Colloidal processing of fine ceramic powders enables the production of complex shaped ceramics with unique micro and macro structures which are not possible to produce via conventional dry processing routes. Because of this enhanced structural control and shaping capabilities, colloidal processing has been exploited to produce ceramic components with ever increasing complexity and functionalities. In this review, we revisit some of the research efforts on this topic to highlight its relevance and growing importance for the advanced manufacturing of functional ceramics. Selected examples of colloidal systems with increasing level of complexity are discussed to showcase the wide range of structures that can be generated through wet processing approaches. The historical development and background knowledge pertaining to colloids and surface interactions is first briefly reviewed. The major colloidal shape forming and additive manufacturing processes that utilize colloidal pastes and inks are then reviewed, highlighting the control of suspension rheology needed in these techniques. Next, methodologies that combine suspended particles with a pore‐forming phase are discussed as a means to produce porous ceramic materials. Further control over the interactions between anisotropic particles and their alignment in suspensions can be gained via externally applied fields (such as magnetic) to produce texturally aligned green bodies. This leads to bioinspired ceramics that can programmably morph into complex shaped objects upon sintering. Hierarchical porous structures with high mechanical efficiency are also shown as an example of the multiscale designs that can be generated through advanced colloidal processing. As drying of ceramic bodies is an inevitable consequence of wet colloidal processing, the current understanding of this critical processing step is reviewed. Finally, the gaps in knowledge in these fields are discussed to provide our perspective on where the field may support advances in ceramics in the future.

Aqueous and nonaqueous colloidal processing of zirconium diboride (ZrB 2 ) and boron carbide (B 4 C) has been investigated. The aqueous and nonaqueous ZrB 2 and B 4 C suspension formulations have been optimized. The suspensions were cast into green bodies using slip casting. The correlation between the state of dispersion with the rheological properties of the suspensions and the resulting packing density was observed in both aqueous and nonaqueous processing. The attractive interactions between powder particles in water were difficult to overcome with electrical double layer or electrosteric repulsion. Reasonably low viscosity aqueous ZrB 2 suspensions up to 45 vol% solids could be prepared. It was not possible to produce low viscosity (viscosity below 1 PaÁs at shear rate of 100 s -1 ) aqueous B 4 C suspensions with solid content above 30 vol%. Slip casting of the weakly aggregated ZrB 2 suspensions resulted in low packing densities (~55% relative density) of the green bodies. On the other hand, dispersion of powder particles in nonaqueous media (cyclohexane and dodecane) enabled suspensions with lower viscosities and a higher maximum solid concentration (up to 50 vol%) to be prepared. The well-dispersed nonaqueous suspensions promoted an efficient particle packing, resulting in higher green densities (64% and 62% relative density for ZrB 2 and B 4 C, respectively) compared to aqueous processing. The significantly high green densities are promising to allow densification of the materials at lower sintering temperature.

Shape‐forming techniques which may be useful in producing components for body armor are reviewed. The techniques are classified in three general categories, dry, wet, and plastic. The different shaping techniques are compared based on key parameters including shape limitations, rate of production, cost, and safety. The techniques are evaluated as to their suitability to be used to produce different body armor components such as breast plates, deltoid, shin and knee protection, and helmets. Dry‐pressing is the current standard for producing “relatively flat” components such as breast plates, but performance is limited by the inherent problem associated with dry‐pressing, namely, the difficulty in producing homogeneous green bodies because of agglomerates in the powder. Plastic processing has the potential to be useful to produce more reliable “flat” components with improved performance due to high shear mixing breaking up agglomerates. Wet (colloidal) processing techniques such as gelcasting and freeze casting may be useful to produce components with high curvature and more complex shape such as helmets. Tiles or segments may be combined to produce shaped components with increased flexibility.