed by Fisher's exact and Kruskal-Wallis tests, respectively. No significant differences were observed among groups after 18 months for any of the assessed criteria (p>0.05). The intra-group analysis performed by Cochran's test (for retention) and Wilcoxon test (for marginal adaptation/staining) revealed significant differences between the time intervals baseline/18 months in marginal adaptation (p= 0.0117) and retention (p= 0.0101) for OSSE and in marginal staining for TSER (0.0051) and EWBT (p= 0.0277) groups. The survival analysis for retention criteria and the overall clinical success were performed using a log-rank test and did not show significant differences among groups (p> 0.05). All three adhesives protocols presented similar clinical performance up to 18 months.

The ethanol wet-bonding technique (EWBT) was introduced in an attempt to overcome the problems caused by high hydrophilicity and/or incomplete penetration of most commercially available adhesive systems. This strategy provides better conditions for the inter-diffusion of hydrophobic dentin monomers. Today, there are many EWBT protocols, which yield bonding interfaces with minimal degradation and longer durability compared with commercial hydrophilic adhesive systems. The aim of this review is to discuss in greater detail the EWBT, focused on the following aspects: dentin saturation, hydrophobic primer preparation, inactivation of metalloproteinases (MMPs), dentin biomimetic remineralization and the clinical perspectives of this technique. The present review on the EWBT provides support for a better understanding of the behavior of dentin when exposed to dehydration and hydrophobic monomer interaction. Moreover, additional studies are suggested to investigate the long-term stability of this type of hybrid layer.

No abstract