The application of soft photoionization mass spectrometry methods (PIMS) for cigarette mainstream smoke analysis is demonstrated. Resonance-enhanced multiphoton ionization (REMPI) at 260 nm and vacuum ultraviolet light single-photon ionization (SPI) at 118 nm were used in combination with time-of-flight mass spectrometry (TOFMS). An optimized smoking machine with reduced memory effects of smoke components was constructed, which in combination with the REMPI/SPI-TOFMS instrument allows PIMS smoke analysis with a time resolution of up to 10 Hz. The complementary character of both PIMS methods is demonstrated. SPI allows the detection of various aliphatic and aromatic compounds in smoke up to approximately 120 m/z while REMPI is well suited for aromatic compounds. The capability of the instrument coupled to the novel sampling system for puff-by-puff resolved measurements is demonstrated. The feasibility of using the experimental system for intrapuff smoke measurements is also shown. Two main patterns of puff-by-puff behaviors are observed for different smoke constituents. The first group exhibits a constant increase in smoke constituent yield from the first to the last puff. The second group shows a high yield of the constituent in the first puff, with lower and constant or slowly increasing yields in the following puffs. A third group cannot be clearly classified and is a combination of both observed profiles.

Soft single photon ionization (SPI)-time-of-flight mass spectrometry (TOFMS) has been applied for the quantitative puff-by-puff-resolved characterization of selected toxic species in cigarette mainstream smoke, namely, nitric oxide (NO), acetaldehyde, butadiene, acetone, isoprene, benzene, toluene, ethyl benzene, and xylene. The 2R4F research cigarette was investigated for whole smoke (unfiltered) and gas phase (filtered). It has been demonstrated that the existing smoking regime for total smoke analysis (smoke from a complete cigarette) features deficiencies when applied to puff-resolved measurements. This is especially the case for analysis in which a glass fiber filter is used to separate the smoke particulate and gas phases because material is desorbed from the filter and influences succeeding puffs. Regarding whole smoke measurements, succeeding puffs are affected by contamination and memory effects of the smoking machine itself, but to a lower extent. Quantitative puff-resolved smoke profiles show that the puff yields of the various constituents can differ tremendously. Most species' concentrations increase gradually with puff number, which is mainly due to the reduction in length of the cigarette. However, high yields in the first puff are observed for butadiene and isoprene, suggesting different formation mechanisms for these compounds. First results are presented in which these high yields in the first puff are mainly associated with the gaseous fraction of the smoke.