ÖzIsı transferini artırmak ve basınç düşüş değerini en aza indirmek, ısı değiştirgeçlerinin ısıl performansını iyileştirmek açısından önemli olup üzerinde çok sayıda çalışma yapılan bir konudur. Isı transfer oranını artırmak için, üstün termofiziksel özellikli nanoakışkanlar ısı değiştiricilerinde kullanılmaktadırlar. Bu çalışmada birleşik sıcak su hazırlama sisteminde bulunan plakalı ısı değiştiricisinde grafitsu nanoakışkanı kullanımının ısı transferine, etkinlik katsayısına ve iyileştirme oranına etkisi deneysel olarak incelenmiştir. Çalışmada soğuk su debileri 4, 5, 6, 7 l/dk, sıcak akışkan giriş sıcaklıkları ise 40, 45, 50, 55, 60˚C olarak alınmıştır. Elde edilen sonuçlara göre hacimce %0.25 nanoakışkan oranında en yüksek iyileştirme oranı 4 l/dk debi değerinde %9,42 olarak elde edilirken, debi arttıkça ısı transferinin arttığı ve iyileşme oranının düştüğü belirlenmiştir.
Parallel to the developing technology and the increasing population, the energy requirement is increasing day by day. Turkey's dependence on foreign sources of energy constitutes a significant budget in terms of energy costs. In this context, in Turkey, renewable energy sources with high potential are gaining importance. Fossil energy sources cause environmental pollution and threaten human health more and more every day. For this reason, the use of renewable energy sources should be encouraged and widespread. With a good energy needs analysis, producer costs will be reduced and efficiency will be increased. Solar energy is an efficient resource in electricity generation. Increase the efficiency of the solar panels used, increases the amount of electricity produced. However, the change in the angle of the sun's rays has an adverse effect on energy production. In this study, it was aimed to increase the efficiency of the solar panels by moving according to angle of sunlight. For this purpose, solar panel was driven by the servo motor and it was directed to the sunlight. Servo motor's PID control was implemented using the MATLAB program. The energy analysis made is given in the results.
In this study, the effects of rotating straight and helical inner tubes is experimentally discussed to determine heat transfer and pressure losses in rotating tubes and improve heat transfer. The outer tube remains stationary and the inner tube is rotated at different speeds in the work. In the experiments for straight and helical tubes, the flow regime is turbulent. According to the results, Nusselt number, pressure loss, efficiency of heat exchanger were gauged. In addition, empirical formulas were obtained for each pipe type. It is observed that as the rotation speed of the pipe increases, the heat transfer rate increases. The pipe that provides the best increase in heat transfer is the five helixes tubes. At 5 helixes tubes; after the number of revolutions per minute (rpm) exceeds 300, the increase in heat transfer rate has almost halt. At 5 helixes tubes and at 300 rpm speed ; when the flow of cold water through the annular gap with the fluid passing through the inner tube is equal, the heat transfer increases by 124.10% compared to straight tube, 23.47% compared to 2 helixes tubes, 7.92% compared to 3 helixes tubes and 1.65% compared to 4 helixes tubes. Maximum effectiveness was obtained while rotating with 300 rpm in 5 helixes pipes.
Bu çalışmada, bir Renault Clio marka otomobil radyatöründe soğutma akışkanı olarak grafen su bazlı nanoakışkan kullanılmış ve motor soğutma performansı deneysel olarak incelenmiştir. Deneylerde ısı transfer hızındaki artış ve basınç düşüşündeki artış değerleri irdelenmiştir. Deney düzeneği motor soğutma sistemine benzer şekilde tasarlanmıştır. Dört tip çalışma sıvısı kullanılmıştır. Bunlar saf su ve (0.01-0.02-0.03) grafen nanoparçacık konsantrasyonuna sahip nanoakışkanlardır. Deneyde hacimsel debi 4 ile 16 l/dk arasında 6 farklı debide gerçekleştirilmiştir. Otomobil radyatörüne giriş sıcaklığı 70°C olarak sabit tutulmuştur. Deneyler laminer akışta gerçekleştirilmiştir. Reynolds sayısı 224 ile 1482 arasındadır. Yapılan deney sonucunda %0.02 hacimsel nanoparçacık konsantrasyonuna sahip nanokışkan kullanmanın ısı transfer hızında %47 artış sağladığı görülmüştür. Toplam ısı transfer katsayısında % 52 ve Nusselt sayısında % 34 maksimum bir artış elde edilmiştir. Basınç düşüşündeki artış %49 olarak tespit edilmiştir. Nanopartiküllerin konsantrasyonunu artırarak ısıl performansların arttığı gözlemlenmiş ancak nanopartiküllerin konsantrasyonunun %0.02'nin üzerine çıkartıldığında motor soğutma performansının düşmeye başladığı izlenmiştir. Çalışma sonucunda en iyi ısı transfer değerlerine %0.02 grafen bazlı su konsantrasyonu kullanıldığında ulaşılmıştır.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.