Disposal of massive amounts of eggshells and seashells from processing industries is a challenge. In recent years, there has been a focus to reuse these waste resources in the production of new thermoplastic and thermoset polymer materials. This paper reviews eggshell and seashell production by country and provides a perspective on the quantity of bio-calcium carbonate that could be produced annually from these wastes. The achievements obtained from the addition of recycled bio-calcium carbonate fillers (uncoated/unmodified) in polymer composites with a focus on tensile strength, flexural strength and impact toughness are discussed. To improve compatibility between calcium carbonate (mineral and bio-based) fillers and polymers, studies on surface modifiers are reviewed. Knowledge gaps and future research and development thoughts are outlined. Developing novel and innovative composites for this waste material could bring additional revenue to egg and seafood processors and at the same time reduce any environmental impact.

In this study, an innovative composite was fabricated in which the matrix is partially derived from natural sources and the filler from undervalued eggshell waste material. The effect of coating eggshells and mineral limestone with 2 wt.% stearic acid on the mechanical properties of a bio-epoxy matrix was investigated. Eggshells and limestone (untreated and stearic acid-treated) fillers were added to the bio-epoxy matrix in quantities of 5, 10, and 20 wt.% loadings using a solution mixing technique. The CaCO3 content in eggshells was confirmed to be 88 wt.%, and the crystalline phase was found to be calcite. The stearic acid coating did not show any decrease in crystallinity of the fillers. Scanning electron microscopy (SEM) displayed changes in the fractured surfaces, which infers the fillers altered the bio-epoxy polymer. The mechanical property results showed enhancements in the composite tensile modulus and flexural modulus compared to the pure bio-epoxy, as expected. In contrast, despite the improvement in the tensile and flexural strengths of the stearic acid-treated fillers, the composite strength values were not higher than those of the unfilled bio-epoxy matrix. The energy absorbed by all composites in Charpy impact tests fell below that of the pure bio-epoxy and decreased with an increase in filler content for both untreated and stearic acid-treated fillers tested at 23 and −40 °C. Statistical analysis of the results was conducted using Statistical Analysis Software (SAS) with ranking based on Tukey’s method. The study identified that the addition of 5, 10, and 20 wt.% in a bio-epoxy matrix may be acceptable provided the end product requires lower tensile and flexural load requirements than those of the pure bio-epoxy. However, filler loadings below 5 wt.% would be a better choice.