Estimates of body mass often represent the founding assumption on which biomechanical and macroevolutionary hypotheses are based. Recently, a scaling equation was applied to a newly discovered titanosaurian sauropod dinosaur (Dreadnoughtus), yielding a 59 300 kg body mass estimate for this animal. Herein, we use a modelling approach to examine the plausibility of this mass estimate for Dreadnoughtus. We find that 59 300 kg for Dreadnoughtus is highly implausible and demonstrate that masses above 40 000 kg require high body densities and expansions of soft tissue volume outside the skeleton several times greater than found in living quadrupedal mammals. Similar results from a small sample of other archosaurs suggests that lower-end mass estimates derived from scaling equations are most plausible for Dreadnoughtus, based on existing volumetric and density data from extant animals. Although volumetric models appear to more tightly constrain dinosaur body mass, there remains a clear need to further support these models with more exhaustive data from living animals. The relative and absolute discrepancies in mass predictions between volumetric models and scaling equations also indicate a need to systematically compare predictions across a wide size and taxonomic range to better inform studies of dinosaur body size.

Tissue material properties are crucial to understanding their mechanical function, both in healthy and diseased states. However, in certain circumstances logistical limitations can prevent testing on fresh samples necessitating one or more freeze-thaw cycles. To date, the nature and extent to which the material properties of articular cartilage are altered by repetitive freezing have not been explored. Therefore, the aim of this study is to quantify how articular cartilage mechanical properties, measured by nanoindentation, are affected by multiple freeze-thaw cycles. Canine cartilage plugs (n = 11) from medial and lateral femoral condyles were submerged in phosphate buffered saline, stored at 3–5 °C and tested using nanoindentation within 12 h. Samples were then frozen at −20 °C and later thawed at 3–5 °C for 3 h before material properties were re-tested and samples re-frozen under the same conditions. This process was repeated for all 11 samples over three freeze-thaw cycles. Overall mean and standard deviation of shear storage modulus decreased from 1.76 ± 0.78 to 1.21 ± 0.77 MPa (p = 0.91), shear loss modulus from 0.42 ± 0.19 to 0.39 ± 0.17 MPa (p=0.70) and elastic modulus from 5.13 ± 2.28 to 3.52 ± 2.24 MPa (p = 0.20) between fresh and three freeze-thaw cycles respectively. The loss factor increased from 0.31 ± 0.38 to 0.71 ± 1.40 (p = 0.18) between fresh and three freeze-thaw cycles. Inter-sample variability spanned as much as 10.47 MPa across freezing cycles and this high-level of biological variability across samples likely explains why overall mean “whole-joint” trends do not reach statistical significance across the storage conditions tested. As a result multiple freeze-thaw cycles cannot be explicitly or statistically linked to mechanical changes within the cartilage. However, the changes in material properties observed herein may be sufficient in magnitude to impact on a variety of clinical and scientific studies of cartilage, and should be considered when planning experimental protocols.

Centre of mass is a fundamental anatomical and biomechanical parameter. Knowledge of centre of mass is essential to inform studies investigating locomotion and other behaviours, through its implications for segment movements, and on whole body factors such as posture. Previous studies have estimated centre of mass position for a range of organisms, using various methodologies. However, few studies assess the accuracy of the methods that they employ, and often provide only brief details on their methodologies. As such, no rigorous, detailed comparisons of accuracy and repeatability within and between methods currently exist. This paper therefore seeks to apply three methods common in the literature (suspension, scales and digital modelling) to three ‘calibration objects’ in the form of bricks, as well as three birds to determine centre of mass position. Application to bricks enables conclusions to be drawn on the absolute accuracy of each method, in addition to comparing these results to assess the relative value of these methodologies. Application to birds provided insights into the logistical challenges of applying these methods to biological specimens. For bricks, we found that, provided appropriate repeats were conducted, the scales method yielded the most accurate predictions of centre of mass (within 1.49 mm), closely followed by digital modelling (within 2.39 mm), with results from suspension being the most distant (within 38.5 mm). Scales and digital methods both also displayed low variability between centre of mass estimates, suggesting they can accurately and consistently predict centre of mass position. Our suspension method resulted not only in high margins of error, but also substantial variability, highlighting problems with this method.

Three‐dimensional musculoskeletal models have become increasingly common for investigating muscle moment arms in studies of vertebrate locomotion. In this study we present the first musculoskeletal model of a western lowland gorilla hind limb. Moment arms of individual muscles around the hip, knee and ankle were compared with previously published data derived from the experimental tendon travel method. Considerable differences were found which we attribute to the different methodologies in this specific case. In this instance, we argue that our 3D model provides more accurate and reliable moment arm data than previously published data on the gorilla because our model incorporates more detailed consideration of the 3D geometry of muscles and the geometric constraints that exist on their lines‐of‐action about limb joints. Our new data have led us to revaluate the previous conclusion that muscle moment arms in the gorilla hind limb are optimised for locomotion with crouched or flexed limb postures. Furthermore, we found that bipedalism and terrestrial quadrupedalism coincided more regularly with higher moment arms and torque around the hip, knee and ankle than did vertical climbing. This indicates that the ability of a gorilla to walk bipedally is not restricted by musculoskeletal adaptations for quadrupedalism and vertical climbing, at least in terms of moment arms and torque about hind limb joints.

It is accepted that non-avian theropod dinosaurs, with their long muscular tails and small forelimbs, had a centre-of-mass close to the hip, while extant birds, with their reduced tails and enlarged wings have their mass centred more cranially. Transition between these states is considered crucial to two key innovations in the avian locomotor system: crouched bipedalism and powered flight. Here we use image-based models to challenge this dichotomy. Rather than a phylogenetic distinction between ‘dinosaurian’ and ‘avian’ conditions, we find terrestrial versus volant taxa occupy distinct regions of centre-of-mass morphospace consistent with the disparate demands of terrestrial bipedalism and flight. We track this decoupled evolution of body shape and mass distribution through bird evolution, including the origin of centre-of-mass positions more advantageous for flight and major reversions coincident with terrestriality. We recover modularity in the evolution of limb proportions and centre-of-mass that suggests fully crouched bipedalism evolved after powered flight.

Due to difficulty of obtaining accurate quantitative data on foot muscles, relatively little has been done to study foot muscle function in non-human apes. Gorilla feet are known to be similar in bony proportions and mechanics to those of humans, hence are key to understanding human foot evolution and its ecological context. We present the first 3D musculoskeletal computer model of a western lowland gorilla foot, giving muscle torques about the tarsometatarsal, metatarsophalangeal and interphalangeal joints of digits 2-5. Peak flexor torque around the fifth metatarsophalangeal joint occurs at a highly flexed position, suggesting an ability to maintain flexed postures around lateral metatarsophalangeal joints, useful for grasping vertical supports. For distal interphalangeal joints, flexor torques peaked the more medial the digit at relatively flexed postures. We report, for the first time, interossei acting upon proximal and distal interphalangeal joints. All these facilitate maintenance of flexed positions around distal interphalangeal joints, likely used for grasping of small supports/objects. Humans lack these features, suggesting that semi-arboreal early hominins made less use of the peripheral canopy than gorillines. Information here could be used in gorilla enclosure design to encourage wild-type locomotor repertoires in captivity.

<p>In its recent Issues Paper, Alternative Pre-Trial and Trial Processes: Possible Reforms, the New Zealand Law Commission proposed to make available some form of restorative justice process as a complete alternative to the criminal justice system in certain sexual offence cases. It also proposed that where an offender participates in an alternative process in good faith and fulfils all undertakings, the case cannot be referred back to the criminal justice system. This paper considers situations where alternative trial processes should be referred back to the criminal justice system and what should happen to material disclosed during the alternative process if referral occurs.  If restorative processes are to be used as a complete alternative to the criminal justice system, there must a “public safety override” which prioritises public safety over victim autonomy. This override will be applied by restorative justice providers, who will have the ability to refer cases back to the criminal justice system. If referral does occur, the content of the restorative proceedings should be privileged, and that privilege should belong to the offender. The fact of the offender’s agreement to participate should also be privileged.</p>

<p>In its recent Issues Paper, Alternative Pre-Trial and Trial Processes: Possible Reforms, the New Zealand Law Commission proposed to make available some form of restorative justice process as a complete alternative to the criminal justice system in certain sexual offence cases. It also proposed that where an offender participates in an alternative process in good faith and fulfils all undertakings, the case cannot be referred back to the criminal justice system. This paper considers situations where alternative trial processes should be referred back to the criminal justice system and what should happen to material disclosed during the alternative process if referral occurs.  If restorative processes are to be used as a complete alternative to the criminal justice system, there must a “public safety override” which prioritises public safety over victim autonomy. This override will be applied by restorative justice providers, who will have the ability to refer cases back to the criminal justice system. If referral does occur, the content of the restorative proceedings should be privileged, and that privilege should belong to the offender. The fact of the offender’s agreement to participate should also be privileged.</p>