Developments of the hot stamping technology have enabled the production of components with differential microstructure composition and mechanical properties. These can increase the performance of certain crash-relevant automotive structures by combining high intrusion protection and energy absorption. This paper presents a comprehensive experimental investigation on the flow and ductile fracture properties of boron-alloyed steel with a wide range of different microstructure compositions. Three types of dual phase microstructures at three different volume fractions, and one triple phase grade, were generated by thermal treatment. Flow curves extending beyond necking and the equivalent plastic strain to fracture for each grade was determined by tensile testing using fullfield measurements. The influence of phase composition and microstructural parameters were further investigated by means of a multi-scale modeling approach based on mean-field homogenization in combination with local fracture criteria. Inter-phase and intra-phase fracture mechanisms were considered by adopting two separate fracture criteria formulated in terms of the local average stress field. The micromechanical model captures with useful accuracy the strong influence of microstructure and processing conditions on the flow and fracture properties, implying promising prospects of mean-field homogenization for the constitutive modeling of hot stamped components.
In most applied monitoring investigations using acoustic emission, measurements are carried out relatively, even though that limits the use of the extracted information. The authors believe acoustic emission monitoring can be improved by instead using absolute measurements. However, knowledge about absolute measurement in boundary restricted systems is limited. This article evaluates a method for absolute calibration of acoustic emission transducers and evaluates its performance in a boundary restricted system. Absolute measured signals of Hertzian contact excited elastic waves in boundary restricted systems were studied with respect to contact time and excitation energy. Good agreement is shown between measured and calculated signals. For contact times short enough to avoid interaction between elastic waves and initiating forces, the signals contain both resonances and zero frequencies, whereas for longer contact times the signals exclusively contained resonances. For both cases, aGreen's function model and measured signals showed good agreement.
The demand of ultra high strength steel (UHSS) components increased in the last decade due to their high strength to weight ratio. The driving force in this development is the automotive industry and regulations concerning passenger safety and fuel consumption. The use of ultra high strength steel enables design of lighter car bodies with equal or better passenger safety compared to earlier car generations. The automotive industry and their suppliers need predictive tools in the development of components with tailored material properties. Components with tailored material properties are produced by hot stamping, in this process a blank is austenitized before it is formed and quenched in one step. By use of sequential heated or cooled tools, different mechanical properties distributed within the same component are achieved.In order to develop a constitutive model for components consisting of regions with varying phase content, a suitable method to describe the elasto-plastic part of the yield curve is needed. The focus of this work is on the description of the elasto-plastic constitutive model of an ultra high strength steel depending on the phase content in the material. Different volume fractions of ferrite, bainite and martensite are experimentally formed. In this study the capability of different homogenization methods on the prediction of the material response of a multiphase steel depending on the volume fraction of formed phases is investigated. The modeling results are compared to experimental results.The prediction of the composite response using the micromechanical based double-inclusion model and pure phase measured data as well as experimentally obtained phase volume fractions of present phases showed good agreement throughout all samples tested in this study.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.