No abstract

We developed an improved technique for measuring the size distribution of black carbon (BC) particles suspended in liquid water to facilitate quantitative studies of the wet deposition of BC. The measurement system, which consists of a nebulizer and a single-particle soot photometer, incorporates two improvements into the system that we developed earlier. First, we extended the upper limit of the detectable BC size from 0.9 mm to about 4.0 mm by modifying the photo-detector for measuring the laser-induced incandescence signal. Second, we introduced a pneumatic nebulizer (Marin-5) with a high extraction efficiency (»50.0%) that was independent of particle diameter up to 2.0 mm. For BC mass concentrations less than 70 mg L ¡1 , we experimentally showed that the diameters of BC particles did not appreciably change during the Marin-5 extraction process, consistent with theoretical calculations. Finally, we demonstrated by laboratory experiments that the size distributions of ambient BC particles changed little during their growth into cloud droplets under supersaturation of water vapor. Using our improved system, we measured the size distributions of BC particles simultaneously in air and rainwater in Tokyo during summer 2014. We observed that the size distributions of BC particles in rainwater shifted to larger sizes compared with those observed in ambient air, indicating that larger BC particles in air were removed more efficiently by precipitation.

The mechanism of capacity fade of the Li2MnO3·LiMO2 (M = Li, Ni, Co, Mn) composite positive electrode within a full cell was investigated using a combination of operando neutron powder diffraction and transmission X-ray microscopy methods, enabling the phase, crystallographic, and morphological evolution of the material during electrochemical cycling to be understood. The electrode was shown to initially consist of 73(1) wt % R3̅m LiMO2 with the remaining 27(1) wt % C2/m Li2MnO3 likely existing as an intergrowth. Cracking in the Li2MnO3·LiMO2 electrode particle under operando microscopy observation was revealed to be initiated by the solid-solution reaction of the LiMO2 phase on charge to 4.55 V vs Li(+)/Li and intensified during further charge to 4.7 V vs Li(+)/Li during the concurrent two-phase reaction of the LiMO2 phase, involving the largest lattice change of any phase, and oxygen evolution from the Li2MnO3 phase. Notably, significant healing of the generated cracks in the Li2MnO3·LiMO2 electrode particle occurred during subsequent lithiation on discharge, with this rehealing being principally associated with the solid-solution reaction of the LiMO2 phase. This work reveals that while it is the reduction of lattice size of electrode phases during charge that results in cracking of the Li2MnO3·LiMO2 electrode particle, with the extent of cracking correlated to the magnitude of the size change, crack healing is possible in the reverse solid-solution reaction occurring during discharge. Importantly, it is the phase separation during the two-phase reaction of the LiMO2 phase that prevents the complete healing of the electrode particle, leading to pulverization over extended cycling. This work points to the minimization of behavior leading to phase separation, such as two-phase and oxygen evolution, as a key strategy in preventing capacity fade of the electrode.

Deposition of black carbon (BC) aerosol in the Arctic lowers snow albedo, thus contributing to warming in the region. However, the processes and impacts associated with BC deposition are poorly understood because of the scarcity and uncertainties of measurements of BC in snow with adequate spatiotemporal resolution. We sampled snowpack at two sites (11 m and 300 m above sea level) at Ny‐Ålesund, Spitsbergen, in April 2013. We also collected falling snow near the surface with a windsock from September 2012 to April 2013. The size distribution of BC in snowpack and falling snow was measured using a single‐particle soot photometer combined with a characterized nebulizer. The BC size distributions did not show significant variations with depth in the snowpack, suggesting stable size distributions in falling snow. The BC number and mass concentrations (CNBC and CMBC) at the two sites agreed to within 19% and 10%, respectively, despite the sites' different snow water equivalent (SWE) loadings. This indicates the small influence of the amount of SWE (or precipitation) on these quantities. Average CNBC and CMBC in snowpack and falling snow at nearly the same locations agreed to within 5% and 16%, after small corrections for artifacts associated with the sampling of the falling snow. This comparison shows that the dry deposition was a small contributor to the total BC deposition. CMBC were highest (2.4 ± 3.0 μg L−1) in December–February and lowest (1.2 ± 1.2 μg L−1) in September–November.

The lifetime and spatial distributions of accumulation-mode aerosols in a size range of approximately 0.05–1 μm, and thus their global and regional climate impacts, are primarily constrained by their removal via cloud and precipitation (wet removal). However, the microphysical process that predominantly controls the removal efficiency remains unidentified because of observational difficulties. Here, we demonstrate that the activation of aerosols to cloud droplets (nucleation scavenging) predominantly controls the wet removal efficiency of accumulation-mode aerosols, using water-insoluble black carbon as an observable particle tracer during the removal process. From simultaneous ground-based observations of black carbon in air (prior to removal) and in rainwater (after removal) in Tokyo, Japan, we found that the wet removal efficiency depends strongly on particle size, and the size dependence can be explained quantitatively by the observed size-dependent cloud-nucleating ability. Furthermore, our observational method provides an estimate of the effective supersaturation of water vapour in precipitating cloud clusters, a key parameter controlling nucleation scavenging. These novel data firmly indicate the importance of quantitative numerical simulations of the nucleation scavenging process to improve the model’s ability to predict the atmospheric aerosol burden and the resultant climate forcings, and enable a new validation of such simulations.

Quantitative simulation of an aerosol's lifecycle by regional-scale and global-scale atmospheric models is mandatory for unbiased analysis and prediction of aerosol radiative forcing and climate change. Globally, aerosol deposition is dominated by the rainout process, which is mostly triggered by activation of aerosols to liquid droplets in supersaturated domains of precipitating clouds. However, the actual environmental supersaturation value that aerosols experience in precipitating clouds is difficult for models to predict, and it has never been constrained by observations; as a result, there is large uncertainty in atmospheric aerosol simulations. Here, by a particle-tracer analysis of 37 rainfall events in East Asia, near the largest source region of anthropogenic aerosols in the northern hemisphere, we observed that the environmental supersaturation actually experienced by the removed aerosols in precipitating clouds averaged 0.08 ± 0.03% and ranged from 0.03 to 0.2%. Simulations by a mixing-state-resolved global aerosol model showed that the simulated long-range transport efficiency and global atmospheric burden of black carbon aerosols can be changed by a factor of two or three as a result of a change in the environmental supersaturation in precipitating clouds within just 0.08 ± 0.03%. This result is attributable to the fact that the sensitivity of an aerosol's rainout efficiency to environmental supersaturation is higher for the less-aged black carbon concentrated near source regions. Our results suggest that observational constraints of environmental supersaturation in precipitating clouds, particularly near source regions, are of fundamental importance for accurate simulation of the atmospheric burden of black carbon and other aerosols.npj Climate and Atmospheric Science (2019) 2:6 ; https://doi.

No abstract

Black carbon (BC) aerosol deposited in and onto Arctic snow increases the snow's absorption of sunlight and accelerates snowmelt. Wet removal of BC from the atmosphere plays a key role in determining its abundance in the Arctic atmosphere and in Arctic snow. However, this process is poorly understood, mainly due to the scarcity of relevant measurements. To study wet deposition of BC, we made measurements of mass concentration of BC in snow and rain (CMBC) and of BC in air (MBC) with high accuracy (16% and 10%, respectively) at the Barrow Atmospheric Baseline Observatory, Alaska, from July 2013 to August 2017 and analyzed them along with routinely measured meteorological parameters from Barrow. Monthly mean MBC near the surface and CMBC were poorly correlated from midwinter to early spring, when CMBC was close to the annual median while MBC was at its annual peak. Seasonal variations in the altitude distribution of MBC may lead to these differences in seasonal variation of MBC near the surface and CMBC. About 50% of the annual wet deposition of BC occurred in the 3 months of summer, associated with high values of total precipitation and BC originating from biomass burning. Size distributions of BC in snow and rain were stable throughout the year, suggesting that the size distribution of BC in the lower troposphere was similarly stable. Calculations by two global models reproduced the observed seasonal variations of CMBC and showed that BC from biomass burning dominated CMBC in summer.