Protein-polymer conjugates are widely used in biotechnology and medicine, and new methods to prepare the bioconjugates would be advantageous for these applications. In this report, we demonstrate that bioactive "smart" polymer conjugates can be synthesized by polymerizing from defined initiation sites on proteins, thus preparing the polymer conjugates in situ. In particular, free cysteines, Cys-34 of bovine serum albumin (BSA) and Cys-131 of T4 lysozyme V131C, were modified with initiators for atom transfer radical polymerization (ATRP) either through a reversible disulfide linkage or irreversible bond by reaction with pyridyl disulfide- and maleimide-functionalized initiators, respectively. Initiator conjugation was verified by electrospray-ionization mass spectroscopy (ESI-MS), and the location of the modification was confirmed by muLC-MSMS (tandem mass spectrometry) analysis of the trypsin-digested protein macroinitiators. Polymerization of N-isopropylacrylamide (NIPAAm) from the protein macroinitiators resulted in thermosensitive BSA-polyNIPAAm and lysozyme-polyNIPAAm in greater than 65% yield. The resultant conjugates were characterized by gel electrophoresis and size exclusion chromatography (SEC) and easily purified by preparative SEC. The identity of polymer isolated from the BSA conjugate was confirmed by (1)H NMR, and the polydispersity index was determined by gel permeation chromatography (GPC) to be as low as 1.34. Lytic activities of the lysozyme conjugates were determined by two standard assays and compared to that of the unmodified enzyme prior to polymerization; no statistical differences in bioactivity were observed.

No abstract

To address the need for bioactive materials toward clinical applications in wound healing and tissue regeneration, an artificial protein was created by recombinant DNA methods and modified by grafting of poly(ethylene glycol) diacrylate. Subsequent photopolymerization of the acrylate-containing precursors yielded protein-graft-poly(ethylene glycol) hydrogels. The artificial protein contained repeating amino acid sequences based on fibrinogen and anti-thrombin III, comprising an RGD integrin-binding motif, two plasmin degradation sites, and a heparin-binding site. Two-dimensional adhesion studies showed that the artificial protein had specific integrin-binding capability based on the RGD motif contained in its fibrinogen-based sequence. Furthermore, heparin bound strongly to the protein's anti-thrombin III-based region. Protein-graft-poly(ethylene glycol) hydrogels were plasmin degradable, had Young's moduli up to 3.5 kPa, and supported three-dimensional outgrowth of human fibroblasts. Cell attachment in three dimensions resulted from specific cell-surface integrin binding to the material's RGD sequence. Hydrogel penetration by cells involved serine-protease mediated matrix degradation in temporal and spatial synchrony with cellular outgrowth. Protein-graft-poly(ethylene glycol) hydrogels represent a new and versatile class of biomimetic hybrid materials that hold clinical promise in serving as implants to promote wound healing and tissue regeneration.

We present here the biological performance in supporting tissue regeneration of hybrid hydrogels consisting of genetically engineered protein polymers that carry specific features of the natural extracellular matrix, cross-linked with reactive poly(ethylene glycol) (PEG). Specifically, the protein polymers contain the cell adhesion motif RGD, which mediates integrin receptor binding, and degradation sites for plasmin and matrix-metalloproteinases, both being proteases implicated in natural matrix remodeling. Biochemical assays as well as in vitro cell culture experiments confirmed the ability of these protein-PEG hydrogels to promote specific cellular adhesion and to exhibit degradability by the target enzymes. Cell culture experiments demonstrated that proteolytic sensitivity and suitable mechanical properties were critical for three-dimensional cell migration inside these synthetic matrixes. In vivo, protein-PEG matrixes were tested as a carrier of bone morphogenetic protein (rhBMP-2) to heal critical-sized defects in a rat calvarial defect model. The results underscore the importance of fine-tuning material properties of provisional therapeutic matrixes to induce cellular responses conducive to tissue repair. In particular, a lack of rhBMP or insufficient degradability of the protein-PEG matrix prevented healing of bone defects or remodeling and replacement of the artificial matrix. This work confirms the feasibility of attaining desired biological responses in vivo by engineering material properties through the design of single components at the molecular level. The combination of polymer science and recombinant DNA technology emerges as a powerful tool for the development of novel biomaterials.

No abstract

The biochemical and morphological specializations of rod and cone photoreceptors reflect their roles in sight. The apoprotein opsin, which converts photons into chemical signals, functions at one end of these highly polarized cells, in the outer segment. Previous work has shown that the mRNA of rod opsin, the opsin specific to rods, is renewed in the outer segment with a diurnal rhythm in the retina of the teleost fish Haplochromis burtoni. Here we show that in the same species, all three cone opsin mRNAs (blue, green, and red) also have a diurnal rhythm of expression. Quantitative real-time polymerase chain reaction (PCR) with primer pairs specific for the cone photoreceptor opsin subtypes was used to detect opsin mRNA abundance in animals sacrificed at 3-h intervals around the clock. All three cone opsins were expressed with diurnal rhythms similar to each other but out of phase with the rod opsin rhythm. Specifically, cone opsin expression occurs at a higher level near the onset of the dark period, when cones are not used for vision. Finally, we found that the rhythm of cone opsin expression in fish appears to be light dependent, as prolonged darkness changes normal diurnal expression patterns.

In this study we developed polymer scaffolds intended as anchorage rings for cornea prostheses among other applications, and examined their cell compatibility. In particular, a series of interconnected porous polymer scaffolds with pore sizes from 80 to 110 microns were manufactured varying the ratio of hydrophobic to hydrophilic monomeric units along the polymer chains. Further, the effects of fibronectin precoating, a physiological adhesion molecule, were tested. The interactions between the normal human fibroblast cell line MRC-5 and primary human umbilical vein endothelial cells (HUVECs) with the scaffold surfaces were evaluated. Adhesion and growth of the cells was examined by confocal laser scanning microscopy. Whereas MRC-5 fibroblasts showed adhesion and spreading to the scaffolds without any precoating, HUVECs required a fibronectin precoating for adhesion and spreading. Although both cell types attached and spread on scaffold surfaces with a content of up to a 20% hydrophilic monomers, cell adhesion, spreading, and proliferation increased with increasing hydrophobicity of the substrate. This effect is likely due to better adsorption of serum proteins to hydrophobic substrates, which then facilitate cell adhesion. In fact, atomic force microscopy measurements of fibronectin on surfaces representative of our scaffolds revealed that the amount of fibronectin adsorption correlated directly with the hydrophobicity of the surface. Besides cell adhesion we also examined the inflammatory state of HUVECs in contact with the scaffolds. Typical patterns of platelet/endothelial cell adhesion molecule-1 expression were observed at intercellular boarders. HUVECs adhering on the scaffolds retained their proinflammatory response potential as shown by E-selectin mRNA expression after stimulation with lipopolyssacharide (LPS). The proinflammatory activation occurred in most of the cells, thus confirming the presence of a functionally intact endothelium. Little or no expression of the proinflammatory activation markers in the absence of LPS stimulation was observed for HUVECs growing on scaffolds with up to a 20% of hydrophilic component, whereas activation of these markers was observed after stimulation. In conclusion, scaffolds containing up to 20% hydrophilic monomers exhibited excellent cell compatibility toward human fibroblast cell line MRC-5 and human endothelial cells. Atomic force microscopy confirmed that adsorbed serum proteins such as fibronectin probably accounted for the positive correlation of HUVEC adhesion and surface hydrophobicity.

Modern tissue engineering concepts integrate cells, scaffolds, signalling molecules and growth factors. For the purposes of regenerative medicine, fetal development is of great interest because it is widely accepted that regeneration recapitulates in part developmental processes. In tissue engineering of cartilage the growth plate of the long bone represents an interesting, well-organized developmental structure with a spatial distribution of chondrocytes in different proliferation and differentiation stages, embedded in a scaffold of extracellular matrix components. The proliferation and differentiation of these chondrocytes is regulated by various hormonal and paracrine factors. Thus, members of the TGFbeta superfamily, the parathyroid hormone-related peptide-Indian hedgehog loop and a number of transcription factors, such as Sox and Runx, are involved in the regulation of chondrocyte proliferation and differentiation. Furthermore, adhesion molecules, homeobox genes, metalloproteinases and prostaglandins play a role in the complex regulation mechanisms. The present paper summarizes the morphological organization of the growth plate and provides a short but not exhaustive overview of the regulation of growth plate development, giving interesting insights for tissue engineering of cartilage.