No abstract

We report the effects of ions on rupture and lifetime of aqueous foam films formed from sodium chloride (NaCl), lithium chloride (LiCl), sodium acetate (NaAc), and sodium chlorate (NaClO 3) using microinterferometry. In the case of NaCl and LiCl, the foam films prepared from the salt solutions below 0.1 M were unstable they thinned until rupturing. The film lifetime measured from the first interferogram (appearing at a film thickness on the order of 500 nm) until the film rupture was only a second or so. However, relatively long lasting and nondraining films prepared from salt solutions above 0.1 M were observed. The film lifetime was significantly longer by 1 to 2 orders of magnitude, i.e., from 10 to 100 s. Importantly, both the film lifetime and the (average) thickness of the nondraining films increased with increasing salt concentration. This effect has not been observed with foam films stabilized by surfactants. The film lifetime and thickness also increased with increasing film radius. The films exhibited significant surface corrugations. The films with large radii often contained standing dimples. There was a critical film radius below which the films thinned until rupturing. In the cases of NaAc and NaClO 3, the films were unstable at all radii and salt concentrations they thinned until rupturing, ruling out the effect of solution viscosity on stabilizing the films.

No abstract

No abstract

No abstract

No abstract

This review focuses on recent works on foam drainage + including both the advanced theoretical and experimental studies into foam drainage, standard and extended drainage theories with analytical and numerical solutions. Highlights of recent works include the effect of physico-chemical properties of the gas-liquid interface on foam drainage, and the foam-structure related properties governing the channel-and node-dominated drainage regimes. Important results obtained using the foam pressure drop technique which allows a systematic investigation of foam drainage with the constant and varying Plateau border radius are discussed. The free and forced drainage methods have also been the useful experimental techniques for revealing two important drainage regimes by the channels and the nodes. Finally, the influence of the syneresis on the foam stability and destruction is reviewed.

Breaking point: Switchable peptide surfactants are used to demonstrate that the extent of cross-linking in an interfacial surfactant layer can control the rate of emulsion coalescence. Pictured is the rupture of an aqueous thin film where the peptide layer lacks sufficient strength to prevent hole formation, but nonetheless dramatically slows the rate of hole expansion.