Up to 36 months of follow-up, soft tissue parameters and crestal bone levels can remain equally stable around dental implants placed at crestal and subcrestal levels. The need for long-term follow-up clinical trials is also emphasized.

The results of this survey showed an acceptable level of awareness about dental implants among a selected sample of dental patients in Riyadh. It also showed the need for providing more general and accurate information to the patients about this treatment modality.

Indexed publications contain a variety of terms used by authors to describe diameter and length of dental implants without conformity and standardization. The classification scheme proposed in this article could serve as a reference for interested parties.

There are no studies that have compared the clinical and radiographic status around immediately loaded (IL) and conventional loaded (CL) implants placed in patients with type 2 diabetes mellitus (T2DM). The aim was to compare the clinical and radiographic status around IL and CL implants placed in T2DM patients. One hundred and eight diabetic patients [55 with IL implants (Group 1) and 53 with CL implants (Group 2)] were included in this cross-sectional study. All implants were placed in healed sites in the maxillary and mandibular premolar and molar regions and supported single restorations. All patients underwent full mouth mechanical debridement biannually. Haemoglobin A1c (HbA1c) levels, clinical [bleeding on probing (BOP) and probing depth (PD) ≥ 4 mm] and radiographic [crestal bone loss (CBL)] peri-implant parameters were measured for both groups at 12- and 24-month follow-up. Group comparisons were performed using the Mann-Whitney U-test (P < 0·05). The mean age and duration of T2DM in groups 1 and 2 were 50·6 ± 2·2 and 51·8 ± 1·7 years, and 9·2 ± 2·4 and 8·5 ± 0·4 years, respectively. At 12- and 24-month follow-up, the mean HbA1c levels in groups 1 and 2 were 5·4% (4·8-5·5%) and 5·1% (4·7-5·4%) and 5·1% (4·7-5·2%) and 4·9% (4·5-5·2%), respectively. At 12- and 24-month follow-up, there was no statistically significant difference in peri-implant BOP, PD and CBL in both groups. It was concluded that clinical and radiographic status is comparable around IL and CL implants placed in patients with T2DM. The contribution of careful case selection, oral hygiene maintenance and glycaemic control is emphasised.

Calcium phosphate (CaP) ceramic coatings have been used to enhance the biocompatibility and osteoconductive properties of metallic implants. The chemical composition of these ceramic coatings is an important parameter, which can influence the final bone performance of the implant. In this study, the effect of phase composition of CaP-sputtered coatings was investigated on in vitro dissolution behavior and in vivo bone response. Coatings were prepared by a radio frequency (RF) magnetron sputtering technique; three types of CaP target materials were used to obtain coatings with different stoichiometry and calcium to phosphate ratios (hydroxyapatite (HA), α-tricalciumphosphate (α-TCP), and tetracalciumphosphate (TTCP)) were compared with non-coated titanium controls. The applied ceramic coatings were characterized by X-ray diffraction, Fourier transform infrared spectroscopy, scanning electron microscopy, and inductively coupled plasma optical emission spectroscopy. The in vitro dissolution/precipitation of the CaP coatings was evaluated using immersion tests in simulated body fluid (SBF). To mimic the in vivo situation, identical CaP coatings were also evaluated in a femoral condyle rabbit model. TCPH and TTCPH showed morphological changes during 4-week immersion in SBF. The results of bone implant contact (BIC) and peri-implant bone volume (BV) showed a similar response for all experimental coatings. An apparent increase in tartrate resistant acid phosphatase (TRAP) positive staining was observed in the peri-implant region with decreasing coating stability. In conclusion, the experimental groups showed different coating properties when tested in vitro and an apparent increase in bone remodeling with increasing coating dissolution in vivo.

The aim was to investigate in vitro the fracture resistance (FR) of endodontically treated teeth (ETT) with conservative access cavity restored using various direct and indirect restorative materials and techniques. Seventy-two mandibular first molars were equally divided into six groups. Teeth in Group 1 were untreated (controls). In Groups 2, 3, 4, 5 and 6, teeth were restored with amalgam, composite resin, ceramic inlay, ceramic onlay and zirconium crown, respectively. A fracture test was performed on all teeth using a static load. Compared with other groups, teeth in Groups 3 (P < 0.05) and 6 (P < 0.05) had the highest FR values with no significant difference in-between them. Teeth in Group 4 had the lowest FR than other groups (P < 0.05). All restorative techniques tested led to a significant reduction in FR. It is necessary to consider type of fracture when evaluating fracture resistance of endodontically treated teeth. Crowned molars had the highest favourable fractures among the five treatment groups. Although the results of this in vitro study showed variations between tested techniques in ETT with a conservative access cavity, further long-term controlled clinical trials are required to confirm these in vitro findings.

Short implants can demonstrate clinical and radiographic stability in a manner similar to conventional long implants in patients with and without T2DM. The role of oral hygiene and glycemic maintenance in this scenario cannot be disregarded.

Learning fine motor skills is a pre-requisite for succeeding in dental practice and it is sometimes challenging for dental students. Most of the methods used in the selection process depend on evaluation of intellectual ability or structured interview while manual competence is not. However, no test on aptitude or manual dexterity is used as criteria. Objective:The purpose of the present study intended to evaluate the fine motor skills of beginning dental students which could in turn be used as a method of selection of students for the dental degree admission process. Materials and methods:A study was conducted among 71 second year dental students at College of Dentistry, King Saud University in Riyadh. A test composed of three parts, writing an answer for a question in four lines, drawing a picture of a smile and doing a class 1 amalgam preparation on a plastic molar tooth. The students were evaluated based on their handwriting, basic drawing skills and their skills in performing the tooth preparation by experts in each fields following certain criteria. Results:The results showed a significant correlation between writing and drawing skills and dental skills of the student with p < 0.001. Conclusions:The results of the current study support the use of the writing or drawing test as one of the test used for the applicants for dental school admission. However, the value given to such test in the selection of students needs further investigations and consensus.