No abstract

No abstract

No abstract

No abstract

The aim of the present study was to elucidate the fundamental mechanism of bovine oviduct epithelial cell (BOEC) co-culture on developmental capacity of bovine in vitro oocyte maturation/in vitro fertilization (IVM/IVF) embryos. We examined the effects of astaxanthin against nitric oxide-induced oxidative stress on cell viability by MTT assay, lipid peroxidation (LPO) by using thiobarbituric acid (TBA) reaction for malondialdehyde (MDA) and the expression of antioxidant genes (CuZnSOD, MnSOD and Catalase) or apoptosis genes (Bcl-2, Caspase-3 and Bax) by RT-PCR in BOEC. We also evaluated the developmental rates of bovine IVM/IVF embryos co-cultured with BOEC pre-treated with astaxanthin (500 μM) in the presence or absence of sodium nitroprusside (SNP, 1000 μM) for 24 h. Cell viability in BOEC treated with SNP (50-2000 μM) lowered, while astaxanthin addition (50-500 μM) increased it in a dose-dependent manner. Cell viability in astaxanthin plus SNP (1000 μM) gradually recovered according to the increase in astaxanthin additions (100-500 mM). The LPO in astaxanthin group (50-500 μM) gradually decreased in a dose dependent manner and among SNP or astaxanthin plus SNP group, SNP alone and astaxanthin (50 μM) plus SNP shown a significant increase than other groups (p < 0.05). Expression of apoptosis or antioxidant genes was detected by RT-PCR. Bcl-2 and antioxidant genes were detected in astaxanthin or astaxanthin plus SNP group, and Caspase-3 and Bax genes were only found in SNP group. When bovine IVM/IVF embryos were cultured for 6-7 days under co-culture system such as BOEC treated with astaxanthin in the presence or absence of SNP, the developmental ability to blastocysts in 500 μM astaxanthin group was the highest of all groups. These results suggest that astaxanthin has a antioxidative effect on cell viability and LPO of BOEC, and development of bovine IVM/IVF embryos due to the induction of antioxidant genes and suppression of apoptosis genes.

A novel multiply synergetic Si@rGO/g-C3N4 as an ultra-long-life anode material for lithium-ion batteries was synthesized successfully via stable interface bonding.

No abstract

The aim of this paper is to compare the mechanical property and machinability of Polyetheretherketone (PEEK) and 30 wt% carbon-fibers reinforced Polyetheretherketone (PEEK CF 30). The method of nano-indentation is used to investigate the microscopic mechanical property. The evolution of load with displacement, Young’s modulus curves and hardness curves are analyzed. The results illustrate that the load-displacement curves of PEEK present better uniformity, and the variation of Young’s modulus and hardness of PEEK both change smaller at the experimental depth. The machinability between PEEK and PEEK CF 30 are also compared by the method of single-point diamond turning (SPDT), and the peak-to-valley value (PV) and surface roughness (Ra) are obtained to evaluate machinability of the materials after machining. The machining results show that PEEK has smaller PV and Ra, which means PEEK has superior machinability.