Abstract:The aim of this study was to investigate the optimal temperature range for waste wood and the effect torrefaction residence time had on torrefied biomass feedstock. Temperature range of 200-400 • C and residence time of 0-50 min were considered. In order to investigate the effect of temperature and residence time, torrefaction parameters, such as mass yield, energy yield, volatile matter, ash content and calorific value were calculated. The Van Krevelen diagram was also used for clarification, along with the CHO index based on molecular C, H, and O data. Torrefaction parameters, such as net/gross calorific value and CHO increased with an increase in torrefaction temperature, while a reduction in energy yield, mass yield, and volatile content were observed. Likewise, elevated ash content was observed with higher torrefaction temperature. From the Van Krevelen diagram, it was observed that at 300 • C the torrefied feedstock came in the range of lignite. With better gross calorific value and CHO index, less ash content and nominal mass loss, 300 • C was found to be the optimal torrefaction temperature for waste wood.

Thermal pre-treatment of non-lignocellulosic biomass, sewage sludge, using a lab-scale fluidized bed reactor was carried out in order to enhance its solid fuel properties. The influence of the torrefaction temperature range from 200-350 • C and 0-50 min residence time on the physical and chemical properties of the torrefied product was investigated. Properties of the torrefied product were analyzed on the basis of the degree of torrefaction, ultimate and proximate analysis, and gas analysis. An attempt was made to obtain the chemical exergy of sewage sludge. An elevated torrefaction temperature presented a beneficial impact on the degree of torrefaction and chemical exergy. Moreover, the effect of the torrefaction temperature and residence time on the elemental variation of sewage sludge exhibited an increase in the weight percentage of carbon while the H/C and O/C molar ratios deteriorated. Additionally, the product gas emitted during torrefaction was analyzed to study the pathway of hydrocarbons and oxygen containing compounds. The compounds with oxygen were emitted at higher temperatures in contrast to hydrocarbon gases. In addition, the study of various correlations for predicting the calorific value of torrefied sewage sludge was made.

Abstract:Comparative analysis of transesterification of virgin cooking oil (VCO) and waste cooking oil (WCO) in catalyzed and supercritical transesterification process using methanol and ethanol as solvents has been conducted in this study. The luminous point of this research was the direct comparison of catalytic and supercritical process using the ester composition obtained from virgin cooking oil and waste cooking oil transesterification. Oil to alcohol molar ratio of 1:6 and reaction condition of 65 • C and 1 bar pressure were considered for the catalytic process, while 260 • C and high pressure (65 and 75 bar for methanol and ethanol, respectively) were accounted for the supercritical process. Distinct layer separation was observed for both processes. Ester, fatty acid and glycerol composition was studied for both the upper and lower layers separately, from which 100% ester composition in the upper layer and a mixture of ester and other composition in the lower layer was obtained for the catalytic process owing to succeeding filtration and washing. However, mixture of ester (>75%) and other composition was obtained in both layers for the supercritical process where purification process was not implemented. The similarity in the result obtained demonstrates the superiority of waste cooking oil compared to virgin cooking oil, taking cost into consideration.

Transesterification of waste vegetable oil is one of the promising partial substitutes for fossil fuels. The degradation characteristics of waste vegetable oil using supercritical alcohols (ethanol and methanol) have been studied in this research. The elementary target was to conduct comparative analysis of the effect of supercritical methanol and supercritical ethanol as solvents on the transesterification along with the analysis of product obtained in terms of carbon number. The experiments were carried out at transesterification temperatures of 250, 270 and 290 • C, retention time of 0 to 60 min at an interval of 15 min and oil to alcohol molar ratios of 1:6, 1:12 and 1:18 for both alcohols. The conversion increased with increase in transesterification temperature and retention time. At 290 • C, almost 99% conversion was achieved for 60-min holding time for both alcohols. Increase in conversion of waste vegetable oil was observed as the molar ratio increased. Supercritical transesterification resulted into ester yield higher than 95% with non-ester composition and glycerol collectively less than 5%.

No abstract