Abstract. Simulation results of global aerosol models have been assembled in the framework of the AeroCom intercomparison exercise. In this paper, we analyze the life cycles of dust, sea salt, sulfate, black carbon and particulate organic matter as simulated by sixteen global aerosol models. The differences among the results (model diversities) for sources and sinks, burdens, particle sizes, water uptakes, and spatial dispersals have been established. These diversities have large consequences for the calculated radiative forcing and the aerosol concentrations at the surface. Processes and parameters are identified which deserve further research.The AeroCom all-models-average emissions are dominated by the mass of sea salt (SS), followed by dust (DU), sulfate (SO 4 ), particulate organic matter (POM), and finally black carbon (BC). Interactive parameterizations of the emissions and contrasting particles sizes of SS and DU lead genCorrespondence to: C. Textor (christiane.textor@cea.fr) erally to higher diversities of these species, and for total aerosol. The lower diversity of the emissions of the fine aerosols, BC, POM, and SO 4 , is due to the use of similar emission inventories, and does therefore not necessarily indicate a better understanding of their sources. The diversity of SO 4 -sources is mainly caused by the disagreement on depositional loss of precursor gases and on chemical production. The diversities of the emissions are passed on to the burdens, but the latter are also strongly affected by the model-specific treatments of transport and aerosol processes. The burdens of dry masses decrease from largest to smallest: DU, SS, SO 4 , POM, and BC.The all-models-average residence time is shortest for SS with about half a day, followed by SO 4 and DU with four days, and POM and BC with six and seven days, respectively. The wet deposition rate is controlled by the solubility and increases from DU, BC, POM to SO 4 and SS. It is the dominant sink for SO 4 , BC, and POM, and contributes about one third to the total removal of SS and DU species. For SS Published by Copernicus GmbH on behalf of the European Geosciences Union. C. Textor et al.: Diversities of aerosol life cycles within AeroComand DU we find high diversities for the removal rate coefficients and deposition pathways. Models do neither agree on the split between wet and dry deposition, nor on that between sedimentation and other dry deposition processes. We diagnose an extremely high diversity for the uptake of ambient water vapor that influences the particle size and thus the sink rate coefficients. Furthermore, we find little agreement among the model results for the partitioning of wet removal into scavenging by convective and stratiform rain.Large differences exist for aerosol dispersal both in the vertical and in the horizontal direction. In some models, a minimum of total aerosol concentration is simulated at the surface. Aerosol dispersal is most pronounced for SO 4 and BC and lowest for SS. Diversities are higher for meridional than for verti...

Abstract. Inventories for global aerosol and aerosol precursor emissions have been collected (based on published inventories and published simulations), assessed and prepared for the year 2000 (present-day conditions) and for the year 1750 (pre-industrial conditions). These global datasets establish a comprehensive source for emission input to global modeling, when simulating the aerosol impact on climate with state-of-the-art aerosol component modules. As these modules stratify aerosol into dust, sea-salt, sulfate, organic matter and soot, for all these aerosol types global fields on emission strength and recommendations for injection altitude and particulate size are provided. Temporal resolution varies between daily (dust and sea-salt), monthly (wild-land fires) and annual (all other emissions). These datasets benchmark aerosol emissions according to the knowledge in the year 2004. They are intended to serve as systematic constraints in sensitivity studies of the AeroCom initiative, which seeks to quantify (actual) uncertainties in aerosol global modeling.

[1] A parameterization of a sea-salt source function for both sub-and super-micron particles was developed based on the semi-empirical formulation of Monahan et al. [1986]. This new parameterization extends the range of Monahan's equation to below 0.2 mm in diameter where it has been found to overestimate submicron sea-salt aerosols, especially the sea-salt number concentrations. The new parameterization was used in a one-dimensional (1-D) column model to predict the number size distributions and compared with reasonable agreement to the observed distributions at various wind speeds reported by O'Dowd et al. [1997]. A global 3-D sea-salt simulation with this parameterization was also made and a much better dependence of sea-salt on surface wind speed was predicted than other schemes compared to observations. For an indirect impact assessment of sea-salt aerosols on climate where submicron particles may have a dominant contribution to aerosol-cloud interactions, this scheme provides the most realistic number flux of sea-salt particles between ocean and atmosphere.

No abstract

[1] Understanding the surface O 3 response over a ''receptor'' region to emission changes over a foreign ''source'' region is key to evaluating the potential gains from an international approach to abate ozone (O 3 ) pollution. We apply an ensemble of 21 global and hemispheric chemical transport models to estimate the spatial average surface O 3 response over east Asia (EA), Europe (EU), North America (NA), and south Asia (SA) to 20% decreases in anthropogenic emissions of the O 3 precursors, NO x , NMVOC, and CO (individually and combined), from each of these regions. We find that the ensemble mean surface O 3 concentrations in the base case (year 2001) simulation matches available observations throughout the year over EU but overestimates them by >10 ppb during summer and early fall over the eastern United States and Japan. The sum of the O 3 responses to NO x , CO, and NMVOC decreases separately is approximately equal to that from a simultaneous reduction of all precursors. We define a continental-scale ''import sensitivity'' as the ratio of the O 3 response to the 20% reductions in foreign versus 1 ''domestic'' (i.e., over the source region itself) emissions. For example, the combined reduction of emissions from the three foreign regions produces an ensemble spatial mean decrease of 0.6 ppb over EU (0.4 ppb from NA), less than the 0.8 ppb from the reduction of EU emissions, leading to an import sensitivity ratio of 0.7. The ensemble mean surface O 3 response to foreign emissions is largest in spring and late fall (0.7-0.9 ppb decrease in all regions from the combined precursor reductions in the three foreign regions), with import sensitivities ranging from 0.5 to 1.1 (responses to domestic emission reductions are 0.8-1.6 ppb). High O 3 values are much more sensitive to domestic emissions than to foreign emissions, as indicated by lower import sensitivities of 0.2 to 0.3 during July in EA, EU, and NA when O 3 levels are typically highest and by the weaker relative response of annual incidences of daily maximum 8-h average O 3 above 60 ppb to emission reductions in a foreign region (<10-20% of that to domestic) as compared to the annual mean response (up to 50% of that to domestic). Applying the ensemble annual mean results to changes in anthropogenic emissions from 1996 to 2002, we estimate a Northern Hemispheric increase in background surface O 3 of about 0.1 ppb a À1 , at the low end of the 0.1-0.5 ppb a À1 derived from observations. From an additional simulation in which global atmospheric methane was reduced, we infer that 20% reductions in anthropogenic methane emissions from a foreign source region would yield an O 3 response in a receptor region that roughly equals that produced by combined 20% reductions of anthropogenic NO x , NMVOC, and CO emissions from the foreign source region.

Abstract. We evaluate black carbon (BC) model predictions from the AeroCom model intercomparison project by considering the diversity among year 2000 model simulations and comparing model predictions with available measurements. These model-measurement intercomparisons include BC surface and aircraft concentrations, aerosol absorption optical depth (AAOD) retrievals from AERONET and Ozone Monitoring Instrument (OMI) and BC column estimations based on AERONET. In regions other than Asia, most models are biased high compared to surface concentration measurements. However compared with (column) AAOD or BC burden retreivals, the models are generally biased low. The average ratio of model to retrieved AAOD is less than 0.7 in South American and 0.6 in African biomass burning regions; both of these regions lack surface concentration measurements. In Asia the average model to observed ratio is 0.7 for AAOD and 0.5 for BC surface concentrations. Compared with aircraft measurements over the Americas at latitudes between 0 and 50N, the average model is a factor of 8 larger than observed, and most models exceed the measured BC standard deviation in the mid to upper troposphere. At higher latitudes the average model to aircraft BC ratio is 0.4 and models underestimate the observed BC loading in the lower and middle troposphere associated with springtime Arctic haze. Low model bias for AAOD but overestimation of surface and upper atmospheric BC concentrations at lower latitudes suggests that most models are underestimating BC absorption and should improve estimates for refractive index, particle size, and optical effects of BC coating. Retrieval uncertainties and/or differences with model diagnostic treatment may also contribute to the model-measurement disparity. Largest AeroCom model diversity occurred in northern Eurasia and the remote Arctic, regions influenced by anthropogenic sources. Changing emissions, aging, removal, or optical properties within a single model generated a smaller change in model predictions than the range represented by the full set of AeroCom models. Upper tropospheric concentrations of BC mass from the aircraft measurements are suggested to provide a unique new benchmark to test scavenging and vertical dispersion of BC in global models.

This paper evaluates the current status of global modeling of the organic aerosol (OA) in the troposphere and analyzes the differences between models as well as between models and observations. Thirty-one global chemistry transport models (CTMs) and general circulation models (GCMs) have participated in this intercomparison, in the framework of AeroCom phase II. The simulation of OA varies greatly between models in terms of the magnitude of primary emissions, secondary OA (SOA) formation, the number of OA species used (2 to 62), the complexity of OA parameterizations (gas-particle partitioning, chemical aging, multiphase chemistry, aerosol microphysics), and the OA physical, chemical and optical properties. The diversity of the global OA simulation results has increased since earlier AeroCom experiments, mainly due to the increasing complexity of the SOA parameterization in models, and the implementation of new, highly uncertain, OA sources. Diversity of over one order of magnitude exists in the modeled vertical distribution of OA concentrations that deserves a dedicated future study. Furthermore, although the OA/OC ratio depends on OA sources and atmospheric processing, and is important for model evaluation against OA and OC observations, it is resolved only by a few global models. The median global primary OA (POA) source strength is 56 Tg a(-1) (range 34-144 Tg a(-1)) and the median SOA source strength (natural and anthropogenic) is 19 Tg a(-1) (range 13-121 Tg a(-1)). Among the models that take into account the semi-volatile SOA nature, the median source is calculated to be 51 Tg a(-1) (range 16-121 Tg a(-1)), much larger than the median value of the models that calculate SOA in a more simplistic way (19 Tg a(-1); range 13-20 Tg a(-1), with one model at 37 Tg a(-1)). The median atmospheric burden of OA is 1.4 Tg (24 models in the range of 0.6-2.0 Tg and 4 between 2.0 and 3.8 Tg), with a median OA lifetime of 5.4 days (range 3.8-9.6 days). In models that reported both OA and sulfate burdens, the median value of the OA/sulfate burden ratio is calculated to be 0.77; 13 models calculate a ratio lower than 1, and 9 models higher than 1. For 26 models that reported OA deposition fluxes, the median wet removal is 70 Tg a(-1) (range 28-209 Tg a(-1)), which is on average 85% of the total OA deposition. Fine aerosol organic carbon (OC) and OA observations from continuous monitoring networks and individual field campaigns have been used for model evaluation. At urban locations, the model-observation comparison indicates missing knowledge on anthropogenic OA sources, both strength and seasonality. The combined model-measurements analysis suggests the existence of increased OA levels during summer due to biogenic SOA formation over large areas of the USA that can be of the same order of magnitude as the POA, even at urban locations, and contribute to the measured urban seasonal pattern. Global models are able to simulate the high secondary character of OA observed in the atmosphere as a result of SOA formation and POA agi...

[1] A size-segregated multicomponent aerosol algorithm, the Canadian Aerosol Module (CAM), was developed for use with climate and air quality models. It includes major aerosol processes in the atmosphere: generation, hygroscopic growth, coagulation, nucleation, condensation, dry deposition/sedimentation, below-cloud scavenging, aerosol activation, a cloud module with explicit microphysical processes to treat aerosol-cloud interactions and chemical transformation of sulphur species in clear air and in clouds. The numerical solution was optimized to efficiently solve the complicated size-segregated multicomponent aerosol system and make it feasible to be included in global and regional models. An internal mixture is assumed for all types of aerosols except for soil dust and black carbon which are assumed to be externally mixed close to sources. To test the algorithm, emissions to the atmosphere of anthropogenic and natural aerosols are simulated for two aerosol types: sea salt and sulphate. A comparison was made of two numerical solutions of the aerosol algorithm: process splitting and ordinary differential equation (ODE) solver. It was found that the process-splitting method used for this model is within 15% of the more accurate ODE solution for the total sulphate mass concentration and <1% accurate for sea-salt concentration. Furthermore, it is computationally more than 100 times faster. The sensitivity of the simulated size distributions to the number of size bins was also investigated. The diffusional behavior of each individual process was quantitatively characterized by the difference in the mode radius and standard deviation of a lognormal curve fit of distributions between the approximate solution and the 96-bin reference solution. Both the number and mass size distributions were adequately predicted by a sectional model of 12 bins in many situations in the atmosphere where the sink for condensable matter on existing aerosol surface area is high enough that nucleation of new particles is negligible. Total mass concentration was adequately simulated using lower size resolution of 8 bins. However, to properly resolve nucleation mode size distributions and minimize the numerical diffusion, a sectional model of 18 size bins or greater is needed. The number of size bins is more important in resolving the nucleation mode peaks than in reducing the diffusional behavior of aerosol processes. Application of CAM in a study of the global cycling of sea-salt mass accompanies this paper [Gong et al., 2002].