After many years of fusion research, the conditions needed for a D–T fusion reactor have been approached on the Tokamak Fusion Test Reactor (TFTR) [Fusion Technol. 21, 1324 (1992)]. For the first time the unique phenomena present in a D–T plasma are now being studied in a laboratory plasma. The first magnetic fusion experiments to study plasmas using nearly equal concentrations of deuterium and tritium have been carried out on TFTR. At present the maximum fusion power of 10.7 MW, using 39.5 MW of neutral-beam heating, in a supershot discharge and 6.7 MW in a high-βp discharge following a current rampdown. The fusion power density in a core of the plasma is ≊2.8 MW m−3, exceeding that expected in the International Thermonuclear Experimental Reactor (ITER) [Plasma Physics and Controlled Nuclear Fusion Research (International Atomic Energy Agency, Vienna, 1991), Vol. 3, p. 239] at 1500 MW total fusion power. The energy confinement time, τE, is observed to increase in D–T, relative to D plasmas, by 20% and the ni(0) Ti(0) τE product by 55%. The improvement in thermal confinement is caused primarily by a decrease in ion heat conductivity in both supershot and limiter-H-mode discharges. Extensive lithium pellet injection increased the confinement time to 0.27 s and enabled higher current operation in both supershot and high-βp discharges. Ion cyclotron range of frequencies (ICRF) heating of a D–T plasma, using the second harmonic of tritium, has been demonstrated. First measurements of the confined alpha particles have been performed and found to be in good agreement with TRANSP [Nucl. Fusion 34, 1247 (1994)] simulations. Initial measurements of the alpha ash profile have been compared with simulations using particle transport coefficients from He gas puffing experiments. The loss of alpha particles to a detector at the bottom of the vessel is well described by the first-orbit loss mechanism. No loss due to alpha-particle-driven instabilities has yet been observed. D–T experiments on TFTR will continue to explore the assumptions of the ITER design and to examine some of the physics issues associated with an advanced tokamak reactor.
A similarity solution is presented which describes the internal waves generated by a simple-harmonic localized disturbance in a stably stratified viscous fluid. Some experimental results support the theoretical predictions for the waves in a linearly stratified salt solution.
Wall conditioning in the Tokamak Fusion Test Reactor ͑TFTR͒ ͓K. M. McGuire et al., Phys. Plasmas 2, 2176 ͑1995͔͒ by injection of lithium pellets into the plasma has resulted in large improvements in deuterium-tritium fusion power production ͑up to 10.7 MW͒, the Lawson triple product ͑up to 10 21 m Ϫ3 s keV͒, and energy confinement time ͑up to 330 ms͒. The maximum plasma current for access to high-performance supershots has been increased from 1.9 to 2.7 MA, leading to stable operation at plasma stored energy values greater than 5 MJ. The amount of lithium on the limiter and the effectiveness of its action are maximized through ͑1͒ distributing the Li over the limiter surface by injection of four Li pellets into Ohmic plasmas of increasing major and minor radius, and ͑2͒ injection of four Li pellets into the Ohmic phase of supershot discharges before neutral-beam heating is begun.
H-mode operation plays a crucial role in National Spherical Torus Experiment (NSTX) research, allowing higher beta limits due to reduced plasma pressure peaking, and long pulse operation due to high bootstrap current fraction. Here, new results are presented in the areas of edge localized modes (ELMs), H-mode pedestal physics and power threshold studies. ELMs of several types as reported by higher aspect ratio tokamaks have been observed: (1) large, Type I ELMs, (2) intermediate-sized Type III ELMs and (3) tiny ELMs. Many high performance discharges in NSTX have the tiny ELMs (recently termed Type V), which have some differences as compared with small-magnitude ELM types in the published literature. A divertor multifaceted axisymmetric radiation from the edge (MARFE) on the inboard leg provides an effective light source to examine the effect of the ELMs on the divertor plasma; it is clear that only the large ELMs burn through the MARFE. The time difference between observation of the ELM flux at the outer and inner targets is substantially longer for the smallest ELMs as compared with the large ELMs. In addition, the visible light patterns show ‘finger-like’ striations during the tiny ELMs. H-mode pedestal studies have commenced, with the observation that the pedestal contains between 25% and 33% of the total stored energy, and the NSTX pedestal energy agrees reasonably well with a recent international multi-machine scaling. A power threshold identity experiment between NSTX and the Mega-Amp Spherical Tokamak shows comparable loss power at the L–H transition in balanced double-null discharges. Both machines require more power for the L–H transition as the balance is shifted toward lower-single null. High-field side gas fuelling enables more reliable H-mode access in NSTX, but does not always lead to a lower power threshold, e.g. with a reduction of the duration of early heating.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.