Several ternary Fe – Ge - C alloys with Ge contents ranging between 3 and 27 at. % have been studied. The structure, anelastic, thermodynamic and kinetic phenomena in Fe - 3, - 12, - 19/21 and – 27 Ge have been examined by X-ray diffraction (XRD), heat flow (DSC), vibrating sample magnetometry (VSM), optical-light and scanning electron microscopy, and internal friction (IF) methods. The Fe - 3Ge and Fe - 12Ge alloys form b.c.c. solid solutions. A Snoek-type internal friction (P1) peak is recorded in the Fe - 3Ge alloy with parameters similar to those for α-Fe: Н = 0.86 eV, Δ = 0.015, β = 0.72 and τ0 = 2 × 10-15 s, showing that Ge atoms have little influence on the diffusivity of carbon in iron. The Fe - 12Ge alloy, with a Curie point around 1008 K, has several IF peaks: a broad Snoek-type (P1 and P2), the P3 peak caused by structural changes in as quenched specimens during annealing, and a P4 (Zener) peak at higher temperature (Tm ≈ 773 K at f = 2 Hz, β ≈ 0.7). The Fe - 21Ge alloy has bcc or bcc plus hexagonal structure depending on heat treatment. The structure of the Fe3Ge-type alloy (Fe - 27Ge) consists mainly of hexagonal phases, i.e. hexagonal ε (D019), β (B81), and cubic ε′ (L12), and exhibits corresponding magnetic ordering transitions below 873 K which are not well-reflected in the common Fe - Ge phase diagrams. In particular a high stability of the hexagonal ε phase at room temperature is noted. A broad internal friction relaxation peak with Δ = 0.0036, H ≈ 1.8 eV and τ 0 = 2 ⋅ 10-17 s is found in Fe – 27 Ge and is classified as a double Zener peak in the ε and β two-phase mixture.
Study of anelasticity in AZ31 magnesium-based alloy in initial (hot-rolled at 370 оС) condition and after one and four passes of equal channel angular pressing is carried out. An internal friction peak was found at 170 °C at a frequency f of about 1 Hz. Two possible mechanisms of this peak are discussed: it is suggested that the peak origin is the grain boundary relaxation.
No abstract
The simultaneous influence of both thermal and mechanical treatment was applied to produce a geometrically complex shaft from 51CrV4 steel. This special treatment led to the formation of adjacent microstructures which were significantly different from each other. It was found that these microstructural changes were accompanied by a change of mechanical properties in terms of hardness, electrical resistivity and especially internal friction. Specimens for structural studies and study of mechanical and physical properties were taken out from different places of the produced shaft and tested in order to verify and understand the obtained gradation. The significant variations in properties could be explained in terms of structure and dislocation behaviour under applied cyclic stress using mechanical spectroscopy technique. The cold-work (Snoek-Köster) peak was recognised and analysed in the structure of this steel.
No abstract
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.