No abstract

This chapter aims to summarize the topics related to the application of a surface treatment by high energy fluxes (i.e., electron and laser beams) for developing of new multifunctional materials, as well as to modify their surface properties. These technologies have a large number of applications in the field of automotive and aircraft industries for manufacturing of railways, space crafts, different tools, and components. Based on the performed literature review, some examples of the use of laser and electron beams for surface manufacturing (i.e., surface alloying, cladding, and hardening) are presented. The present overview describes the relationship between electron beam and laser beam technologies, microstructure, and the obtained functional properties of the materials. The benefits of the considered techniques are extensively discussed.

This study examines the effect of electron beam treatment (EBT) of Co-Cr substrate on the film growth mechanism, mechanical properties, and surface topography of TiN/TiO 2 coatings deposited by reactive magnetron sputtering. The obtained results and processes that occurred during the deposition are discussed in the context of crystallographic principles, and special attention is paid to the crystallographic orientation and growth mechanism studied by X-ray diffraction (XRD). The mechanical properties were investigated by means of nanoindentation and wear tests. The surface topography was evaluated using atomic force microscopy (AFM). The results obtained in the present study showed that polycrystalline TiN and anatase TiO 2 phases were present in all cases. Electron beam treatment of Co-Cr substrate tended to form a reorientation of the microvolumes from (111) to (200) of TiN, leading to a change in the growth mechanism from three-dimensional (Volmer-Weber) to layer-by-layer (Frank-van der Merwe). It was found that the electron beam treatment process did not significantly affect the thickness of the coatings and the deposition rate. The treatment process led to an increase in surface roughness. The higher surface roughness after the EBT process should be appropriate to support cell growth and adhesion on the surface of the deposited bilayer coating. It was demonstrated that EBT of the substrate caused a decrease in hardness of the deposited coatings from 10 to 5 GPa. The observed decrease in hardness was attributed to the change in the preferred crystallographic orientation and film growth mechanism. The hardness of the bilayer coating after the application of EBT of the Co-Cr substrate was much closer to that of human bones, which means that severe stress shielding effect could not be expected. The evaluated coefficient of friction (COF) exhibited significantly lower values in the case of EBT of the substrate compared to the untreated Co-Cr material.resistance, which depends mostly on the surface properties and can be overcome by appropriate surface modification technologies [4].During the last decades, considerable attention has been paid to surface manufacturing of materials by high-energy fluxes (HEFs) (i.e., electron and laser beams). In these technologies, the electrons or photon fluxes interact with the surface of the sample, heat the treated area, and form a thermal distribution. The rate of heating and cooling can be characterized by quite high values (about 10 5 -10 6 K/s), which lead to some structural changes in the functional properties [5][6][7][8][9][10]. The authors of [11] demonstrated an innovative approach for controlling the surface topography and tribological behavior of biomedical alloys, such as Ti6Al4V, by means of electron beam surface treatment. Other researchers [12,13] have successfully demonstrated the possibilities for enhancing the wear and corrosion properties of steel by the formation of carbon fiber-reinforced Ni-based composite coatings via laser cladding. Laser beam technologie...