In this study, the CeO2-Fe2O3 mixed oxide catalysts have been prepared by combustion method using gel-created tartaric acid. The ability of effective carbon monoxide (CO) oxidation to carbon dioxide (CO2) by CeO2-Fe2O3 catalyst under low-temperature conditions was also demonstrated. The calcined CeO2-Fe2O3 material has a porous honeycomb structure and good gaseous absorption-desorption ability. The solid solution of CeO2-Fe2O3 mixed oxides was formed by the substitution of Fe+3 ions at some Ce4+ ion sites within the CeO2 crystal lattice. The results also showed that the calcination temperature and the molar ratio of Ce3+ ions to Fe3+ ions (CF) affected the formation of the structural phase and the catalytic efficiency. The catalytic properties of the CeO2-Fe2O3 mixed oxide were good at the CF ratio of 1 : 1, the average crystal size was near 70 nm, and the specific surface area was about 20.22 m2.g-1. The full conversion of CO into CO2 has been accomplished at a relatively low temperature of 270 °C under insufficient O2 conditions.

In this study, the material characterization of Vietnamese ground coal slag and ground granulated blast furnace slag (GGBFS), such as particle size distribution, chemical composition, bulk density and particle density are shown. The geopolymer specimens were prepared by mixing an 80 m/m% mass of solid materials (ground coal slag and GGBFS in a different ratio) with 20 m/m % of a 10M NaOH alkaline activator. A systematic experimental series was carried out in order to optimize the preparation process. In that series, the heat curing temperature was 60°C for 6 hours, and then selected specimens were heat treated at a high temperature (1000 °C) for 1 hour. After 7 days of ageing, the physical properties of the geopolymer (compressive strength, specimen density) were measured. Also, after 180 days of ageing, the pH values of water in the geopolymer leaching preparation were determined. The results show that the geopolymer can be used for refractory applications due to its good heat resistance properties. However, geopolymers that were heated at 1000 °C had lower compressive strength, specimen density and pH values of water containing the geopolymer than those that were cured at 60 °C.