Herein, we report nanosecond, single-pulse laser post-processing (PLPP) in a liquid flat jet with precise control of the applied laser intensity to tune structure, defect sites, and the oxygen evolution reaction (OER) activity of mesostructured Co 3 O 4 . High-resolution X-ray diffraction (XRD), Raman, and Xray photoelectron spectroscopy (XPS) are consistent with the formation of cobalt vacancies at tetrahedral sites and an increase in the lattice parameter of Co 3 O 4 after the laser treatment. X-ray absorption spectroscopy (XAS) and X-ray emission spectroscopy (XES) further reveal increased disorder in the structure and a slight decrease in the average oxidation state of the cobalt oxide. Molecular dynamics simulation confirms the surface restructuring upon laser post-treatment on Co 3 O 4 . Importantly, the defectinduced PLPP was shown to lower the charge transfer resistance and boost the oxygen evolution activity of Co 3 O 4 . For the optimized sample, a 2-fold increment of current density at 1.7 V vs RHE is obtained and the overpotential at 10 mA/cm 2 decreases remarkably from 405 to 357 mV compared to pristine Co 3 O 4 . Post-mortem characterization reveals that the material retains its activity, morphology, and phase structure after a prolonged stability test.

A comprehensive search for stable structures in the low coverage regime (0-1 ML) and at 2 ML and 3 ML using DFT revealed several new aggregation states of water on the non-polar ZnO(101[combining macron]0) surface. Ladder-like structures consisting of half-dissociated dimers, arranged side-by-side along the polar axis, constitute the most stable aggregate at low coverages (≤1 ML) with a binding energy exceeding that of the monolayer. At coverages beyond the monolayer - a regime that has hardly been studied previously - a novel type of structure with a continuous honeycomb-like 2D network of hydrogen bonds was discovered, where each surface oxygen atom is coordinated by additional H-bonding water molecules. This flat double-monolayer has a relatively high adsorption energy, every zinc and oxygen atom is 4-fold coordinated and every hydrogen atom is engaged in a hydrogen bond. Hence this honeycomb double monolayer offers no H-bond donor or acceptor sites for further growth of the water film. At 3 ML coverage, the interface restructures forming a contact layer of half-dissociated water dimers and a liquid-like overlayer of water attached by hydrogen bonds. The structures and their adsorption energies are analysed to understand the driving forces for aggregation and dissociation of water on the surface. We apply a decomposition scheme based on a Born-Haber cycle, discussing difficulties that may occur in applying such an analysis to the adsorption of dissociated molecules and point out alternatives to circumvent the bias against severely stretched bonds. Water aggregation on the ZnO surface is favoured by direct water-water interactions including H-bonds and dipole-dipole interactions and surface- or adsorption-mediated interactions including enhanced water-surface interactions and reduced relaxations of the water molecules and surface. While dissociation of isolated adsorbed molecules is unfavourable, partial or even full dissociation is preferred for aggregates. Nevertheless, direct water-water interactions change very little in the dissociation reaction. Dissociation is governed by a subtle balance between strongly enhanced water-surface interactions and the large energies required for the geometric changes of the water molecule(s) and the surface. Our conclusions are discussed on the background of the current knowledge on water adsorption at metals and non-metallic surfaces.

Due to the variability of the cation occupancy of octahedral and tetrahedral sites, spinel ferrites and cobaltites are particularly interesting to investigate activity trends in oxidation catalysis. Yet, the preparation of the respective catalyst series remains challenging. We employed pulsed laser defect engineering of CoFe2O4 nanoparticles in water to gradually alter the cation occupancy of octahedral and tetrahedral sites by single laser pulses and study its effect on cinnamyl alcohol oxidation. Three CoFe2O4 catalysts from different synthesis methods resembling different initial site occupancy were chosen as starting materials. The laser‐induced randomization of the cation occupancy was verified by Mössbauer spectroscopy and linearly correlated with the conversion of cinnamyl alcohol while the size and Co : Fe ratio was maintained during laser processing. The study solidifies the importance of octahedral Co3+‐sites and the feasibility of pulsed laser processing for altering the cation occupancy and related crystallographic defect density in oxidation catalysis.

The spinel Co3O4 has many beneficial properties for potential use in catalysis. In operando, water is always present and alters the properties of the catalyst. We have used ab initio molecular dynamics to understand the effect of water and solvation on the structure and reactivity of the Co3O4 (001) A-type and B-type surface terminations. Water adsorbs on both terminations via a partial dissociative mode, and the A-termination is seen to be more reactive. On this surface, a higher degree of dissociation is observed in the topmost layers of the crystal in contact with water. Water dissociates more frequently on the Co2+ sites (about 75%) than on the adjacent Co3+ sites, where the degree of dissociation is about 50%. Increasing water coverage does not change the degree of water dissociation significantly. OH− adsorption on the Co2+ sites leads to a reduction of the amount of reconstruction and relaxation of the surface relative to the clean surface at room temperature. Proton transfer within the water films and between water molecules and surface has localized character. The B-terminated interface is less dynamic, and water forms epitactic layers on top of the Co3+ sites, with a dissociation degree of about 25% in the contact layer.

We combine theoretical and experimental X-ray absorption near-edge spectroscopy (XANES) to probe the local environment around cationic sites of bulk spinel cobalt tetraoxide (Co3O4). Specifically, we analyse the oxygen K-edge spectrum. We find an excellent agreement between our calculated spectra based on the density functional theory and the projector augmented wave method, previous calculations as well as with the experiment. The oxygen K-edge spectrum shows a strong pre-edge peak which can be ascribed to dipole transitions from O 1s to O 2p states hybridized with the unoccupied 3d states of cobalt atoms. Also, since Co3O4 contains two types of Co atoms, i.e., Co3+ and Co2+, we find that contribution of Co2+ ions to the pre-edge peak is solely due to single spin-polarized t2g orbitals (dxz, dyz, and dxy) while that of Co3+ ions is due to spin-up and spin-down polarized eg orbitals (dx2−y2 and dz2). Furthermore, we deduce the magnetic moments on the Co3+ and Co2+ to be zero and 3.00 μB respectively. This is consistent with an earlier experimental study which found that the magnetic structure of Co3O4 consists of antiferromagnetically ordered Co2+ spins, each of which is surrounded by four nearest neighbours of oppositely directed spins.

Co3O4, MgCo2O4 and MgO materials have been synthesized using a simple co-precipitation approach and systematically characterized. The total conversion of toluene to CO2 and H2O over spinel MgCo2O4 with wormlike morphology has been investigated. Compared with single metal oxides (Co3O4 and MgO), MgCo2O4 with the highest activity has exhibited almost 100% oxidation of toluene at 255 °C. The obtained results are analogous to typical precious metal supported catalysts. The activation energy of toluene over MgCo2O4 (38.5 kJ/mol) is found to be much lower than that of Co3O4 (68.9 kJ/mol) and MgO ((87.8 kJ/mol)). Compared with the single Co and Mg metal oxide, the as-prepared spinel MgCo2O4 exhibits a larger surface area, highest absorbed oxygen and more oxygen vacancies, thus highest mobility of oxygen species due to its good redox capability. Furthermore, the samples specific surface area, low-temperature reducibility and surface adsorbed oxygenated species ratio decreased as follows: MgCo2O4 > Co3O4 > MgO; which is completely in line with the catalytic performance trends and constitute the reasons for MgCo2O4 high excellent activity towards toluene total oxidation. The overall finding supported by ab initio molecular dynamics simulations of toluene oxidation on the Co3O4 and MgCo2O4 suggest that the catalytic process follows a Mars–van Krevelen mechanism.

We use ab initio molecular dynamics simulations to study the adsorption of thin water films with 1 and 2 ML coverage on anatase TiO (001) nanotubes. The nanotubes are modeled as 2D slabs, which consist of partially constrained and partially relaxed structural motifs from nanotubes. The effect of anion doping on the adsorption is investigated by substituting O atoms with N and S impurities on the nanotube slab surface. Due to strain-induced curvature effects, water adsorbs molecularly on defect-free surfaces via weak bonds on Ti sites and H bonds to surface oxygens. While the introduction of an S atom weakens the interaction of the surface with water, which adsorbs molecularly, the presence of an N impurity renders the surface more reactive to water, with a proton transfer from the water film and the formation of an NH group at the N site. At 2 ML coverage, a further surface-assisted proton transfer takes place in the water film, resulting in the formation of an OH group and an NH cationic site on the surface.

One-dimensional tungsten disulfide (WS 2 ) single-walled nanotubes (NTs) with either achiral, i.e., armchair ( n , n ) and zigzag-type ( n , 0), or chiral (2 n , n ) configuration with diameters d NT > 1.9 nm have been found to be suitable for photocatalytic applications, since their band gaps correspond to the frequency range of visible light between red and violet (1.5 eV < Δε gap < 2.6 eV). We have simulated the electronic structure of nanotubes with diameters up to 12.0 nm. The calculated top of the valence band and the bottom of the conduction band (ε VB and ε CB , respectively) have been properly aligned relatively to the oxidation (ε O 2 /H 2 O ) and reduction (ε H 2 /H 2 O ) potentials of water. Very narrow nanotubes (0.5 < d NT < 1.9 nm) are unsuitable for water splitting because the condition ε VB < ε O 2 /H 2 O < ε H 2 /H 2 O < ε CB does not hold. For nanotubes with d NT > 1.9 nm, the condition ε VB < ε O 2 /H 2 O < ε H 2 /H 2 O < ε CB is fulfilled. The values of ε VB and ε CB have been found to depend only on the diameter and not on the chirality index of the nanotube. The reported structural and electronic properties have been obtained from either hybrid density functional theory and Hartree–Fock linear combination of atomic orbitals calculations (using the HSE06 functional) or the linear augmented cylindrical waves density functional theory method. In addition to single-walled NTs, we have investigated a number of achiral double-walled ( m , m )@( n , n ) and ( m , 0)@( n , 0) as well as triple-walled ( l , l )@( m , m )@( n , n ) and ( l , 0)@( m , 0)@( n , 0) nanotubes. All multiwalled nanotubes show a common dependence of their band gap on the diameter of the inner nanotube, independent of chirality index and number of walls. This behavior of WS ...