Авторское право 2008 г., Общество инженеров-нефтяников Этот доклад был приготавливан предьявления в 2008 Российской нефтьегазовой технической конференции и выставке состоится в Москве 28-30 октабря 2008.Данный доклад был выбран для проведения презентации Программным комитетом SPE по результатам экспертизы информации, содержащейся в представленном авторами резюме. Экспертиза содержания доклада Обществом инженеров-нефтяников не выполнялась, и доклад подлежит внесению исправлений и корректировок авторами. Материал в том виде, в котором он представлен, не обязательно отражает точку зрения Общества инженеров-нефтяников, его должностных лиц или участников. Доклады, представленные на конференциях SPE, подлежат экспертизе со стороны Редакционных Комитетов Общества инженеров-нефтяников. Электронное копирование, распространение или хранение любой части данного доклада в коммерческих целях без предварительного письменного согласия Общества инженеров-нефтяников запрещается. Разрешение на воспроизведение в печатном виде распространяется только на резюме длиной не более 300 слов; при этом копировать иллюстрации не разрешается. Резюме должно содержать явно выраженную ссылку на то, где и кем был представлен данный доклад. Write Librarian, SPE, P.O.Box 833836, Richardson, TX 75083-3836 U.S.A., факс 01-972-952-9435. Аннотация. В работе представлены первые результаты применения пароциклических обработок скважин с радиальными отводами в глубокозалегающих карбонатных пластах с высоковязкой нефтью пермо-карбоновой залежи Усинского месторождения. В конце 2006 г. было пробурено 32 радиальных отводов длиной до 100 м каждый в 8 вертикальных добывающих скважинах, 5 из которых затем были подвергнуты пароциклическим обработкам. Бурение радиальных отводов в скважинах с пониженной продуктивностью без пароциклических обработок вскрытых пластов оказалось неэффективным, так как не привело к существенному увеличению продуктивности скважин. Интегрирование проводки радиальных отводов и пароциклических обработок скважин наоборот оказалось высокоэффективным благодаря снижению вязкости нефти. Средний прирост дебита нефти в таких скважинах составил около 15,0 т/сут. Введение. Проблема вовлечения в активную разработку запасов высоковязких нефтей и битумов, по мере опережающей выработки запасов легких нефтей, становится одной из наиболее актуальных для нефтяной промышленности XXI века. Высоковязкие нефти и битумы относятся к нетрадиционным источникам углеводородов, мировые ресурсы которых уже превышают ресурсы легкой нефти и газа и эквивалентны 600 -800 млрд. т нефти. Ожидается, что к 2025 г. нетрадиционные источники углеводородов будут обеспечивать более 20 % мировой добычи нефти [1].Российские запасы высоковязких нефтей и битумов по разным оценкам составляют от 30 до 75 млрд. т.Наибольший отечественный опыт освоения запасов высоковязких нефтей накоплен в Республике Коми. Здесь в промышленной разработке десятки лет находятся два крупных месторождения -Ярегское и пермо-карбоновая залежь Усинского месторождения с суммарными геологическими запасами высоковя...
Thermal-steam stimulation (TSS) is considered as the most effective among all up-to-date methods for heavy oil production. However problem consists in lower coverage by steam injection and decreased TSS efficiency at later stage of the development. Paper presents the results of solving this problem by combining thermal-steam and physicochemical stimulations and using "cold" technologies involving thermotropic gel-forming and oil-displacing systems: gels increase reservoir coverage, whereas oil-displacing systems increase oil displacement. In 2008-2013 172 wells were treated on the Permian-Carboniferous reservoir of high-viscosity oil in Usinsk oilfield using IPC SB RAS technologies. As a result the increase in oil production rate ranged of 3-24 ton/d per one well and incremental oil production amounted to 980 tons per one well treatment. It is promising to use integrated technologies alternating injection of steam, gel-forming and oil-displacing systems. They are commercially produced in Russia and China. In 2014 to improve TSS efficiency pilot tests of new technologies were successfully carried out: using gelled system based on surfactants with controlled viscosity to increase simultaneously reservoir coverage and oil-displacement factor; using polymer gel-forming system – for selective water shutoff in production wells. TSS is effective, but expensive method. It is promising to use "cold" technologies. To enhance oil recovery from high-viscosity reservoirs at 20-40 °С we propose to use gels and sols based on low temperature inorganic gel-forming system and oil-displacing alkaline and acid systems based on surfactants, inorganic buffer solution and polyol with controlled viscosity, from tens to hundreds mPa·s, and low freezing point, -20÷-60 °С. In 2014 pilot tests of new "cold" technologies were carried out in Usinsk oilfield. Alkaline system was injected into 5 and acid system into 10 low productivity production wells. After injections oil production rate increased by 5-15 ton/d, fluid flow rate increased by 15-25 m3/d. The technologies were recommended for commercial application.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
customersupport@researchsolutions.com
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.