In this paper, a comparative study is done on the time and frequency domain tuning strategies for fractional order (FO) PID controllers to handle higher order processes. A new fractional order template for reduced parameter modelling of stable minimum/non-minimum phase higher order processes is introduced and its advantage in frequency domain tuning of FOPID controllers is also presented. The time domain optimal tuning of FOPID controllers have also been carried out to handle these higher order processes by performing optimization with various integral performance indices. The paper highlights on the practical control system implementation issues like flexibility of online autotuning, reduced control signal and actuator size, capability of measurement noise filtration, load disturbance suppression, robustness against parameter uncertainties etc. in light of the above tuning methodologies.

We present evidence of extreme events in two Hindmarsh-Rose (HR) bursting neurons mutually interacting via two different coupling configurations: chemical synaptic- and gap junctional-type diffusive coupling. A dragon-king-like probability distribution of the extreme events is seen for combinations of synaptic coupling where small- to medium-size events obey a power law and the larger events that cross an extreme limit are outliers. The extreme events originate due to instability in antiphase synchronization of the coupled systems via two different routes, intermittency and quasiperiodicity routes to complex dynamics for purely excitatory and inhibitory chemical synaptic coupling, respectively. For a mixed type of inhibitory and excitatory chemical synaptic interactions, the intermittency route to extreme events is only seen. Extreme events with our suggested distribution is also seen for gap junctional-type diffusive, but repulsive, coupling where the intermittency route to complexity is found. A simple electronic experiment using two diffusively coupled analog circuits of the HR neuron model, but interacting in a repulsive way, confirms occurrence of the dragon-king-like extreme events.

Phase shaping using fractional order (FO) phase shapers has been proposed by many contemporary researchers as a means of producing systems with iso-damped closed loop response due to a stepped variation in input. Such systems, with the closed loop damping remaining invariant to gain changes can be used to produce dead-beat step response with only rise time varying with gain. This technique is used to achieve an active step-back in a Pressurized Heavy Water Reactor (PHWR) where it is desired to change the reactor power to a pre-determined value within a short interval keeping the power undershoot as low as possible. This paper puts forward an approach as an alternative for the present day practice of a passive step-back mechanism where the control rods are allowed to drop during a step-back action by gravity, with release of electromagnetic clutches. The reactor under a step-back condition is identified as a system using practical test data and a suitable Proportional plus Integral plus Derivative (PID) controller is designed for it. Then the combined plant is augmented with a phase shaper to achieve a dead-beat response in terms of power drop. The fact that the identified static gain of the system depends on the initial power level at which a step-back is initiated, makes this application particularly suited for using a FO phase shaper. In this paper, a model of a nuclear reactor is developed for a control rod drop scenario involving rapid power reduction in a 500MWe Canadian Deuterium Uranium (CANDU) reactor using AutoRegressive Exogenous (ARX) algorithm. The system identification and reduced order modeling are developed from practical test data. For closed loop active control of the identified reactor model, the fractional order phase shaper along with a PID controller is shown to perform better than the present Reactor Regulating System (RRS) due to its iso-damped nature.

ABSTRACT:A novel conformal mapping based Fractional Order (FO) methodology is developed in this paper for tuning existing classical (Integer Order) Proportional Integral Derivative (PID) controllers especially for sluggish and oscillatory second order systems.