Pseudotachylytes are typically interpreted to have formed by frictional melting during coseismic faulting within the upper to middle crust. Pseudotachylytes in the Bergen arcs of western Norway contain microlites including omphacite, garnet, plagioclase, and quartz. This eclogite facies assemblage is stable at temperatures of about 800°C and pressures of 18 to 19 kilobars, corresponding to depths of 60 kilometers or more. The pseudotachylytes are exposed in Grenvillian granulites that locally underwent fluid-induced eclogitization and corresponding volume reduction of approximately 10 percent during the Caledonian continental collision. The pseudotachylytes may have formed as a result of the rapid relaxation of stresses caused by the eclogitization process.

A B S T R A C T Caledonian eclogite facies shear zones developed from Grenvillian garnet granulite facies anorthosites and gabbros in the Bergen Arcs of western Norway allow direct investigation of the relations between macroscopic structures and crystallographic preferred orientation (CPO) in lower continental crust. Field relations on the island of Holsn~y show that the eclogites formed locally from granulite facies rocks by progressive development of: (1) eclogite adjacent to fractures; (2) eclogite in discrete shear zones (<2 m thick); (3) eclogite breccia consisting of <80% well-foliated eclogite that wraps around rotated granulite blocks; and (4) anastomosing, subparallel, eclogite facies shear zones 30-100 m thick continuous over distances > 1 km within the granulite terrane. These shear zones deformed under eclogite facies conditions at an estimated temperature of 670 f 50°C and a minimum pressure of 1460 MPa, which corresponds to depths of >55 km in the continental crust. Detailed investigation of the major shear zones shows the development of a strong foliation defined by the shape preferred orientation of omphacite and by alternating segregations of omphacite/garnet-rich and kyanite/zoisite-rich layers. A consistent lineation throughout the shear zones is defined by elongate aggregates of garnet and omphacite. The CPO of omphacite, determined from five-axis universal stage measurements, shows a strong b-axis maximum normal to foliation, and a c-axis girdle within the foliation plane with weak maxima parallel to the lineation direction. These patterns are consistent with deformation of omphacite by slip parallel to [Ool] and suggest glide along (010). The lineation and CPO data reveal a consistent sense of shear zone movement, although the displacement was small. Localized faulting of high-grade rocks accompanied by fluid infiltration can be an important mode of failure in the lower continental crust. Field relations show that granulite facies rocks can exist in a metastable state under eclogite facies conditions and imply that the lower crust can host differing metamorphic facies at the same depth. Deformation of granulite and partial conversion to eclogite, such as is exposed on Holsn~y Island, may be an orogenic-scale process in the lowermost crust of collisional orogens.

No abstract

Strongly foliated eclogite-facies rocks in 30-150 m thick shear zones of Caledonian age occur within a Grenvillian garnet granulite-facies gabbro-anorthosite terrain in the Bergen Arcs of Norway. The predominant eclogite-facies mineral assemblages in the shear zones are omphacite + garnet + zoisite + kyanite in gabbroic anorthosite and omphacite + garnet in gabbro. Eclogite-facies rocks in shear zones are generally fine-grained; alternating omphacite/ garnet-and kyanite/ clinozoisite-rich layers define gneissic layering. A strong shape preferred orientation of omphacite, kyanite, and white mica (phengitic muscovite and/or paragonite) define the foliation. The anorthositic eclogites show omphacite b-axis maxima approximately normal to the foliation and c-axis girdles within the foliation plane. P-wave velocities (V,) determined at confining pressures to 600 MPa for samples from eciogite-facies shear zones range from 8.3 to 8.5 km s-l and anisotropy ranges from 1 to 7%. The few samples with more pronounced anisotropy tend to be approximately transversely isotropic with minimum velocities for propagation directions normal to foliation and maximum velocities for propagation directions parallel to foliation. The fast propagation direction lies within the c-axis girdles (parallel to foliation) and the slow propagation direction is parallel to the b-axis concentration (normal to foliation) in samples for which omphacite crystallographic preferred orientation was determined, V, for the granulite-facies protoliths average about 7.5 km s -'. High calculated reflection coefficients for these shear zones, 0.04-0.14, indicate that they are excellent candidates for deep crustal reflectors in portions of crust that experienced high-pressure conditions but escaped thermal reactivation.

No abstract