High PAPR is the main drawback of OFDM systems. DSI method and SLM method are two of the most promising techniques to reduce PAPR.
One of the effective methods used for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems is selected mapping (SLM). In this paper, a new SLM scheme called DSI-SLM, which is a combination of dummy sequence insertion (DSI) and conventional selected mapping (C-SLM) is proposed. Previous techniques have had some drawbacks. In DSI, increasing the number of dummy sequences to have better PAPR degrades transmission efficiency, and in C-SLM, the complexity rises dramatically when the number of sub-blocks increases. The proposed DSI-SLM scheme significantly reduces the complexity because of the reduction in the number of sub-blocks compared with the C-SLM technique while its PAPR performance is even better. To enhance the efficiency of the OFDM system and suppress the out-of-band distortion from the power amplifier nonlinearity, a digital predistortion technique is applied to the DSI-SLM scheme. Simulations are carried out with the actual power amplifier model and the OFDM signal based on the worldwide interoperability for microwave access standard and quadrature phaseshift keying modulation. The simulation results show improvement in PAPR reduction and complexity, whereas the BER performance is slightly worse.
Power Amplifiers (PAs) are important parts of the transmitters. They amplify the signals that are going to be transmitted. With increasing the input power of the PA, it creates the nonlinearity at the output. The nonlinearity causes out of band distortion and in band distortion. To overcome these effects the power amplifier should be backed off but it will reduce the efficiency of the PA. To increase the efficiency, the Complex Gain Memory Predistortion (CGP) is added to the system. Experimental results with the Mini Circuit power amplifier show an improvement of 7% in Power Added Efficiency (PAE) when the CGP method is applied.
Orthogonal frequency division multiplexing (OFDM) has become an indispensable part of waveform generation in wideband digital communication since its first appearance in digital audio broadcasting (DAB) in Europe in 1980s, and it is indeed in use. As has been seen, the OFDM based waveforms work well with time division duplex operation in new radio (NR) systems in 5G systems, supporting delay-sensitive applications, high spectral efficiency, massive multiple input multiple output (MIMO) compatibility, and ever-larger bandwidth signals, which has demonstrated successful commercial implementation for 5G downlinks and uplinks up to 256-QAM modulation schemes. However, the OFDM waveforms suffer from high peak to average power ratio (PAPR), which is not desired by system designers as they want RF power amplifiers (PAs) to operate with high efficiency. Although NR offers some options for maintaining the efficiency and spectral demand, such as cyclic prefix based (CP-OFDM), and discrete Fourier transform spread based (DFT-S-OFDM) schemes, which have limiting effects on PAPR, the PAPR is still as high as 13 dB. This value increases when the bandwidth is increased. Moreover, in LTE-Advance and 5G systems, in order to increase the bandwidth, and data-rate, carrier aggregation technology is used which increases the PAPR the same way that bandwidth increment does; therefore, it is essential to employ PAPR reduction in signal processing stage before passing the signal to PA. In this paper, we investigate the performance of an innovative peak shrinking and interpolation (PSI) technique for reducing peak to average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) based signals at waveform generation stage. The main idea behind the PSI technique is to extract high peaks, scale them down, and interpolate them back into the signal. It is shown that PSI technique is a possible candidate for reducing PAPR without compromising on computational complexity, compatible for existing and future telecommunication systems such as 4G, 5G, and beyond. In this paper, the PSI technique is tested with variety of signals in terms of inverse fast Fourier transform (IFFT) length, type of the signal modulation, and applications. Additional work has been carried out to compare the proposed technique with other promising PAPR reduction techniques. This paper further validates the PSI technique through experimental measurement with a power amplifier (PA) test bench and achieves an adjacent channel power ratio (ACPR) of less than -55 dBc. Results showed improvement in output power of PA versus given input power, and furthermore, the error vector magnitude (EVM) of less than 1% was achieved when comparing of the signal after and before modification by the PSI technique.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.