The characterisation of the cooking oils presents a significant challenge due to minor changes in their dielectric behaviour. In this paper, a new metamaterial-based sensor incorporating a split-ring resonator (SRR) with a microstrip transmission line is presented to characterise cooking oils. The design demonstrates metamaterial characteristics of negative permittivity and permeability simultaneously at the resonance frequency. Furthermore, its operation in the range of millimetre-wave frequencies can further enhance its sensitivity, especially for liquid materials. The sensor’s novelty is the operation at millimetre-wave frequencies that offers a high shift in the transmission coefficient while operating at 30 GHz. The sensor’s performance analysis is undertaken by using six MUTs with dielectric constants ranging from 0.126 to 4.47. The presented structure designed on 12 × 8 mm2 Rogers substrate offers a sensitivity of 1.12 GHz per unit change in dielectric constant. The phase's shift demonstrates a lower percentage error than the amplitude and linearly moves towards higher frequencies with the increase in dielectric constant and tangent loss of MUT. The designed sensor can be prominently useful for detecting liquids' chemical characteristics in chemistry and medicine fields.

No abstract

Millimetre-wave frequencies are promising for sensitive detection of glucose levels in the blood, where the temperature effect is insignificant. All these features provide the feasibility of continuous, portable, and accurate monitoring of glucose levels. This paper presents a metamaterial-inspired resonator comprising five split-rings to detect glucose levels at 24.9 GHz. The plexiglass case containing blood is modelled on the sensor’s surface and the structure is simulated for the glucose levels in blood from 50 mg/dl to 120 mg/dl. The novelty of the sensor is demonstrated by the capability to sense the normal glucose levels at millimetre-wave frequencies. The dielectric characteristics of the blood are modelled by using the Debye parameters. The proposed design can detect small changes in the dielectric properties of blood caused by varying glucose levels. The variation in the transmission coefficient for each glucose level tested in this study is determined by the quality factor and resonant frequency. The sensor presented can detect the change in the quality factor of transmission response up to 2.71/mg/dl. The sensor’s performance has also been tested to detect diabetic hyperosmolar syndrome. The sensor showed a linear shift in resonant frequency with the change in glucose levels, and an R2 of 0.9976 was obtained by applying regression analysis. Thus, the sensor can be used to monitor glucose in a normal range as well as at extreme levels.

No abstract

This paper discusses a new sensing technique for detecting ethanol concentration in aqueous solutions rapidly based on electromagnetic resonance. The sensor consists of two substrate layers and operates at 5G millimetre-wave frequencies (5G mm-wave). An experimental study of the new resonator's con guration is undertaken in determining the sensor's sensitivity. During the measurements, 6 samples were modelled with varying amounts of ethanol concentration in the water. The results showed that S 11 resonance moves linearly towards higher frequencies as the ethanol content increases. The resonance shifted by 178 MHz for every 10% increase in ethanol. As a result, the proposed 5G mm-Wave sensing technique based on a replaceable sensing layer proves to be suitable for rapid, accurate, and low-cost alcohol content detection in liquids.