Management of nitrogen (N) is a challenging task and several methods individually and in combination are in use to manage its efficiency. However, nitrogen use efficiency (NUE) has not been improved to a level, only 33%, as predicted by the researchers while developing nitrogen management tools and methods. The primary objective of this review article is to evaluate methods and tools available to manage nitrogen. Several methods, soil testing, plant tissue testing, spectral response, fertilizer placement and timing and vegetative indexes (leaf area index, and NDVI) through drones, handheld sensors, and satellite imagery were reviewed on the subject of user-friendly and effectiveness towards NUE. No single method was found sufficient to counter the nitrogen loss. Some methods were found time consuming and unsynchronized with N uptake behavior of particular crop, for example, plant tissue testing. Use of precision agriculture tools, such as GreenSeeker, Holland Crop Circle, drone, and satellite imagery, were found better compared to conventional methods such as soil testing, but these tools can only be used when the crop is up. Therefore, N management is possible only through inseason N application methods. When 70% of the applied nitrogen is used by the crops within 25-30 days after planting, for example, corn and potatoes, it is required to apply major N rates through inseason approach and some N at planting using soil test reports. In conclusion, this article strongly advocates using two or more methods in combination when managing N.

In Maine, potato yield is consistent, 38 t·ha−1, for last 10 years except 2016 (44 t·ha−1) which confirms that increasing the yield and quality of potatoes with current fertilization practices is difficult; hence, new or improvised agronomic methods are needed to meet with producers and industry requirements. Normalized difference vegetative index (NDVI) sensors have shown promise in regulating N as an in season application; however, using late N may stretch out the maturation stage. The purpose of the research was to test Trimble GreenSeeker® (TGS) and Holland Scientific Crop Circle™ ACS-430 (HCCACS-430) wavebands to predict potato yield, before the second hilling (6–8 leaf stage). Ammonium sulfate, S containing N fertilizer, is not advised to be applied on acidic soils but accounts for 60–70% fertilizer in Maine’s acidic soils; therefore, sensors are used on sulfur deficient site to produce sensor-bound S application guidelines before recommending non-S-bearing N sources. Two study sites investigated for this research include an S deficient site and a regular spot with two kinds of soils. Six N treatments, with both calcium ammonium nitrate and ammonium nitrate, under a randomized complete block design with four replications, were applied at planting. NDVI readings from both sensors were obtained at V8 leaf stages (8 leaf per plant) before the second hilling. Both sensors predict N and S deficiencies with a strong interaction with an average coefficient of correlation (r2) ~45. However, HCCACS-430 was observed to be more virtuous than TGS. The correlation between NDVI (from both sensors) and the potato yield improved using proprietor-proxy leaf area index (PPLAI) from HCCACS-430, e.g., r2 value of TGS at Easton site improve from 48 to 60. Weather data affected marketable potato yield (MPY) significantly from south to north in Maine, especially precipitation variations that could be employed in the N recommendations at planting and in season application. This case study addresses a substantial need to revise potato N recommendations at planting and develop possible in season N recommendation using ground based active optical (GBAO) sensors.

Nitrogen (N) and phosphorus (P) are the most important nutrients for crop production. The N contributes to the structural component, generic, and metabolic compounds in a plant cell. N is mainly an essential part of chlorophyll, the compound in the plants that is responsible for photosynthesis process. The plant can get its available nitrogen from the soil by mineralizing organic materials, fixed-N by bacteria, and nitrogen can be released from plant as residue decay. Soil minerals do not release an enough amount of nitrogen to support plant; therefore, fertilizing is necessary for high production. Phosphorous contributes in the complex of the nucleic acid structure of plants. The nucleic acid is essential in protein synthesis regulation; therefore, P is important in cell division and development of new plant tissue. P is one of the 17 essential nutrients for plant growth and related to complex energy transformations in the plant. In the past, growth in production and productivity of crops relied heavily on high-dose application of N and P fertilizers. However, continue adding those chemical fertilizers over time has bad results in diminishing returns regarding no improvement in crop productivity. Applying high doses of chemical fertilizers is a major factor in the climate change in terms of nitrous oxide gas as one of the greenhouse gas and eutrophication that happens because of P pollution in water streams. This chapter speaks about N and P use efficiency and how they are necessary for plant and environment.

Crop yield prediction is a critical measurement, especially in the time when parts of the world are suffering from farming issues. Yield forecasting gives an alert regarding economic trading, food production monitoring, and global food security. This research was conducted to investigate whether active optical sensors could be utilized for potato (Solanum tuberosum L.) yield prediction at the mid.le of the growing season. Three potato cultivars (Russet Burbank, Superior, and Shepody) were planted and six rates of N (0, 56, 112, 168, 224, and 280 kg ha−1), ammonium sulfate, which was replaced by ammonium nitrate in the 2nd year, were applied on 11 sites in a randomized complete block design, with four replications. Normalized difference vegetation index (NDVI) and chlorophyll index (CI) measurements were obtained weekly from the active optical sensors, GreenSeeker (GS) and Crop Circle (CC). The 168 kg N ha−1 produced the maximum potato yield. Indices measurements obtained at the 16th and 20th leaf growth stages were significantly correlated with tuber yield. Multiple regression analysis (potato yield as a dependent variable and vegetation indices, NDVI and CI, as independent variables) could make a remarkable improvement to the accuracy of the prediction model and increase the determination coefficient. The exponential and linear models showed a better fit of the data. Soil organic matter content increased the yield significantly but did not affect the prediction models. The 18th and 20th leaf growth stages are the best time to use the sensors for yield prediction.

Phosphorus (P) is an element that is potatoes require in large amounts. Soil pH is a crucial factor impacting phosphorus availability in potato production. This study was conducted to evaluate the influence of P application rates on the P efficiency for tuber yield, specific gravity, and P uptake. Additionally, the relationship between soil pH and total potato tuber yield was determined. Six rates of P fertilization (0–280 kg P ha−1) were applied at twelve different sites across Northern Maine. Yield parameters were not responsive to P application rates. However, regression analysis showed that soil pH was significantly correlated with total potato tuber yield(R2 = 0.38). Sites with soil pH values < 6 had total tuber yields, marketable tuber yields, tuber numbers per plant, and total tuber mean weights that were all higher than these same parameters at sites with soil pH ≥ 6. All sites with soil pH< 6 showed a highly correlated relationship between P uptake and petiole dry weight (R2 = 0.76). The P application rate of 56 kg P ha−1 was the best at sites with a soil pH < 6, but 0–56 kg P ha−1 was the best at sites with soil pH ≥ 6.

Recent phosphorus (P) pollution in the United States, mainly in Maine, has raised some severe concerns over the use of P fertilizer application rates in agriculture. Phosphorus is the second most limiting nutrient after nitrogen and has damaging impacts on crop yield if found to be deficient. Therefore, farmers tend to apply more P than is required to satisfy any P loss after its application at planting. Several important questions were raised in this study to improve P efficiency and reduce its pollution. The objective of this study was to find potential reasons for P pollution in water bodies despite a decrease in potato acreage. Historically, the potato was found to be responsible for P water contamination due to its high P sensitivity and low P removal (25-30 kg ha −1 ) from the soil. Despite University of Maine recommended rate of 56 kg ha −1 P, if soil tests reveal that P is below 50 kg ha −1 , growers tend to apply P fertilizer at the rate of 182 kg ha −1 to compensate for any loss. The second key reason for excessive P application is its tendency to get fixed by aluminum (Al) in the soil. Soil sampling data from UMaine Soil Testing Laboratory confirmed that in Maine reactive Al levels have remained high over the last ten years and are increasing further. Likewise, P application to non-responsive sites, soil variability, pH change, and soil testing methods were found to be other possible reasons that might have led to increases in soil P levels resulting in P erosion to water streams.

Undesirable growth of potato (Solanum tuberosum L.) crop under an excessive N fertilizer application is the main obstacle presently. This research was conducted to investigate the response of different potato cultivars; Russet Burbank, Shepody, and Superior, and its qualitative characteristics under a series of N rates. Six rates of N fertilization (0–280 kg ha−1) were applied on 11 sites in a randomized complete block design, with four replications. Sites with ≥30 g kg−1 of soil organic matter (OM) produced total tuber yield, marketable yield, and tuber weight per plant 39.5, 45.2, and 54.9%, respectively, higher than sites with ≤30 g kg−1 of OM. Tubers specific gravity increased by 0.18% in the sites with ≥30 g kg−1 of OM. The total tuber yield for the three cultivars was maximized at 168 kg N ha−1. Marketable specific gravity, starch, and dry matter content were achieved by applying 168 and 112 kg N ha−1 at ≤30 and ≥30 g kg−1 of OM sites, respectively. Russet Burbank produced a higher yield than Shepody and Superior cultivars significantly, but there was no significant difference among them regarding specific gravity. Excessive N application (>168 kg ha−1) decreased potato tuber production and quality.

Ground-based active optical sensors (GBAOS) have been successfully used in agriculture to predict crop yield potential (YP) early in the season and to improvise N rates for optimal crop yield. However, the models were found weak or inconsistent due to environmental variation especially rainfall. The objectives of the study were to evaluate if GBAOS could predict YP across multiple locations, soil types, cultivation systems, and rainfall differences. This study was carried from 2011 to 2013 on corn (Zea mays L.) in North Dakota, and in 2017 in potatoes in Maine. Six N rates were used on 50 sites in North Dakota and 12 N rates on two sites, one dryland and one irrigated, in Maine. Two active GBAOS used for this study were GreenSeeker and Holland Scientific Crop Circle Sensor ACS 470 (HSCCACS-470) and 430 (HSCCACS-430). Rainfall data, with or without including crop height, improved the YP models in term of reliability and consistency. The polynomial model was relatively better compared to the exponential model. A significant difference in the relationship between sensor reading multiplied by rainfall data and crop yield was observed in terms of soil type, clay and medium textured, and cultivation system, conventional and no-till, respectively, in the North Dakota corn study. The two potato sites in Maine, irrigated and dryland, performed differently in terms of total yield and rainfall data helped to improve sensor YP models. In conclusion, this study strongly advocates the use of rainfall data while using sensorbased N calculator algorithms.