Mixing in 96-well microplates was studied using soluble pH indicators and a fluorescence pH sensor. Small amounts of alkali were added with the aid of a multichannel pipet, a piston pump, and a piezoelectric actuator. Mixing patterns were observed visually using a video camera. Addition of drops each of about 1 nL with the piezoelectric actuator resulted in umbrella and double-disklike shapes. Convective mixing was mainly observed in the upper part of the well, whereas the lower part was only mixed quickly when using the multichannel pipet and the piston pump with an addition volume of 5 microL or larger. Estimated mixing times were between a few seconds and several minutes. Mixing by liquid dispensing was much more effective than by shaking. A mixing model consisting of 21 elements could describe mixing dynamics observed by the dissolved fluorescence dye and by the optical immobilized pH sensor. This model can be applied for designing pH control in microplates or for design of kinetic experiments with liquid addition.

Microplates with integrated optical oxygen sensors are a new tool to study metabolic rates and enzyme activities. Precise measurements are possible only if oxygen exchange between the sample and the environment is known. In this study we quantify gas exchange in plastic microplates. Dissolved oxygen was detected using either an oxygen-sensitive film fixed at the bottom of each well or a needle-type sensor. The diffusion of oxygen into wells sealed with different foils, paraffin oil, and paraffin wax, respectively, was quantified. Although foil covers showed the lowest oxygen permeability, they include an inevitable gas phase between sample and sealing and are difficult to manage. The use of oil was found to be critical due to the extensive shaking caused by movement of the plates during measurements in microplate readers. Thus, paraffin wax was the choice material because it avoids convection of the sample and is easy to handle. Furthermore, without shaking, significant gradients in pO2 levels within a single well of a polystyrene microplate covered with paraffin oil were detected with the needle-type sensor. Higher pO2 levels were obtained near the surface of the sample as well as near the wall of the well. A significant diffusion of oxygen through the plastic plate material was found using plates based on polystyrene. Thus, the location of a sensor element within the well has an effect on the measured pO2 level. Using a sensor film fixed on the bottom of a well or using a dissolved pO2-sensitive indicator results in pO2 offset and in apparently lower respiration rates or enzyme activities. Oxygen diffusion through a polystyrene microplate was simulated for measurements without convection--that is, for samples without oxygen diffusion through the cover and for unshaken measurements using permeable sealings. This mathematical model allows for calculation of the correct kinetic parameters.

Among the GDSL family of serine esterases/lipases is a group of bacterial enzymes that posses C-terminal extensions involved in outer membrane anchoring or translocation. ApeE from Salmonella enterica serovar Typhimurium, a member of this group, has been expressed in Escherichia coli and was resistant to protease digestion when the protease was added to whole cells, indicating a periplasmic localization. The five consensus blocks conserved within all GDSL esterases were identified in ApeE by multiple sequence alignment and separated from the C-terminal extension. The DNA sequence spanning the four invariant residues Ser, Gly, Asn, and His, and hence representing the catalytic domains of ApeE, was amplified by PCR and fused in frame to the transport domains of the autodisplay system. The resulting artificial esterase, called EsjA, was overexpressed in the cell envelope of E. coli and was shown to be active by the use of ␣-naphthyl acetate (␣-NA) as a substrate in an in-gel activity stain after sodium dodecyl sulfate-polyacrylamide gel electrophoresis. Surface exposure of EsjA was indicated by its accessibility to protease added to whole cells. The esterase activity of whole cells displaying EsjA was determined by a pH agar assay and by the use of microplates with integrated pH-dependent optical sensors. ␣-NA, ␣-naphthyl butyrate, and ␣-naphthyl caproate were used as substrates, and it turned out that the substrate preferences of artificial EsjA were altered in comparison to original ApeE. Our results indicate that autodisplay of esterase in combination with pH sensor microplates can provide a new platform technology for the screening of tailor-made hydrolase activities.