The present study comprises steady state, two-dimensional computational investigations performed on NACA 0012 airfoil to analyze the effect of Gurney flap (GF) on airfoil aerodynamics using k-ε RNG turbulence model of FLUENT. Airfoil with GF is analyzed for six different heights from 0.5% to 4% of the chord length, seven positions from 0% to 20% of the chord length from the trailing edge, and seven mounting angles from 30° to 120° with the chord. Computed values of lift and drag coefficients with angle of attack are compared with experimental values and good agreement is found at low angles of attack. In addition static pressure distribution on the airfoil surface and pathlines and turbulence intensities near the trailing edge are present. From the computational investigation, it is recommended that Gurney flaps with a height of 1.5% chord be installed perpendicular to chord and as close to the trailing edge as possible to obtain maximum lift enhancement with minimum drag penalty.

Steady state, two-dimensional computational investigations performed on NACA 0012 airfoil to analyze the effect of variation in Reynolds number on the aerodynamics of the airfoil without and with a Gurney flap of height of 3% chord are presented in this paper. RANS based one-equation Spalart-Allmaras model is used for the computations. Both lift and drag coefficients increase with Gurney flap compared to those without Gurney flap at all Reynolds numbers at all angles of attack. The zero lift angle of attack seems to become more negative as Reynolds number increases due to effective increase of the airfoil camber. However the stall angle of attack decreased by 2° for the airfoil with Gurney flap. Lift coefficient decreases rapidly and drag coefficient increases rapidly when Reynolds number is decreased below critical range. This occurs due to change in flow pattern near Gurney flap at low Reynolds numbers.

In the present study, the design and analysis of smoke generator are done for the low-speed wind tunnel. The wind tunnel fan is fitted with the Variable Frequency Drive to produce the wind speed in the range of 3 to 32 m/s with fan speed of 150 to 1500 rpm. The design of smoke generator was done according to Preston Sweeting mist generator principle corresponding to the free stream velocity of 3 m/s. A controlled smoke generator consisting of kerosene reservoir, controlled heater, blower, liquid column height adjustment mechanism, valves etc. was designed and fabricated. The smoke generator produced the smoke at the rate of 154 cm3/s which was close to the design flow rate of 149 cm3/s. To supply the required quantity of smoke in the wind tunnel, the smoke rake of NACA 0010 profile was developed and installed in the rapid contraction section of the wind tunnel to achieve the streamlined flow. The parametric studies were done on the smoke generator at different power inputs and its effects were studied on smoke temperature, smoke discharge and boiling time of the kerosene. The flow visualization was carried out on NACA 0015 airfoil model and the images were captured to examine the flow physics around them under different operating conditions.

This paper presents a design of force balance setup that can measure lift force acting on the aircraft model. The setup was developed indigenously and installed in an open circuit low-speed wind tunnel. It mainly consists of two components viz. a traverse mechanism that can hold the model in the test section at different angles of attack and air speeds and a supporting frame to hold the traverse mechanism over it. The spring balances are used to obtain lift force readings at different angles and air speeds. The experimental and numerical investigations were done in the wide range of Reynolds number (range: 0.55 to 1.12 lakh) and angle of attack (range: -6° to 20°). The results are presented in terms of pressure contours, velocity contours, pressure coefficient and lift coefficient. From the experiments it was found that value of lift coefficient increases with angle of attack and stalling occurs at 18° for all the air speeds. However, in the numerical results the stalling was observed little earlier than 18° angle of attack. The experimental results were compared with CFD results and an average relative error of 18% was observed which may be due to assumption of 2-D airfoil in CFD analysis.