SUMMARYWe have studied the passive maintenance of high angle of attack and its lift generation during the crane fly's flapping translation using a dynamically scaled model. Since the wing and the surrounding fluid interact with each other, the dynamic similarity between the model flight and actual insect flight was measured using not only the non-dimensional numbers for the fluid (the Reynolds and Strouhal numbers) but also those for the fluid-structure interaction (the mass and Cauchy numbers). A difference was observed between the mass number of the model and that of the actual insect because of the limitation of available solid materials. However, the dynamic similarity during the flapping translation was not much affected by the mass number since the inertial force during the flapping translation is not dominant because of the small acceleration. In our model flight, a high angle of attack of the wing was maintained passively during the flapping translation and the wing generated sufficient lift force to support the insect weight. The mechanism of the maintenance is the equilibrium between the elastic reaction force resulting from the wing torsion and the fluid dynamic pressure. Our model wing rotated quickly at the stroke reversal in spite of the reduced inertial effect of the wing mass compared with that of the actual insect. This result could be explained by the added mass from the surrounding fluid. Our results suggest that the pitching motion can be passive in the crane fly's flapping flight.
The room-temperature continuous-wave operation of a 1.5λ-cavity GaN-based vertical-cavity surface-emitting laser with an n-type conducting AlInN/GaN distributed Bragg reflector (DBR) was achieved. A peak reflectivity of over 99.9% was obtained in the n-type conducting AlInN/GaN DBR so that the current was injected through the DBR for the operation. The threshold current was 2.6 mA, corresponding to the threshold current density of 5.2 kA/cm2, and the operating voltage was 4.7 V. A lasing spectrum with a peak wavelength of 405.1 nm and a full-width at half maximum of 0.08 nm was also observed.
The transient processes of rotating stall evolution have been investigated experimentally in a low-speed axial compressor stage with three stator-rotor gaps. The pressure traces at eight circumferential locations on the casing wall near the rotor leading edge have been analyzed by the wavelet transforms. With the appropriate mother wavelets, the evolution of short and long length-scale disturbances leading to the stall can be captured clearly. Behavior of these disturbances is different depending on the stator-rotor gap. For the large and middle gap, the stall inception is detected by a spiky short length-scale disturbance, and the number of spiky waves increases to generate the high frequency waves. They become the short length-scale part-span stall cells at the mild stall for the large gap, while they turn into a big stall cell with growth of a long length-scale disturbance for the middle gap. In the latter case, therefore, the stalling process was identified with “high-frequency stall inception.” For the small stator-rotor gap, the stalling process is identified with “long wavelength stall inception” and supported the recent computational model for the short wavelength stall inception by showing that closing the rotor-stator gaps suppressed the growth of short length-scale disturbances. From the measurement of the pressure field traces on the casing wall, a hypothesis has been developed that the short length-scale disturbance should result from a separation vortex from a blade surface to reduce circulation. The processes of the stall evolution are discussed on this hypothesis.
We demonstrated a room-temperature (RT) continuous-wave (CW) operation of a GaN-based vertical-cavity surface-emitting laser (VCSEL) using a thick GaInN quantum well (QW) active region and an AlInN/GaN distributed Bragg reflector. We first investigated the following two characteristics of a 6 nm GaInN 5 QWs active region in light-emitting diode (LED) structures. The light output power at a high current density (∼10 kA/cm2) from the 6 nm GaInN 5 QWs was the same or even higher than that from standard 3 nm 5 QWs. In addition, we found that hole injection into the farthest QW from a p-layer was sufficient. We then demonstrated a GaN-based VCSEL with the 6 nm 5 QWs, resulting in the optical confinement factor of 3.5%. The threshold current density under CW operation at RT was 7.5 kA/cm2 with a narrow (0.4 nm) emission spectrum of 413.5 nm peak wavelength.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.