This paper presents a pioneering effort to ascertain the suitability of hyperelastic modelling in simulating the stress–strain response of oil palm shell reinforced rubber (ROPS) composites. ROPS composites with different oil palm shell contents (0%, 5%, 10% and 20% by volume) were cast in the laboratory for the experimental investigation. ROPS specimens with circular, square, hexagon, and octagon shapes (loading surface) were considered to evaluate the accuracy of finite element simulation considering the shape effect of composites. Strain-controlled (compressive) tests with ε ≈ 50% at 0.8 Hz frequency were conducted in the laboratory and the test data obtained was used as input to simulate material coefficients corresponding to the strain energy functions chosen. Five different strain energy functions were selected and utilized for the hyperelastic modelling in this study using finite element approach. The shape effect was then used to ascertain any variation in the simulation outcomes and to discuss the effect of shape on the behaviour of ROPS composites in comparison to existing literature. The numerical predictions using the Yeoh model (error ≤ 2.7% for circular shaped ROPS) were found to perform best in comparison with the experimental results, thus a more stable and suitable hyperelastic model to this end. The Marlow (error ≤ 4.6% for circular shaped ROPS) and Arruda Boyce (error ≤ 4.7% for circular shaped ROPS) models were amongst the next alternatives to perform better. Even with the other shapes considered in this study, Yeoh, followed by the Marlow function, were more appropriate models. The shape effect was then studied with particular emphasis on comparing and assessing them with that observed in the literature. To this end, adopting the Yeoh function in the finite element model is the ideal approach to estimate the stress–strain response of ROPS composites.

No abstract

No abstract

No abstract

This paper presents an attempt to evaluate the suitability of oil palm shell (OPS) and rubberized OPS (ROPS), an alternative bio-material, as reinforcement in kaolin. OPS was surface coated with rubber, and its water absorption potential was studied in 5 media involving water and kaolin samples (with different water contents). The water absorption data measured in the laboratory was used as an indirect measure to verify the degradability of ROPS samples when used as reinforcements in kaolin. The surface treatment of OPS with rubber was found to perform well, with around a fivefold decrease in water absorption, thus making it an ideal treatment procedure to this end. Kaolin-ROPS mixtures with different OPS and ROPS proportions (0, 5%, 10%, 20%, and 30% by weight) were prepared in laboratory to evaluate their compaction behaviors. Both standard proctor compaction and mini-compaction procedures were adopted in this study to ensure applicability of the findings across a wide range of compaction methods adopted in the laboratory. Compaction curves obtained for both kaolin-OPS and kaolin-ROPS mixes showed a decreasing trend in the maximum dry density values with increasing proportions of OPS and ROPS. Optimum water content of kaolin-OPS mixtures did not show a significant variation, while kaolin-ROPS mixture showed a downward trend with increasing ROPS contents, thereby signifying improvement in the compaction characteristics after OPS reinforcement in kaolin.