The paper reports a preliminary study of the behavior of a high performance controlledclearance piston gauge (CCPG) in the pressure range up to 1 GPa through finite elemental analysis (FEA). The details of the experimental characterization of this CCPG has already been published (Yadav et al.. 2007 [1]). We have already pointed out that the use of Heydemann-Welch (HW) model for the characterization of any CCPG. has some limitation due to the fact that the linear extrapolation of the cube root of the fall rate versus jacket pressure (vl/ 3 _Pj) curve is assumed to be independent of the rheological properties of the pressure transmitting fluids. The FEA technique addresses this problem through simulation and optimization with a standard ANSYS program where the material properties of the piston and cylinder. pressure dependent density and viscosity of the pressure transmitting fluid etc. are to be used as the input parameters. Thus it provides characterization of a pressure balance in terms of effective area and distortion coefficient of the piston and cylinder. The present paper describes the results obtained on systematic studies carried out on the effect of gap profile between piston and cylinder of this controlled-clearance piston gauge, under the influence of applied pressure (p) from 100 MPa to 1000 MPa, on the pressure distortion coefficient U) of the assembly. The gap profile is also studied at different applied jacket pressure (Pj) such that pjp varied from 0.3, 0.4 and 0.5.
This paper reports the behavior of a well-characterized pneumatic piston gauge in the pressure range up to 8 MPa through simulation using finite element method (FEM). Experimentally, the effective area of this piston gauge has been estimated by cross-floating to obtain A 0 and λ. The FEM technique addresses this problem through simulation and optimization with standard commercial software (ANSYS) where the material properties of the piston and cylinder, dimensional measurements, etc are used as the input parameters. The simulation provides the effective area A p as a function of pressure in the free deformation mode. From these data, one can estimate A p versus pressure and thereby A o and λ. Further, we have carried out a similar theoretical calculation of A p using the conventional method involving the Dadson's as well as Johnson-Newhall equations. A comparison of these results with the experimental results has been carried out.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.