No abstract

No abstract

The authors have developed a large-signal simulation technique extending an in-house small-signal simulation code for analyzing a 94 GHz double-drift region impact avalanche transit time device based on silicon with a non-sinusoidal voltage excitation and studied the effect of junction temperature between 300 and 550 K on the large-signal characteristics of the device for both continuous wave (CW) and pulsed modes of operation. Results show that the large-signal RF power output of the device in both CW and pulsed modes increases with the increase of voltage modulation factor up to 60%, but decreases sharply with further increase of voltage modulation factor for a particular junction temperature; while the same parameter increases with the increase of junction temperature for a particular voltage modulation factor. Heat sinks made of copper and type-IIA diamond are designed to carry out the steady-state and transient thermal analysis of the device operating in CW and pulsed modes respectively. Authors have adopted Olson's method to carry out the transient analysis of the device, which clearly establishes the superiority of type-IIA diamond over copper as the heat sink material of the device from the standpoint of the undesirable effect of frequency chirping due to thermal transients in the pulsed mode.

Porcelain and plastic materials constitute bulk of household wastes. Owing to resistibility and slow degradability that accounts for higher residence time, these materials qualify as potential hazardous wastes. Retention of water permits these wastes to form a congenial biotope for the breeding of different vector mosquitoes. Thus porcelain and plastic wastes pose a risk from public health viewpoint. This proposition was validated through the study on the porcelain and plastic household wastes as larval habitats of Dengue vectors (Aedes spp.) in rural and urban areas around Kolkata, India. The wastes were characterized in terms of larval productivity, seasonal variation and a comparison between urban and rural areas was made using data of two subsequent years. The number of wastes positive as larval habitats and their productivity of Aedes spp. varied among the types of household wastes with reference to months and location. Multivariate analysis revealed significant differences in the larval productivity of the household wastes based on the materials, season, and urban–rural context. Results of Discriminant Analysis indicated differences in abundance of Ae. aegypti and Ae. albopictus for the urban and rural areas. The porcelain and plastic wastes were more productive in urban areas compared to the rural areas, indicating a possible difference in the household waste generation. A link between household wastes with Aedes productivity is expected to increase the risk of dengue epidemics if waste generation is continued without appropriate measures to limit addition to the environment. Perhaps, alternative strategies and replacement of materials with low persistence time can reduce this problem of waste and mosquito production.

The aquatic bodies designated as mosquito larval habitats are diverse in size and species composition. The macroinvertebrate predators in these habitats are elements that influence the abundance of mosquito species, providing a basis for biological control. Assessment of species assemblage in these habitats will indicate the possible variations in the resource exploitation and trophic interactions and, therefore, can help to frame biological control strategies more appropriately. In the present study, the species composition is being investigated in five different mosquito larval habitats at a spatial scale. A random sample of 80 each of the habitats, grouped as either small or large, was analyzed in respect to the macroinvertebrate species assemblage. The species composition in the habitats was noted to be an increasing function of habitat size (species number = 1.653 + 0.819 habitat size) and, thus, the diversity. The relative abundance of the mosquito immatures varied with the habitat, and the number of useful predator taxa was higher in the larger habitats. In the smaller habitats-plastic and earthen structures and sewage drains, the relative and absolute number of mosquito immatures per sampling unit were significantly higher than the pond and rice field habitats. This was evident in the cluster analysis where the smaller habitats were more related than the larger habitats. The principal component analysis on the species diversity yielded four and six components, respectively, for the smaller and larger habitats for explaining the observed variance of species abundance. The species composition in the habitats was consistent with the earlier findings and support that the abundance of coexisting macroinvertebrate species regulates the relative load of mosquito immatures in the habitats. The findings of this study may be further tested to deduce the relative importance of the habitats in terms of the productivity of mosquito immatures at a temporal scale.