Vapor deposition has been used to create glassy materials with extraordinary thermodynamic and kinetic stability and high density. For glasses prepared from indomethacin or 1,3-bis-(1-naphthyl)-5-(2-naphthyl)benzene, stability is optimized when deposition occurs on substrates at a temperature of 50 K below the conventional glass transition temperature. We attribute the substantial improvement in thermodynamic and kinetic properties to enhanced mobility within a few nanometers of the glass surface during deposition. This technique provides an efficient means of producing glassy materials that are low on the energy landscape and could affect technologies such as amorphous pharmaceuticals.

An optical photobleaching technique has been used to measure the reorientation of dilute probes in freestanding polystyrene films as thin as 14 nm. Temperature-ramping and isothermal anisotropy measurements reveal the existence of two subsets of probe molecules with different dynamics. While the slow subset shows bulk-like dynamics, the more mobile subset reorients within a few hundred seconds even at T(g,DSC) - 25 K (T(g,DSC) is the glass transition temperature of bulk polystyrene). At T(g,DSC) - 5 K, the mobility of these two subsets differs by 4 orders of magnitude. These data are interpreted as indicating the presence of a high-mobility layer at the film surface whose thickness is independent of polymer molecular weight and total film thickness. The thickness of the mobile surface layer increases with temperature and equals 7 nm at T(g,DSC).

When sufficient force is applied to a glassy polymer, it begins to deform through movement of the polymer chains. We used an optical photobleaching technique to quantitatively measure changes in molecular mobility during the active deformation of a polymer glass [poly(methyl methacrylate)]. Segmental mobility increases by up to a factor of 1000 during uniaxial tensile creep. Although the Eyring model can describe the increase in mobility at low stress, it fails to describe mobility after flow onset. In this regime, mobility is strongly accelerated and the distribution of relaxation times narrows substantially, indicating a more homogeneous ensemble of local environments. At even larger stresses, in the strain-hardening regime, mobility decreases with increasing stress. Consistent with the view that stress-induced mobility allows plastic flow in polymer glasses, we observed a strong correlation between strain rate and segmental mobility during creep.