Remanent polarizations (Pr) of 200-nm-thick epitaxial Pb(Zr0.35,Ti0.65)O3 (PZT) thin films deposited on (001), (110), and (111) SrTiO3 (STO) substrates coated with SrRuO3 (SRO) were compared to the domain configurations that were precisely and quantitatively characterized by high-resolution x-ray diffraction reciprocal space mapping (HRXRD-RSM). (001)/(100), (101)/(110), and (111) oriented domains were obtained for films grown on (001), (110), and (111) STO substrates coated with SRO, respectively. HRXRD-RSM showed that the films grown on (001) and (110) STO substrates mainly consisted of (001) and (101) domains, although they also included about 32% and 25% of (100) and (110) domain, respectively. Tilt growths in the domains were found except for the (001) domain. The tilt growths in the (100), (101), and (110) domains were attributed to the geometrically induced tilt by the 90° domain that had {101} domain walls. On the other hand, the tilt in the (111) domain was attributed to the misfit strain relaxation by introducing tilt growth in the domain but not due to the 90° domain. The Pr ratios of films having different domain configurations were well explained by the estimated Pr ratios from the volume fractions of the domains, based on the assumption that the 90° domain was not reoriented by the externally applied electrical field and did not contribute to the measured Pr values. This indicates that the 90° domain is strongly pinned in epitaxial 200-nm-thick PZT films and the 180° domain switching is the dominant contribution to the total remanent polarization.
In the Sr–Bi–Ta–Nb–O system, three crystallographic phases are known to exist: the SrBi2(Ta1-x
Nb
x
)O9 (SBTN) perovskite, fluorite and pyrochlore phases. It is considered that the fluorite phase is a low-temperature phase of SBT, which tends to grow in excess bismuth compositions, and the pyrochlore phase tends to grow in bismuth-deficient compositions. In conventional X-ray diffraction (XRD) characterization, the SBTN phase shows strong (115) diffraction around 29 [2θ deg]. Unfortunately, however, the other two phases also show their (111) and (222) diffractions near the same angle when the film is prepared on a platinum-coated silicon substrate. Therefore, the phase identification of the SBTN phase from the other two phases is almost impossible by the conventional technique. We employed XRD reciprocal space mapping to distinguish these phases in the present study. The three crystallographic phases were identified and distinguished from each other. It is ascertained that this technique is effective to identify crystallographic phases especially in the case in which more than two phases show similar diffraction angles.
ABSTRACT200-nm-thick Pb(Zrx,Ti1-x)O3 (PZT) thin films with zirconium composition in the range from 0% to 65% were epitaxially grown on (001)c SrRuO3 (SRO)//SrTiO3 (STO) single crystal substrates by pulsed metalorganic chemical vapor deposition (pulsed MOCVD). Constituent crystallographic phases were characterized by high-resolution X-ray diffraction reciprocal space mapping. It was found that PZT thin films having zirconium composition from 45% to 60% show mixed tetragonal and pseudocubic phases and their lattice parameters remained constant in this composition range.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.