No abstract

ABSTRACT:The surfaces of glass fibers were sized by polyvinyl alcohol (PVA), polyester, and epoxy resin types in order to improve the mechanical interfacial properties of fibers in the unsaturated polyester matrix. The surface energetics of the glass fibers sized were investigated in terms of contact angle measurements using the wicking method based on the Washburn equation, with deionized water and diiodomethane as the wetting liquids. In addition, the mechanical behaviors of the composites were studied in the context of the interlaminar shear strength (ILSS), critical stress intensity factor (K IC ), and flexural measurements. Different evolutions of the London dispersive and specific (or polar) components of the surface free energy of glass fibers were observed after different sizing treatments. The experimental result of the total surface free energies calculated from the sum of their two components showed the highest value in the epoxy-sized glass fibers. From the measurements of mechanical properties of composites, it was observed that the sizing treatment on fibers could improve the fiber-matrix interfacial adhesion, resulting in improved final mechanical behaviors, a result of the effect of the enhanced total surface free energy of glass fibers in a composite system.

The effect of the novel N-crotyl-N,N-dimethyl-4-methylanilinium hexafluroantimonate (CMH) initiator on cure kinetics and rheological properties of diglycidylether of bisphenol A (DGEBA) epoxy cationic system was investigated. From DSC measurements of the DGEBA/CMH system, it was found that this system exhibited excellent thermal latent characteristics at a given temperature and revealed complex cure behavior as indicated by multiple exotherms. The conversion and conversion rate of the DGEBA/CMH system increased with increasing the concentration of initiator, attributed to the high activity of CMH. Viscoelastic properties during gel formation of DGEBA initiated by CMH were investigated by rheological techniques under isothermal conditions. The gel time obtained from the modulus crossover point t(GЈ) ϭ GЉ was affected by a high curing temperature and the concentration of CMH, resulting in a high degree of network formation in cationic polymerization.

No abstract