High-Mn lightweight steel, Fe-0.9C-29Mn-8Al, was manufactured using steelmaking, ingot-making, forging, and rolling processes. After the final rolling process, a typical austenite single phase was observed on all sides of the thick plate. The microstructural changes after annealing and aging heat-treatments were observed, using optical and transmission electron microscopy. The annealed coupon exhibited a typical austenite single phase, including annealing twins in several grains; the average grain size was 153 μm. After aging heat treatment, κ-carbide was observed within the grains and on the grain boundaries. Additionally, the effect of aging heat treatment on the mechanical properties was analyzed, using a tensile test. The fine κ-carbide that precipitated within the grains in the aged coupon improved the 0.2% offset yield and the tensile stresses, as compared to the as-annealed coupon. To estimate the applicability of high-Mn lightweight steel for low-pressure (LP) steam turbine blades, a low-cycle fatigue (LCF) test was carried out at room temperature. At a total strain amplitude of 0.5 to 1.2%, the LCF life of high-Mn lightweight steel was approximately three times that of 12% Cr steel, which is used in commercial LP steam turbine blades. The LCF behavior of high-Mn lightweight steel followed the Coffin–Manson equation. The LCF life enhancement in the high-Mn lightweight steel results from the planar dislocation gliding behavior.
Z-type hexagonal ferrites have recently received attention for their room-temperature magnetoelectric (ME), which is activated when the temperature at which the transverse-conical spin-state transitions to a ferrimagnetic state is increased. The changes in the magnetic domain structure at the transition have been well-documented; however, they are still not understood in detail. In the present study, Lorentz transmission electron microscopy (TEM) analysis combined with an in situ heating experiment was conducted to demonstrate the shift in magnetic domain structure during the transition from the transverse-conical spin arrangement to a ferrimagnetic spin order. The dynamics of the magnetic domain structure changes with the increasing temperature were acquired in real-time. At 490 K, the magnetization transition from the transverse-conical spin state to the ferromagnetic state was demonstrated. Cross-tie domain walls formed during the magnetic transition process. The increased effect of the demagnetizing field applied to the 180° magnetic domains was caused by a lower magnetocrystalline anisotropy (MCA) at the easy axis of magnetization.
Real-time structural changes in Na-β″-alumina were observed in situ using transmission electron microscopy (TEM) with electron beam irradiation. Na-β″-alumina has been widely investigated as a solid electrolyte material for sodium–sulfur secondary batteries owing to its high ionic conductivity. This high conductivity is known to be due to the Na+ ions on the loosely packed conduction planes of Na-β″-alumina. In the present study, we acquired real-time videos of the generation of spinel blocks caused by the conduction of Na+ ions. In addition, by observing Na extraction during electron beam irradiation, we experimentally confirmed that spinel block generation originates from the Na+ ion conduction, which has been a subject of recent debate.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.